View from Top
View from above
Attach wooden lift support to salmon
ladder side and secure with velcro strap
Make sure you are attaching
Lift Support to Salmon Ladder
Side of Monkey Bars
Lay out Monkey Bar Side Rails.
Insert Rungs into pre-drilled holes and fasten with
allen head bolts on each side.
9
10
11
12
Side Rails x 2 • Rungs x 13 • 3/16 Allen Head Bolts x 26
Warped Wall Side
Salmon Ladder Side
Side View
Rung Velcro
Strap
Salmon Ladder Leg
Salmon Ladder Leg
Salmon Ladder Header
View from Front
Side View
Carriage Bolts
x 2
Carriage Bolts
x 2
Header
Attach legs of salmon ladder to header using
four pre-installed carriage bolts with at washer,
lock washer and nut on each.
Flat Washer
Lock Washer
Nut
(on each bolt)
2” Deck Screws
Fasten Rock Wall panels to back of warped
wall using 2” Deck Screws into pre-drilled holes.
Be sure the panel with pre-installed mounting
block is installed with the block closest to the
top, and that top edge of panel is ush.
Monkey Bars
wooden lift support
Mounting
Block
13 Lift Warped Wall end of Monkey Bars so that
mounting brackets t into pre-installed wooden
mounting block. Adjust horizontally to line up
bolt holes on brackets and warped wall.
14 Lift other end of Monkey Bars using wooden lift
support, taking care that both sides are lifted
evenly. Secure Monkey Bars to warped wall
using four 1/2”x 3 1/2” bolts with lock washer
and at washer.
ATTENTION:
Wooden Lift support should
never be left unattended and
MUST BE STABILIZED by at least
one person at all times.
Top of Wall
3 1/2” Bolts x 4
Lock Washer
Flat Washer
on Each Bolt
