DFI TK130 Manual de usuario
Multi-Face Fever Detection
User Manual for TK130
Image-F
- 2 -
Version information：
Version
Content
Date
Ver. 1.0
Version 1
2020/6
- 3 -
Table of Contents
1. TK-130 Thermal camera ................................................................................................. 4
2. Installation Requirements ................................................................................................ 4
3. Camera Settings
3.1 Log in to the web interface ..................................................................................... 5
3.2 IP Address settings ................................................................................................. 5
3.3 Global Parameters settings ...................................................................................... 6
4. Notification on EZ Pro
4.1 Install the setup tool ............................................................................................ 10
4.2 Setup tool ........................................................................................................... 12
4.3 EZ Setting ........................................................................................................... 13
- 4 -
1. TK-130 Thermal camera
Main feature
Temperature measurement range: 30-45°C
Working temperature: 10-35°C
Accuracy: ±0.5°C
Resolution:384 × 288
2. Installation Requirements
Mount the TK-130 to the recommended height, approx. 2.5 meters.
The best detect distance between human & camera is approx.2.5-9 meters.
- 5 -
3. Camera Settings
3-1. Log in to the web interface
Key in the camera’s IP with Internet Explorer to enter the web UI.
The default IP Address would be: 192.0.0.64
The default user credentials would be:
User: admin
Password: 12345
3-2. IP Address settings
The factory default IP Address would be: 192.0.0.64
Modifying IP using camera web interface
(1) Go to 【Configuration】>【Network】>【Basic Settings】>【TCP/IP】on
web interface
Set up IPv4 address, subnet mask and gateway here.
Press to save the change
- 6 -
3-3. Global Parameters settings
Before using TK-130 to detect human temperature, you should set up some
parameters
Go to 【Configuration】>【System】>【Maintenance】>【VCA Resource
Type】
Make sure you have choose the
Temperature Screening
Live View Parameters
Go to 【Configuration】>【Local】
Enable and save the following settings:
- 7 -
Basic Settings
Go to 【Configuration】>【Temperature Screening】>【Basic Settings】>
【Basic Settings】
Choose
Camera 01
, configure and save the following settings:
Please set the distance as the real situation.
- 8 -
Temperature Screening Configuration
Go to 【Configuration】>【Temperature Screening】>【Basic Settings】>
【Temperature Screening Configuration】
Configure
Camera 01
(Optical) Settings.
(1) Make sure you have set the temperature to ensure alarm and
pre-alarm.
(2) Press
Draw Area
to adjust face detection region
(3) Set up Max. and Min. Pupil Distance
You can use the button below the image to set pupil distance. Max and
Min distance refer to camera detection distance.
- 9 -
Configure Camera 02 (Thermal) Settings.
Uncheck
Enable Blackbody Correction
If no blackbody is used.
Check.
Enable of Body Temperature Compensation and keep parameters as
default.
Manual Calibration
can adjust some errors if needed.
- 10 -
4. Notification on EZ Pro
4-1. Install
Temperature catcher
To post notification on EZ Pro, we need to install the setup tool first.
(1) Execute the installer.
(2) Follow the steps to finish the installer.
Tabla de contenidos
Otros manuales de Cámara térmica de DFI
