A.CHANNEL SECTON
All channels of powered mixers & mixing consoles are the same. Therefore ,this manualshows
the control functions of only one channel.
1.MICROPHONE
Electronically Microphone inputs accept astandard XLR male connector.
1.GROUND=shield, 2.HOT=signal input,
3.COLD=ground(shield).
You can use max 20-60dB according to signallevel by GAIN control.
2.LINE INPUT
USING BY 1/4"standard line connector, You
canuse unbalance(tip/sleeve) and
balance(tip/ring/sleeve). It can be connected with keyboards orother electric instruments.
Tip=positive ring=negative sleeve=ground
3.PAD(-20dB)
This switch.when push,attenuates the input signal-20dB.
4.CLIP(PEAK LEVEL INDICATOR)
The peak indicator LED will begin to illuminatewhen the post EQ,per fader signal of that channel
is within 10dB of actual clipping.
5.GAIN CONTROL
Adjust input sensitivity from -60dB to -20dB withthe -20dB pad switch in the out position and -40
dBto OdB. When the -20dB pad switch is pushed.
6.HIGH FREPUENCY EQUALIZATION CONTROL
Provides =15cB of fixed frequency equalizationthat shelves at 12KHz.
7.MID FREQUENCY EQUALIZATION CONTROL
Provides =15dB of fixed frequency equalizationthat shelves at 250KHz-6KHz.
8.LO FREQUENCY EQUALIZATION CONTROL
Provides +15dB of fixed frequency equalizationthat shelves 100Hz.
9.EFFECT CONTROL
Use this control when you want to get effect sound by adjustment of input signal. When you
don't use external source.digital delay will be working which installed in side.
10.AUX CONTROL
Use this contro! to set the level of signal from external stereo source and the main signal
control is re-controlled by master section.(seeAUXsection)
11.PAN CONTROL
The pan control sends continuously variable amounts of the post fader signal to either the
Left &Right main busses. In the center position,equal amounts of signal are sent to the and right
busses. As the control is roated in either direction,more
signal is sent to the buss indicated in the
direcction of the rotation while less signal issent to the other buss, if the control is turned all the
way to one side, the signal is only.
12.CHANNEL ON/OFF
When you want to control this, press this button,the green indicator LED to indicate the signals of
the channel has been lined in. Turn off the other channels to improve the reality of the noise
and to clear away the unnecessary noises. That would make it more perfect in the effect and
voice.
13.PRE-FADER LEVEL(PFL)
You can monitor the signal of the only channelwhich PFL switch is turned on using by headphone
in useful. When PFL switch is turned on, otherchannels are cut off automatically. See monitor
section.
14.INDICATION
Can be found easily by inputed input signal which recorded on the sticker.
15.CHANNEL FADER
You can adjust the volume of signalsources which connected to the relevant channel. .
