9
ENG
1.4. ADDITIONAL INDICATIONS
2011/65/EU (RoHS 2), European standard on the
restriction of the use of certain harmful substances
polybrominated biphenyls, polybrominated diphenyl
ethers) in small and large household appliances,
electrical and electronic tools, toys, leisure and sports
instruments, including industrial control instruments,
in the previous categories.
2012/19/EU (WEEE), European standard on the
recycling of non-disposable products, such as
dispose of it at the collection points designated for this
purpose in order to facilitate its appropriate recycling.
1.5. GENERAL SAFETY WARNINGS
ONLY STAFF THAT ARE DULY QUALIFIED MUST INSTALL
OR CONFIGURE THIS UNIT.
Read this manual carefully before beginning to install the
panel.
MAKE SURE you have the appropriate tools
damage to the unit, the facility to malfunction or safety risks
for people.
normal distributor or customer service before continuing to
install the unit.
applicable standards issued by the competent authority of the
corresponding country. Consult local, national and business
standards
Do not use the panel or its components beyond their
of -5°C to 40°C
earth.
The installation of the system on CAD-250 control panels must
include a method to isolate or disconnect the input voltage
supply. The isolation or disconnection device must be located
close to the system and be clearly labelled. The isolation or
disconnection device must disconnect both the active and the
Consider the incorporation of protection for the inputs against
overvoltages, depending on the type of location and risk
All signal and interconnection cables must be armoured and
this manual.
All ducts and the cable protection must be connected to the
the cable shield.
the system is connected in normal operation.
