Designer Systems DVD-D9RC+ Manual de instrucciones

Distributed by : Page 1 of 4 V1.00

Kingsbridge House, Padbury Oaks Tel: +44 1753 680023

575-583 Bath Road, Longford Fax: +44 1753 686020

Middlesex UB7 0EH Email: [email protected]

United Kingdom

Designer

DesignerDesigner

Designer

Systems

SystemsSystems

Systems

Bespoke Electronic Design & Manufacturing in the UK

.co.uk

9Channel Switch Interface

for the Denon®V300 player

Technical Data

DVD-D9RC+ interface

Firmware revision 1.00

Features

•Ultra low power consump-

tion from the connected

player

•Simple connection to Denon®

V300 player serial (RS232)

port

•Standard DVD-D9RC+ ver-

sion provides UP/DOWN

/LEFT/RIGHT and ENTER

(3 other versions also avail-

able from your distributor)

•Screw terminals for quick

connection to Normally

Open (NO) switch contacts

•Anti-bounce on all switch

inputs

•Enclosure lugs provide sim-

ple secure fixing

Description

The DVD-D9 interfaces permit

nine Normally Open (NO) mo-

mentary action switches the con-

trol of a Denon®V300 player.

The DVD-D9 range emulate a

standard external control device by

issuing PlayC, PlayT and RC com-

mands that control the action per-

formed by the player.

The DVD-D9RC+ issues cursor

UP/DOWN/LEFT/RIGHT, EN-

TER and number buttons 1-4 the

same as the IR remote control.

Other versions are also available

from your distributor, the DVD-

D9CH issues PlayC commands for

DVD media, the DVD-D9DA is-

sues PlayT commands for CD-DA

&VCD media and the DVD-

D9RC issues cursor UP/DOWN,

ENTER and buttons 1-6 the same

as the IR remote control.

Applications

The DVD-D9 range is primar-

ily for use within a kiosk envi-

ronment where input is required

from the kiosk control buttons

or from an Anti-Vandal button

plate such as the DVD-nBUT.

The devices are especially de-

signed to connect to any type of

momentary action switch and

can therefore be used to control

the DVD player in a number

diverse applications.

Custom designed firmware is available for

this product, please contact your distributor.

Selection Guide

Description Part Number

Remote control switch interface + DVD-D9RC+

DVD

ACCESSORIES

Distributed by : Page 2 of 4 V1.00

Kingsbridge House, Padbury Oaks Tel: +44 1753 680023

575-583 Bath Road, Longford Fax: +44 1753 686020

Middlesex UB7 0EH Email: [email protected]

United Kingdom

Power requirements

The DVD-D9 range are powered

from the serial port RTS line of the

connected DVD player. The maxi-

mum current draw is 6mA.

Switch Inputs

The DVD-D9 switch interface con-

sists of a series of nine double ter-

minal blocks to which any Normally

Open (NO) momentary switch can

be connected.

Contacts may be wired up to 100

metres away from the DVD-D9

without degrading the performance

of the device.

DVD-D9 interface

The DVD-D9 interface connection

is a standard DB9 male as specified

within the V300 player specifica-

tion.

Serial communication protocol is

9600 Baud, 1 Start bit, 8 Data bits, 1

Stop bits, No parity for all control

commands. All I/O is RS232 and

TTL compatible.

DVD control protocol

The DVD-D9 communicates with

the player using the player control

protocol . This protocol takes the

form of ASCII command strings of

format:

[PC,RC,44]\r

\r – Carriage return

These strings allow the PlayC (Play

Chapter), PlayT (Play Title/Track)

or RC (Remote control) commands

to be issued to the player in response

to an external button on the DVD-

D9 being pressed.

See button function tables at the end

of the document.

NOTE: For further information on

the DVD-D9CH, DVD-D9DA or

DVD-D9RC please see the rele-

vant datasheet.

DVD-D9 interface

Function DB9 Male

RTS 8

RXD 3

TXD 2

Ground 5

All other connection are N/C

Electrical Characteristics (TA= 25oCTypical)

Parameter Minimum Maximum Units Notes

Supply Voltage (RTS) 4.5 9 V

Supply Current - 6 mA

Switch resistance - 100 

Switch de-bounce time - 50 mS

RXData high level GND 0.8 V

RXData low level 2.4 VCC V

Terminal wire thickness 0.5 1.3 mm2

Absolute Maximum Ratings

Parameter Minimum Maximum Units

Supply Voltage (RTS) -0.5 +10 V

Environmental

Parameter Minimum Maximum Units

Operating Temperature 0 70 oC

Storage Temperature -10 80 oC

Humidity 0 80

Dimensions See below

Weight 150g

Immunity & emissions EMC compliance to 89/336/EEC

Distributed by : Page 3 of 4 V1.00

Kingsbridge House, Padbury Oaks Tel: +44 1753 680023

575-583 Bath Road, Longford Fax: +44 1753 686020

Middlesex UB7 0EH Email: [email protected]

United Kingdom

Normally Open switch connections

2000 (79)

92 (3.62)

52 (2.04)

Mechanical Specifications – Units millimetres (inches)

Installation

1. Ensure power to the Denon DN-V300 player is switched OFF.

2. Insert the lead on the DVD-D9RC+ into the I/O connector on the rear of the Denon DN-V300 player and secure

with the integral screw-locks.

3. Connect a Normally Open (NO) momentary action button across each of the inputs you wish to use (Note: each

double terminal block is one input) using a pair of wires or multi-conductor cable to a maximum length of 50 me-

tres using a small flat blade screwdriver.

(NB. For a ready-made aluminium button plate with sealed anti-vandal buttons see the Designer Systems DVD-

nBUT solution)

4. Site the DVD-D9 in a location that will not put undue strain on the terminals.

5. Switch ON the Denon DN-V300 player and test by pressing each of the wired in buttons cross referencing with the

table below. Should the installation not function, switch OFF immediately and check all connections.

Switch input No.

Function

1Button ENTER

2Button arrow UP

3Button arrow DOWN

4Button arrow LEFT

5Button arrow RIGHT

6Button 1

7Button 2

8Button 3

9Button 4

Notes:

•The DVD-D9RC+ must NEVER be connected to voltage bearing circuits; damage to the unit and the Denon DN-

V300 player will result and will invalidate the Warranty.

Distributed by : Page 4 of 4 V1.00

Kingsbridge House, Padbury Oaks Tel: +44 1753 680023

575-583 Bath Road, Longford Fax: +44 1753 686020

Middlesex UB7 0EH Email: [email protected]

United Kingdom

WEEE Consumer Notice

This product is subject to Directive 2002/96/EC of the European Parliament and the Council of the Euro-

pean Union on Waste of Electrical and Electronic Equipment (WEEE) and, in jurisdictions adopting that

Directive, is marked as being put on the market after August 13, 2005, and should not be disposed of as

unsorted municipal/public waste. Please utilise your local WEEE collection facilities in the disposition and

otherwise observe all applicable requirements. For further information on the requirements regarding the disposition of

this product in other languages please visit www.designersystems.co.uk

Apparatus name / model number DVD-9 Manufacturer Designer Systems, 15 Andrew Place, Truro, Cornwall

Conformity via Generic Standard EN50081-1 TR1 3HZ, United Kingdom

Generic Standard EN50082-1 Description of apparatus DVD control device

Conformity criteria For use only within commercial, residential and light industrial applications

We certify that the apparatus identified above conforms to the requirements of Council Directive 89/336/EEC & 73/23/EEC

Signed. Date 1/10/99

Having made this declaration the CE mark is affixed to this product, its packaging, manual or warranty.

The information appearing in this Operation Note is believed to be accurate at the time of publication. However, Designer Systems assumes no responsibility arising from the use of the

information supplied. The applications mentioned herein are used solely for the purpose of illustration and Designer Systems makes no warranty or representation that such applications will

be suitable without further modification, nor recommends the use of its products for application that may present a risk to human life due to malfunction or otherwise. Designer Systems

reserves the right to alter its products without prior notification. For the most up-to-date information, please visit our web site at http://www.designersystems.co.uk

Otros manuales de Equipo de grabación de Designer Systems