- When the door is open, press the inside button and fingerprint reader button together
and hold about 4 seconds.
- After 4 seconds, system will start to give signal by interrupts.
- Close the door within 8 seconds.
- When you close the door, system will automatically loc the door and system will be
switched to holiday mode.
When the system switched to the holiday mode, fingerprint reader and remote controller
receiver will be disabled. Because of that reason, entries only with fingerprint or remote
controller will be disabled.
To o en the door from outside:
First way;
- Use your ey to unloc and open the door.
- When you open the door, fingerprint reader will be on.
- Put your finger to reader (you need to do that in 5 seconds, otherwise alarm siren will be
activated). You will hear a signal from main unit and system will activate the motor to the
unloc ing side.
- After that, system will be switched to the normal mode.
Second way;
- Use your ey to unloc and open the door.
- When you open the door, fingerprint reader will be on.
- Press the unloc button of the remote controller (you need to do that in 5 seconds,
otherwise alarm siren will be activated). You will hear a signal from main unit and
system will activate the motor to the unloc ing side.
- After that, system will be switched to the normal mode.
IMPORTANT NOTE: BE SURE THAT YOU TAKE YOUR KEYS BEFORE SWITCHING
THE SYSTEM TO THE HOLIDAY MODE.
IV- ERASING FINGERPRINT AND REMOTE CONTROLLER
a. Deleting Finger rint
To erase fingerprint from system:
- When the door is open, press button of fingerprint reader and hold. Press inside button
of system and release both buttons. Fingerprint reader module will wa e up (red light
will be on and you will hear a signal.)
- Press the “DLT” button of the control unit. You will hear a signal from control unit.
- Put any master finger to the reader and when you hear a signal, draw bac the finger
immediately.
6
