DentalEZ Forest Manual de usuario

INSTALLATION

INSTRUCTIONS

2.17.21 0097-305 Rev. T 4 of 4

6200 NE Cherry Drive, Hillsboro, OR 97124 USA (TF) 800 . 423 . 3555 (T) 503 . 640 . 3012 (F) 503 . 693 . 9715

DTE OREGON, INC. DENTALEZ.COM

REAR PIVOT MOUNT

1 of 4

ALERT SYMBOL KEY

The safety notices associated with the following should be

given special attention when they appear in maintenance,

operating and emergency procedures in the guide.

WARNING indicates that the personal safety of the

patient, end user or technician could be compromised

by disregarding the WARNING. Not following instruc-

tions may result in an injury.

CAUTION indicates that a particular procedure

or precaution must be followed to avoid system

irregularity or possible damage to the product.

NOTE indicates special information to improve the

ease of maintaining the product, or to clarify important

information.

CAUTION: To avoid electrostatic discharge (ESD)

damage to electronics, always wear grounded wrist

strap attached to a ground adapter (eg: Banana or

Grounding plug) when handling circuit boards, chair

controls, and cables or working in the area of electrical

circuits.

CAUTION: Field modiﬁcations that alter the electrical

and/or mechanical safety of Forest products conﬂict

with agency construction ﬁle requirements and are not

sanctioned by Forest.

NOTE: Installation Veriﬁcation: Refer to Operator’s

Guide or Service Manual on our website at Forest-

dental.com; perform all operations. If operations

performing as intended installation complete. If

operations not performing as intended, review steps in

installation instructions to conﬁrm correct installation or

call Forest Technical Support at 800-423-3555.

FIG.1: POSITION CHAIR

Tools Required: 1/8”, 5/32”, 3/16”, 3/32” & 5/16”, 3mm, 8mm, and

10mm, Allen Hex Wrenches, 1/8”, 5/16” Allen Sockets with

Torque Wrench, 3/4”, 9/16” & 15/16” Wrench, Flathead Screw-

driver, and Nitrile Gloves.

NOTE: Chairs purchased before July of 2014 contain

metric screws, all chairs purchased after this date

contain standard screws. This kit contains a metric and

standard nut and bolt set to accommodate either chair.

Please check to make sure that you are using the

correct tools and hardware for your chair before

proceeding.

NOTE: If rear pivot is already installed, proceed to page 3.

REAR PIVOT ASSISTANT’S OR CUSPIDOR

MOUNT 3900 CHAIR

STEP 1: Position the chair’s back in the fully up position and

the base in the fully down position. (FIG. 1)

STEP 2: Remove the 6 screws holding the upholstery in place

(Phillips screwdriver). Sit upholstery and hardware aside.

(FIG. 2)

FIG. 2: REMOVE SEAT UPHOLSTERY

ROUTING DRAIN/SUCTION LINE

STEP 1: Remove covers. (FIG. 1)

STEP 2: Route and secure tubings together with zip tie. (FIG. 2)

CAUTION: Do not kink tubings with zip tie.

STEP 3: Make appropriate connection at utility center.

STEP 4: Reinstall covers.

STEP 5: Reinstall upholstery if originally removed.

FIG. 1: REMOVE COVERS.

COVERS

DRAIN LINE FROM

REAR PIVOT UNIT

ZIP TIE

TUBINGS

TOGETHER

FIG. 2: REAR UNIT DRAIN/SUCTION LINE.

2 of 4 3 of 4

REAR PIVOT ASSISTANT’S OR CUSPIDOR

MOUNT 3900 CHAIR (CONTINUED)

LIFT COVER PLATE INSTALLATION (FIG. 3)

STEP 1: Remove existing lift cover plate from chair (1/8” or

3mm hex).

STEP 2: Use pre-existing screws to install the new cover plate

that contains the umbilical routing hole.

REAR PIVOT MOUNT SETUP (FIG. 4)

STEP 1: Install rear pivot bumpers on the mounting plate using

the screws provided (5/32” hex). Choose hole location based

on the desired limits of the link arm that will be attached.

REAR PIVOT MOUNT INSTALLATION (FIG. 5)

STEP 1: Remove 3 shoulder bolts as shown (3/8” or 10mm hex)

If a chair mounted touchpad is installed, remove it during this

step.

STEP 2: Install mounting plate and spacers with nuts and

bolts provided. (5/16” hex & 3/4” socket or 8mm hex & 19mm

socket). If re/installing a chair mounted touchpad, insert the

touchpad mount assembly in place of the provided spacer.

STEP 3: Remove remaining shoulder bolt. Insert spacer and

secure with nut and bolt (5/16” hex & 3/4” socket or 8mm hex

& 19mm socket).

FIG. 3:

STEP 1: REMOVE

BOLTS (3)

STEP 2: INSTALL SPACERS/BOLTS

(3)

REAR PIVOT BEARING ASSEMBLY - ASSISTANT’S

1090/1091/1095/1096/1290

REAR PIVOT BEARING ASSEMBLY - CUSPIDOR OR DUO CONTROL

1490/1495PI/1500PI/1580/1590/1591

CAUTION: Protect work area. Threads to be

sealed must be clean and dry. Shake the product

applicator before use.

FIG. 4:

FIG. 5:

CAUTION: Protect work area. Threads to be sealed

must be clean and dry. Shake the product applicator

before use.

(REAR ADAPTER)

MAIN BEARINGS

1115-314

GREASE

BEARINGS

(LINK 1110-625)

LOCTITE®

(243/242) P/N:

0030-010

(ARM SIDE )

INTERMEDIATE BEARINGS

0010-679

MODEL 3900

CHAIR

ASSISTANT’S UNIT

(LINK = 1110-911)

(REAR ADAPTER)

MAIN BEARINGS

1115-314

MODEL 3900

CHAIR

GREASE

BEARINGS

LOCTITE®

(243/242) P/N:

0030-010

(ARM SIDE )

INTERMEDIATE BEARINGS

0010-728

CAUTION: 2 or 3 screw threads from bolt (1) should

protrude below the nut (13) for proper installation.

CAUTION: 2 or 3 screw threads from bolt (1) should

protrude below the nut (13) for proper installation.

STEP 3: REMOVE BOLT; INSTALL

SPACER/BOLT (1) CUSPIDOR OR

DUO CONTROL

LOCTITE®

(243/242) P/N:

0030-010

Otros manuales de Equipo dental de DentalEZ

DentalEZ

DentalEZ AERAS Star Manual de usuario

DentalEZ

DentalEZ StarDental 430 SWL RA Manual de usuario

DentalEZ

DentalEZ Star Manual de usuario

DentalEZ

DentalEZ StarDental Blis-sonic K Manual de usuario

DentalEZ

DentalEZ aXcs Series Manual de usuario

DentalEZ

DentalEZ Heritage Simplicity LED Light Manual de usuario

DentalEZ

DentalEZ Heritage CORE Chair Manual de usuario

DentalEZ

DentalEZ Heritage Manual de usuario

DentalEZ

DentalEZ Aeras Star 500 Elite Handpice Manual de usuario

DentalEZ

DentalEZ Star TITAN 3 5K MOTOR Manual de usuario

DentalEZ

DentalEZ Star LUBRICATED PROPHY ANGLE Manual de usuario

DentalEZ

DentalEZ StarDental Star Simplicity FX Manual de usuario

DentalEZ

DentalEZ Forest Manual de usuario

DentalEZ

DentalEZ Star Manual de usuario

DentalEZ

DentalEZ StarDental 430 SWL Torque Manual de usuario

DentalEZ

DentalEZ Aeras 400 Flex Manual de usuario

DentalEZ

DentalEZ StarDental 430 SWL Flex Manual de usuario

DentalEZ

DentalEZ J-Chair J-3 Manual de usuario

DentalEZ

DentalEZ StarDental Titan LubeFree Five Star Manual de usuario

DentalEZ

DentalEZ StarDental Titan 3 Five Star Manual de usuario

DentalEZ

DentalEZ Star Aeras 500 Elite Manual de usuario

DentalEZ

DentalEZ StarDental Concentrix FX Manual de usuario

DentalEZ

DentalEZ Aeras Ramvac C3 Manual de usuario

DentalEZ

DentalEZ aXcs Magellan Manual de usuario

Manuales populares de Equipo dental de otras marcas

Vatech

Vatech EzRay Air VEX-P300 Manual de usuario

KaVo

KaVo GENTLEpower LUX Contra-angle 25 LP Manual de usuario

DENTSPLY

DENTSPLY SmartLite Focus Manual de usuario

LM ProPower CombiLED Manual de usuario

Owandy Radiology

Owandy Radiology RX-AC Manual de usuario

mectron

mectron Piezosurgery Manual de usuario

Belmont

Belmont CREDIA G1 Manual de usuario

Planmeca

Planmeca Sovereign Classic Manual de usuario

Bego

Bego Fornax T Manual de usuario

Renfert

Renfert SYMPRO Guía rápida

Ateco

Ateco AT-301 Manual de usuario

Nevadent

Nevadent NZPS 3 A1 Manual de usuario

Muss Dental

Muss Dental MA 50 Manual técnico

Diplomat

Diplomat Comfort Series Manual de usuario

Dentatus

Dentatus Nyström Manual de usuario

OMS

OMS DUKE EASY Manual

OMS

OMS LINEA PATAVIUM Manual

BRYANT DENTAL

BRYANT DENTAL Ignis Gesture A-494322 Manual de usuario