Dell PowerEdge 2400 Manual de usuario



™









Throughout this guide, blocks of text may be accompanied by an icon and printed in

bold type or in italic type. These blocks are notes, notices, cautions, and warnings,

and they are used as follows:

NOTE: A NOTE indicates important information that helps you make better use of your

computer system.





  !"

"#

$%&$%&!"

"#

____________________

Information in this document is subject to change without notice.

Trademarks used in this text: Dell, PowerEdge, and the DELL logo are trademarks of Dell

Computer Corporation.

Other trademarks and trade names may be used in this document to refer to either the entities

claiming the marks and names or their products. Dell Computer Corporation disclaims any pro-

prietary interest in trademarks and trade names other than its own.

October 1999 P/N 6648R Rev. A01

Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si 1-1





 

! "#

To activate the integrated PowerEdge Expandable RAID Controller (PERC) 2/Si,

perform the following steps.



 !

"#$%&

'()*+,--.

+/01-+

%&+&,/.!

2&%&2+%

/01-!

3242+

/ 01-+++

#!5+-+565"

" !

1. Turn off and unplug your computer and peripherals.

2. Remove the right-side computer cover.

See “Checking Inside the Computer” in your system Installation and Trouble-

shooting Guide for more information.

3. Remove the cooling shroud.

See “Checking Inside the Computer” in your system Installation and Trouble-

shooting Guide for more information.

4. Press the ejectors on the RAID controller DIMM socket (see Figure 1-1) down

and outward to allow the dual in-line memory module (DIMM) to be inserted into

the socket (see Figure 1-2).

1-2 Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si



1Integrated RAID hardware key connector (RAID_KEY)

2DIMM socket for optional RAID controller (DIMM_RAID)

Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si 1-3



5. Align the DIMM's edge connector with the slot in the center of the DIMM

socket, and insert the DIMM in the socket (see step A in Figure 1-2).

The DIMM socket has two alignment keys that allow the DIMM to be installed in

the socket in only one way.

NOTE: The RAID controller DIMM must be an unbuffered DIMM, rated to run at

100 MHz. Do not substitute registered DIMMs such as those used for system

memory. System memory is labeled “PC133.”

6. Press down on the DIMM with your thumbs while pulling up on the ejectors with

your index fingers to lock the DIMM into the socket (see step B in Figure 1-2).

7. Install the RAID hardware key in its socket on the system board (see Figure 1-1).

Secure the key with the latches on each end of the socket (see Figure 1-3). The

RAID hardware key should be labeled “PE2400.”

1DIMM socket ejectors (2)

2Alignment keys (2)

1-4 Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si

 

8. Replace the cooling shroud and computer cover, and then reconnect the com-

puter and peripherals to their AC power sources and turn them on.

9. Press <F2> immediately after you see the following message:

<F2> = System Setup

If you wait too long and your operating system begins to load into memory, let

the system complete the load operation; then shut down the system and try

again.

For more information on the System Setup program, see “Using the System

Setup Program”in your system User’s Guide.

NOTE: To ensure an orderly system shutdown, consult the documentation that

accompanied your operating system.

10. Press <Alt> <p> to switch to Page 2 of the System Setup screen.

11. If the Onboard RAID option is displayed, select this option.

If the Primary SCSI option is displayed, the integrated RAID controller was not

detected; go to step 1 and repeat all installation steps.

'()*--+

/01-+%&/!

1RAID hardware key

2Latches (2)

3Socket

Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si 1-5

12. Press the left- or right-arrow key to set the Onboard RAID option to RAID.

The default setting for Onboard RAID is SCSI.

13. Press <Alt> <b> to save the settings and reboot the system.

14. Configure the RAID subsystem and install the RAID driver and management

software.

For more information, refer to the integrated PERC 2/Si controller documentation.

1-6 Dell PowerEdge 2400 Systems—Activating the Dell PowerEdge Expandable RAID Controller 2/Si

Otros manuales para PowerEdge 2400

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Servidor de Dell

Dell

Dell PowerEdge FX2 Manual de usuario

Dell

Dell PowerEdge R805 System Instrucciones generales

Dell

Dell 5J5D0 Manual

Dell

Dell DL4300 Manual de usuario

Dell

Dell PowerEdge R715 Manual de usuario

Dell

Dell DX6004S Manual de usuario

Dell

Dell PowerEdge C2100 Manual de usuario

Dell

Dell PowerEdge SC1425 Manual de usuario

Dell

Dell EMC PowerEdge R240 CHRH4 Manual

Dell

Dell PS4100 Instrucciones de montaje

Dell

Dell EMC PowerEdge T640 D24XR Manual

Dell

Dell PowerEdge 6800 Manual técnico

Dell

Dell Wyse ThinOS T10 Manual de usuario

Dell

Dell Wyse 5020 Manual de usuario

Dell

Dell EMC PowerEdge T640 Manual de usuario

Dell

Dell POWER EDGE SC1430 Manual de usuario

Dell

Dell PowerEdge C6100 Manual de usuario

Dell

Dell PowerEdge 2650 Manual de usuario

Dell

Dell PowerEdge T710 Manual técnico

Dell

Dell PowerEdge C5220 Manual de usuario

Dell

Dell DR4000 Restore Manager Manual de usuario

Dell

Dell PowerEdge M620 Manual de usuario

Dell

Dell PowerEdge M830 Manual de usuario

Dell

Dell External OEMR R320 Manual de usuario

Manuales populares de Servidor de otras marcas

HP AlphaServer ES47 Manual de usuario

PowerNAS

PowerNAS CMA Manual de usuario

Supero

Supero FatTwin F617R3-FT Manual de usuario

MSI

MSI P1-109N-L70 Manual de usuario

EtroVISION

EtroVISION EV3151 Manual de usuario

NEC

NEC Express5800/T110j Manual de usuario

HP ProLiant Gen9 Manual de usuario

Compaq

Compaq ProLiant 3000 Manual

iRobo

iRobo IPC2U Manual de usuario

Nortel

Nortel 1000 Con?guration guide Manual de usuario

Asus

Asus AP7500 Manual de operación y mantenimiento

Avid Technology

Avid Technology AirSpeed 5000 Manual de usuario

HP Integrity rx2600 Guía de instalación

Milestone

Milestone Husky IVO 350T Manual de usuario

Planet

Planet NAS-7410 Manual de usuario

Lenovo

Lenovo ThinkSystem SR635 V3 Manual de usuario

Fujitsu

Fujitsu PRIMERGY BX900 Manual de usuario

Asus

Asus RS700DA-E6 PS4 Manual de usuario