Dell Vostro 24-5460 Manual de usuario
Dell Vostro 24–5460
Owner's Manual
Regulatory Model: W12C
Regulatory Type: W12C007
Notes, cautions, and warnings
NOTE: A NOTE indicates important information that helps you make better use of your computer.
CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you
how to avoid the problem.
WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
©2016 Dell Inc. All rights reserved. This product is protected by U.S. and international copyright and intellectual
property laws. Dell and the Dell logo are trademarks of Dell Inc. in the United States and/or other jurisdictions. All other
marks and names mentioned herein may be trademarks of their respective companies.
2016 - 08
Rev. A00
1
Working on your computer
Before working inside your computer
To avoid damaging your computer, perform the following steps before you begin working inside the
computer.
1. Ensure that your work surface is flat and clean to prevent the computer cover from being scratched.
2. Turn off your computer (see Turning off your computer).
CAUTION: To disconnect a network cable, first unplug the cable from your computer and
then unplug the cable from the network device.
3. Disconnect all network cables from the computer.
4. Disconnect your computer and all attached devices from their electrical outlets.
5. Press and hold the power button while the computer is unplugged to ground the system board.
6. Remove the cover.
CAUTION: Before touching anything inside your computer, ground yourself by touching an
unpainted metal surface, such as the metal at the back of the computer. While you work,
periodically touch an unpainted metal surface to dissipate static electricity, which could
harm internal components.
Recommended tools
The procedures in this document require the following tools:
• Small flat blade screwdriver
• Phillips screwdriver
• Small plastic scribe
Turning off your computer
CAUTION: To avoid losing data, save and close all open files and exit all open programs before
you turn off your computer.
1. Turning off your computer :
• Using a touch enabled device:
a. Swipe in from the right edge of the screen, opening the Charms menu and select Settings.
b. Select and then select Shut down.
or
a. On the Home screen, touch and then select Shut down.
3
• Using a mouse:
a. Point to upper-right corner of the screen and click Settings.
b. Click and then select Shut down.
or
a. On the Home screen, click and then select Shut down.
2. Ensure that the computer and all attached devices are turned off. If your computer and attached
devices did not automatically turn off when you shut down your operating system, press and hold
the power button for about 6 seconds to turn them off.
After working inside your computer
After you complete any replacement procedure, ensure that you connect any external devices, cards, and
cables before turning on your computer.
1. Replace the cover.
CAUTION: To connect a network cable, first plug the cable into the network device and then
plug it into the computer.
2. Connect any telephone or network cables to your computer.
3. Connect your computer and all attached devices to their electrical outlets.
4. Turn on your computer.
5. If required, verify that the computer works correctly by running Dell Diagnostics.
4
2
Removing and installing components
This section provides detailed information on how to remove or install the components from your
computer.
Removing the Stand
1. Follow the procedures in Before Working Inside Your Computer.
2. Place the computer on a flat surface with the display facing downwards.
3. Pry the hinge cover from the computer.
4. Slide and lift the hinge cover from the computer.
5
5. Perform the following steps:
a. Remove the screws that secure the stand to the computer [1].
b. Slide and lift the stand from the computer [2].
Installing the Stand
1. Align the stand to the screw holes on the back of the computer.
2. Tighten the screws to secure the stand to the computer.
3. Press the hinge cover on the computer until it clicks into place.
4. Follow the procedures in After Working Inside Your Computer.
6
Removing the Back Cover
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the stand.
3. Pry the edges of the back cover to release it from the tabs.
4. Lift the back cover from the computer.
Installing the Back Cover
1. Align and press the back cover, until it clicks into place.
2. Install the stand.
7
3. Follow the procedures in After Working Inside Your Computer.
Removing the Hard Drive
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. stand
b. back cover
3. Disconnect the hard drive cable from the hard drive.
4. Perform the following:
a. Remove the screw that secures the hard drive to the computer [1].
b. Slide [2] and lift the hard drive from the slot [3].
5. Remove the screws that secure the hard drive to the bracket and lift the hard drive from bracket [1,2].
8
Installing the Hard Drive
1. Place the hard drive in the bracket.
2. Tighten the screws to secure the hard drive to the bracket.
3. Slide the hard drive into the slot.
4. Tighten the screw that secures the hard drive to the computer.
5. Connect the hard drive cable.
6. Install:
a. back cover
b. stand
7. Follow the procedures in After Working Inside Your Computer.
Removing the System Fan
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. stand
b. back cover
3. Disconnect the system-fan cable from the system board.
9
4. Perform the following:
a. Remove the screws that secure the system fan to the computer [1].
b. Lift the system fan from the computer [2].
Installing the System Fan
1. Tighten the screws that secure the system fan to the computer.
2. Connect the system-fan cable to the system board.
3. Install:
a. back cover
b. stand
4. Follow the procedures in After Working Inside Your Computer.
Removing the Memory module
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
10
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Computadora de Dell
Manuales populares de Computadora de otras marcas
Intergraph
Intergraph StudioZ RenderRAX Manual de usuario
Intel
Intel NUC Kit NUC5CPYH Manual de usuario
MSI
MSI Wind Top AE2712 Series Manual de usuario
Intergraph
Intergraph StudioZ RenderRAX II Manual de usuario
Intergraph
Intergraph StudioZ Manual de usuario
Intergraph
Intergraph TD-100 Manual de lista de piezas
