It is effective in dehumidification mode, and the humidity is set to 40% by default
every time it is switched to dehumidification mode. Change the humidity setting
value by pressing the Setting key, the humidity setting range is 40%-80%
-40%, every 5% interval, when the humidity is set, double 8 flashes display, after
stopping the key for 5 seconds, it returns to the normal display state.
When the machine has been running for a period of time to dehumidify, the H ring
<H is set to -2%, the compressor stops working, and the fan still works in the
previous state; as the ambient humidity increases, when the H ring> H is set to +2%,
compression When the three-minute protection time expires, the compressor starts
immediately; if the compressor stops for more than 3 minutes and the current
humidity is still lower than the set humidity value, the fan will automatically turn off.
In the drying mode, the humidity cannot be set, the default is 30%.
5. Press Timing to perform timing operation:
In the shutdown state, press the Timing key, double 8 displays the timing time, you
can press again at this time
Timing key to set the time, double 8 display cycle from 01-02...23-24, indicating that
the machine is scheduled to be turned on time, in the power-on state, press Timing
key, double 8 displays the timing time, and then you can Press Timing to set the
time, double 8 display from 01-02...23-24 cycle, which means the machine is
scheduled to shut down. After stopping the setting, the machine returns to the
normal display. The machine automatically cancels the timer function when it is
turned on/off or when the water is full.
6. Press the Negative ion key to control the switch of the negative ion, and the
negative ion light will be on when the negative ion function is turned on.
7. Press the Mode button, after turning on the machine, you can press the Mode
button to adjust the working mode. There are two working modes, dehumidification
and drying mode.
Water Tank:
When the water tank is full, the water full indicator will be on, the buzzer will beep
15 times to warn the user and then automatically stop, the water in the water tank
must be emptied, and the button will be invalid when the water is full.
Empty the water tank
