
DecaLED®
Power Supply IP20 Range
Product code(s)
95792401, 95790100
IP20
www.decaled.com
Technische specicaties | Technical specications
Plug adapter 25W
95792401
Power Supply 80W
95790100
Wattage | Power 25 W 80 W
Voltage ingang | Voltage input 220-240 VAC
Voltage uitgang | Voltage output 24 VDC
Voltage uitgang | V output min - max
Dimbaar | Dimmable -
Power factor
Efciëntie | Efciency 100-240 VAC
Uitgangsstroom | Output current 0,0 - 1 A 0,0 - 6,7 A
Aantal uitgangen | Output leads 1 x 20cm 1 x 20cm
Lengte L1| Length L190 mm 78 mm
Breedte W2| Width W224 mm 168 mm
Hoogte H3| Height H340 mm 45 mm
Gewicht | Weight 112 g 750 g
Veiligheidsinstructies
• Laat dit product installeren en onderhouden door een geschoolde technicus.
• De beschikbare netspanning mag niet hoger zijn dan de spanning in de specicaties
van deze handleiding.
• Houd dit product buiten het bereik van kinderen en onbevoegden.
• Elektrocutiegevaar bij het openen van het product. Raak geen kabels aan die onder
stroom staan om dodelijke elektrische schokken te vermijden. Open de behuizing niet
zelf. Laat het onderhoud van het product over aan een geschoolde vakman.
• Dit product heeft geen ingebouwde voorziening om het los te koppelen van het
stroomnet. Isoleer het product elektrisch voor de installatie of onderhoud. Zorg
ervoor dat het stroomsnoer niet gekneld of geplooid is en bescherm het tegen
beschadigingen. Waarschuwing! Indien de voedingskabel beschadigd is, dan moet
deze door de fabrikant, diens servicedienst, of een gelijkwaardig bekwaam persoon
vervangen worden om gevaar te voorkomen.
• Dit product is uitsluitend bestemd voor het gebruik met LED producten die een
constante spanning van 24VDC nodig hebben.
• Bij het aansluiten van de LED producten moet erop worden gelet dat (+) en (–) op de
juiste klemmen van de voeding aangesloten worden.
• Primaire en secundaire leidingen niet kruisgewijs aansluiten (voorkomen van vonken).
• Gebruik het product enkel binnenshuis. Bescherm het product tegen regen,
vochtigheid en opspattende vloeistoffen. Plaats geen objecten gevuld met vloeistof
op of naast het product.
• Alle elektrotechnische installaties dienen te worden uitgevoerd volgens de IEE
bedradingsrichtlijnen.
Safety instructions
• A qualied technician shall install and service this device.
• Make sure that the available voltage does not exceed the voltage stated in the
specications of this manual.
• Keep this device away from children and unauthorized users.
• Risk of electroshock when opening the cover. Touching live wires can cause life-
threatening electroshocks. Do not disassemble or open the housing yourself. Have the
device repaired by qualied personnel.
• This product does not have a built-in device to disconnect it from the electric mains.
Make sure to electrically isolate the luminaire before installation or maintenance
activities are performed. Do not crimp the power cord and protect it against
damage. Warning! If the power cord is damaged, it must be replaced by the
manufacturer, its service agent, or similarly qualied persons in order to avoid any
hazard.
• This product is only intended for the use with LED products that require a constant
voltage of 24VDC.
• When connecting the LED product, pay attention to connecting (+) and (–) to the
right terminals of the power supply.
• Primary and secondary power lines should not be connected crosswise (RFI
protection).
• Indoor use only. Keep this device away from rain, moisture, splashing and dripping
liquids. Never put objects lled with liquids on top of or close to the device.
• All electrical installations must be carried out according to IEE wiring regulations.
Reiniging en onderhoud
• Dit product heeft geen ingebouwde voorziening om het los te koppelen van het
stroomnet. Isoleer het product elektrisch voor de installatie of onderhoud.
• Alle gebruikte schroeven moeten goed zijn aangespannen en mogen geen sporen
van roest vertonen.
• De behuizing, de zichtbare delen, de montagebeugels en de montageplaats (bv. het
plafond of bevestingsveren) mogen niet vervormd zijn of aangepast worden (geen
extra gaten in montagebeugels boren, aansluitingen niet verplaatsen, enz.).
• De voedingskabels mogen niet beschadigd zijn. Laat het product onderhouden door
een geschoolde technicus.
• Indien de behuizing beschadigd is, moet u het product onmiddellijk loskoppelen van
het stroomnet. De behuizing is niet vervangbaar.
• De gebruiker mag geen onderdelen vervangen.
• Bestel eventuele reserveonderdelen bij uw plaatselijke verdeler.
• Maak het product geregeld schoon met een vochtige, niet pluizende doek.
• Gebruik geen alcohol of oplosmiddelen voor de reiniging.
Cleaning and maintenance
• This product does not have a built-in device to disconnect it from the electric mains.
Make sure to electrically isolate the luminaire before installation or maintenance
activities are performed.
• All screws shall be tight and free of corrosion.
• The housing, the visible parts, the mounting supports and the installation location
(e.g. ceiling, suspension, etc.) shall not be deformed, modied or tampered with;
e.g. do not drill extra holes in mounting supports, do not change the location of the
connections.
• The electric power supply cables must not show any damage.
• Have a qualied technician maintain the device.
• If the housing is damaged, disconnect the product immediately from the mains. The
housing is not replaceable.
• There are no user-serviceable parts.
• Contact your dealer for spare parts if necessary.
• Wipe the device regularly with a moist, lint-free cloth.
• Do not use alcohol or solvents for cleaning.
Versie 2015.04
W2
H3
L1