
5-9 Memory modules in memory slots 0 and 1 ................ 5–15
5-10 Removing a memory module ............................ 5–16
5-11 Replacing the cover on the system unit ................... 5–18
5-12 Typical CPU module ................................... 5–21
5-13 Installing a CPU module . . . ............................ 5–22
5-14 Removing the nameplate . . . ............................ 5–24
5-15 Where to install drives in the system unit ................ 5–26
5-16 Typical hard disk drive ................................ 5–30
5-17 Inside the system unit before the drives are installed . . . . . . 5–32
5-18 Locations for internal hard disk drives ................... 5–33
5-19 Power supply cable in the system unit ................... 5–34
5-20 SCSI cable in the system unit........................... 5–35
5-21 Power supply cable connector ........................... 5–36
5-22 SCSI connector . . . .................................... 5–37
5-23 Inserting the hard disk drive ........................... 5–38
5-24 Inside the system unit before the drive is installed......... 5–45
5-25 Inserting a removable media drive into the drive bracket . . . 5–46
5-26 SCSI cable connector .................................. 5–48
5-27 Plugging the cable straight into the connector . . ........... 5–49
5-28 Removing the existing bezel ............................ 5–50
5-29 Installing a new bezel ................................. 5–51
6-1 Base system ThickWire Ethernet connector . . . ........... 6–2
6-2 ThickWire Ethernet cable . . ............................ 6–3
6-3 Removing a loopback connector from a ThickWire Ethernet
connector ............................................ 6–4
6-4 Connecting a ThickWire Ethernet cable to the system unit . . 6–5
6-5 A DESTA and a ThinWire Ethernet T-connector ........... 6–8
6-6 A ThickWire-to-twisted-pair adapter and
twisted-pair-adapter-to-ThickWire cable .................. 6–11
7-1 Communications connectors on the system unit. ........... 7–2
7-2 Communications device connectors and an adapter ......... 7–3
7-3 Connecting a communications device with a 25-pin
connector ............................................ 7–5
8-1 Typical storage expansion boxes ......................... 8–2
8-2 Expansion box cables and an expansion box power cord and
terminator ........................................... 8–4
8-3 Expansion box SCSI switches ........................... 8–6
8-4 Attaching a system-unit-to-expansion-box cable to a SCSI
connector on the system unit ........................... 8–8
x