Attention: To check the authenticity of testing/inspection report & certicate, please contact us at telephone: +86 139 1666 5083, or email:
[email protected] ©DCbright
dcbright.com
Operating Instruction
no. : Dark Licht Operating Instruction
date: 06/12/23
page: 10/19
Installation - scope of supply
Check whether the contents of the package are complete.
Contents:
1x Dark Licht xture as specied
1x Instruction manual
1x Cable entry open-end wrench
1x Stainless steel (304) exible tube
Shrinking tube
Vulcanizing tape (3M J20)
Installation - general notes
1. Assembly, installation, and maintenance may only be performed by qualied persons.
2. Before installing or replacing the xture, ensure that the power supply is turned o to prevent accidents.
3. Prior and during installation, closely follow the instructions provided in this manual.
4. Before installing a luminaire, the load-bearing capacity of the lamppost or other installation location and the xing elements must be
ensured. If these values are unknown, have this calculated and/or checked by a certied company.
5. Electrical connection must be carried out in accordance with all applicable standards and directives.
6. The xture can only be used within the specied voltage range.
7. Recommended cable: Supply cord: EPDM H07RN-F 3G1.5mm2 - Dim cord: Dcbright H07BQ-F 4G0.5mm2
8. Make sure that the corresponding IP class is met when connecting the luminaire. For the Dark Licht xture this is IP67
9. Disassembly, assembly and adjustment of the luminaire should only be carried out with the power switched o.
10. Ensure proper sealing by adding shrink tubing and vulcanizing tape around the cable glands, providing a secure and watertight connection.
11. Position the luminaire in such a way that it prevents prolonged staring from a distance less than 11.688m into the luminaire.
12. The luminaire is designed to be suitable for both indoor and outdoor use.
13. The distance between the luminaire and a radio should be at least one meter to avoid possible interference with the radio reception.
14. Fixtures that are attached to a moving object must be secured with a safety cord or chain.
15. Make sure the xture is not exposed to heat sources beyond the specied operating temperature and vibration and avoid contact with
corrosive chemicals
16. The luminaire must not be covered or wrapped with insulating material. Because the maximum operating temperature around the luminaire
can lead to temperatures of 70°C, a minimum distance of 75mm must be maintained between the luminaire and thermal insulation materi-
als and components. Direct ceiling mounting is therefore excluded.
17. Never remove the glass plate or other parts of the xture yourself.
18. The xture must not be used if the housing is damaged or broken. Parts that have broken must be replaced immediately. Do not switch on
power as long as the xture is damaged or broken. If damage has occurred to the luminaire, please contact your supplier immediately
19. Commissioning and storage must be within the rated temperature range
20. In order to prevent light nuisance and to guarantee proper functioning of the full-cut-o reectors, the luminaire must always be installed
21. in accordance with the pre-made lighting plan; For this reason, it is not recommended to tilt the xture more than 15 degrees in a perma-
nent installation
22. Never attempt to repair the xture yourself; repairs must be conducted by the manufacturer or a designated company.
23. Maximum mounting height: 50 meter - Maximum elevation height: none
