POSITIONING
You probably have a position for your loudspeakers in mind. Start with this position and try to position the
loudspeakers not too close to a corner (>0.5m), and between 1.5m and 3 m apart. For the listening
position we recommend in the middle in front of the speakers, a distance away from the speakers a little
over the actual gap between them.
CONNECTING
With all equipment turned off, please check the connections on your loudspeaker cable. You now have the
following two possibilities:
1. (recommended) spade type connector: rotate the speaker terminal knob counter clockwise
and mount the + and - spade connector simultaneously in between the knob and the speaker
terminal base. Tighten the speaker terminal knob firmly by rotating clockwise.
2. no connector: rotate the speaker terminal knob counter clockwise. Remove the cable isolation
for about 10-15mm. Bend halve of the wire strands around the left and the other halve around
the right side of the copper terminal piece. Do this for the + and - cable endings simultaneously
and tighten the knob firmly by rotating clockwise.
A tie rap mount is provided in the stand base to enable to hide the loudspeaker cable out of sight. With the
cable connected to the loudspeaker terminal, guide the cable downward the stand, and tighten it to the
stand base with the tie rap. Note: the provided tie rap can not be released without cutting it.
CONNECT TO YOUR AUDIO AMPLIFIER
Ensure that positive terminals on the speaker (marked +) are connected to the positive output terminal on
the amplifier. The negative terminals on the speaker (marked – ) should be connected to the negative
output terminal on the amplifier. With the cable securely connected to amplifier and loudspeaker, you can
switch on your audio amplifier. If you are satisfied with the sound quality, you have now successfully
installed your Davone Ray loudspeakers. If not, in the next section you can find recommendations how to
improve.
