DAVID D2000 Manual de usuario
Models: S10S.DV, S10P.DV
Owner’s Manual
1
Getting Started
Important Safety Instructions 2
Polarization Instructions 3
State of California Proposition 65 Warnings 3
Description of the Vacuum 4
Assembling the Vacuum 5
Operation
Reclining the Handle 6
On/Off Switch 6
Edge Cleaning 6
Automatic Carpet Height Adjustment 6
Bare Floor Cleaning 6
Maintenance and Care
Power Cord Care 7
Vacuuming Under Furniture 7
Replacing the Vacuum Bag 8
Removing/Reinstalling the Bottom Plate 9
Replacing the Agitator Belt 10
Lifetime Belt Protection 10
Brushroll Jam Indicator 11
Resetting the Circuit Breaker 12
Replacing the Squeegee 12
Annual Checkup 12
Problem Solving Guide
Troubleshooting 13
How to Contact Your Authorized Retailer 13
Key Replacement Parts 13
For Best Performance 13
Warranty 14
CONTENTS
2SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS
APPLIANCE. FOR HOUSEHOLD USE ONLY.
IMPORTANT:
The manufacturer cannot accept responsibility for damage
caused when the appliance is not used according to the instructions, or for uses other
than those for which it was intended.
WARNING:
To reduce the risk of fire, electric shock, damage or injury:
• Do not leave appliance when plugged
in. Unplug from outlet when not in use
and before servicing.
• Do not use outdoors or on wet
surfaces.
• Do not allow to be used as a toy. Close
attention is necessary when used by or
near children.
• Use only as described in this manual.
• Do not use with damaged cord or plug.
If appliance is not working as it should,
has been dropped, damaged, left
outdoors, or dropped into water, return
it to your Authorized DAVID Vacuum
Retailer for service.
• Do not pull or carry by cord, use cord
as a handle, close a door on the cord,
or pull cord around sharp edges or
corners. Do not run appliance over
cord. Keep cord away from heated
surfaces.
• Do not unplug by pulling on cord. To
unplug, grasp the plug, not the cord.
• Do not handle plug or appliance with
wet hands.
• Do not put any object into openings.
Do not use with any opening blocked;
keep free of dust, lint, hair and anything
that may reduce air flow.
• Keep hair, loose clothing, fingers and all
parts of body away from openings and
moving parts.
• Do not pick up anything that is burning
or smoking, such as cigarettes, matches
or hot ashes.
• Do not use without vacuum bag in
place.
• Turn off all controls before unplugging.
• Use extra care when cleaning on stairs.
• Do not use to pick up flammable or
combustible liquids such as gasoline or
use in areas where they may be
present.
• Do not attempt to service the unit while
appliance is plugged in.
3
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the State of
California to cause cancer.
WARNING: This product contains one or more chemicals known to the State of
California to cause birth defects or other reproductive harm.
POLARIZATION INSTRUCTIONS
Power Cord, 2-Wire Polarized Cord
To reduce the risk of electric shock, the charger is equipped with a polarized
alternating current line plug (a plug having one blade wider than the other). This
plug will fit into the power outlet only one way. This is a safety feature. If you are
unable to insert the plug fully into the outlet, try reversing the plug. If the plug
should still fail to fit, contact a qualified electrician to replace the obsolete outlet.
Do not defeat the safety purpose of the polarized plug.
4
1 Ergonomic Handle
2 On/Off Power Switch
3 Bag Compartment
4 Vacuum Nozzle
5 Headlight
6 Furniture Guard
7 Brushroll Jam Indicator (model S10P.DV)
8 Circuit Breaker Reset Button (model S10S.DV)
9 Handle Release Pedal
10 Quick Release Cord Hook
11 Upper Cord Hook
1
2
3
4
5
6
7
89
10
11
DESCRIPTION OF THE VACUUM
5
Attaching the Handle
to the Vacuum
NOTE: Do not plug in the vacuum until it
is completely assembled.
The vacuum cleaner and the handle are
packed separately and require assembly.
• Thread the cord through the lower and
upper cord guides on the back of the
vacuum bag (Fig. 1).
• Remove the handle bracket by
removing the two screws (Fig. 2).
• Place handle onto the back of the
vacuum, aligning holes with pegs
(Fig.3).
• Place the handle bracket back into
position (Fig. 4).
• Secure with two screws removed in
Step 2.
• Open the bag compartment to ensure
a vacuum bag is in place.
• Your vacuum is now ready for use.
• If storing the vacuum, wrap the cord
clockwise around the top and bottom
cord hooks. Fasten the plug to the
wrapped cord using the channel on
theplug.
Unwinding the Power Cord
• The lower cord hook rotates to allow
for quick access to the power cord.
Turn the lower cord hook upward and
you can quickly drop the power cord to
the floor without unwinding it from the
cord hooks.
• When storing the vacuum cleaner, turn
the lower cord hook to the downward
position and wind the power cord
around the cord storage hooks.
Fig. 2
Fig. 3 Fig. 4
Fig. 1
ASSEMBLING THE VACUUM
6
Reclining the Handle
• Press the handle release pedal located
on the back of the vacuum with your
foot to recline the handle (Fig. 1).
On/Off Switch
• The power switch located on the
vacuum handle, is a three-way switch
(Fig. 2). The middle position is the “Off”
setting, the rear position is the “On”
setting and the forward position is for
“Maximum Power” (Fig. 3).
• Use the “Maximum Power” setting for
carpet cleaning. Use the “On” setting
for cleaning bare floors and throw rugs.
Always turn the vacuum cleaner to the
“Off” setting before unplugging it from
the electrical outlet.
Edge Cleaning
The edge cleaning feature provides
improved cleaning near walls and
stationary furniture. For maximum edge
cleaning, place the left side of the nozzle,
from the user’s perspective, against the
wall or stationary furniture.
Automatic Carpet
Height Adjustment
Your vacuum is designed with an
automatic self-adjusting nozzle. No
manual adjustments are required. The
height of the nozzle automatically
adjusts to the flooring surface. This self-
adjusting feature allows the nozzle to
float evenly over all flooring surfaces.
Bare Floor Cleaning
Your vacuum is equipped with a
squeegee on the bottom of the vacuum
to improve its effectiveness in cleaning
bare floors (Fig. 4). When cleaning
tile, hardwood, vinyl, etc., use the “On”
setting for best results.
This vacuum is intended for household use only.
Fig. 2
Fig. 1
Fig. 3
ON
OFF
MAX
POWER
Fig. 4
OPERATION
7
Fig. 2
Power Cord Care
• If the cord or plug has any apparent
damage, refrain from using the vacuum.
Please visit an Authorized DAVID
Vacuum Retailer for a new cord or plug.
• When the vacuum is in use, hold the
cord to keep from running over it.
• Avoid obstructions and do not pull the
cord around sharp edges or corners.
• Always keep the cord away from
heated surfaces and never close doors
on it as this may cause damage to
thewiring.
• To unplug, always grasp the plug, not
the cord.
Vacuuming Under Furniture
Your vacuum will lay flat on the floor for
effective cleaning under beds and tables.
• Press the handle release pedal once for
normal vacuum cleaning (Fig. 1).
• Continue to lower the handle to enable
the vacuum to lay flat on the floor
(Fig.2).
MAINTENANCE AND CARE
Fig. 1
8
Replacing the Vacuum Bag
NOTE: Unplug the vacuum cleaner from
the electrical outlet before changing
thebag.
• Unzip the bag compartment.
• Remove the used vacuum bag by
pulling the green bag collar tab away
from the vacuum (Fig. 1). Slide the
used bag out of the bag holder which
automatically seals the bag opening
(Fig. 2). Discard the used bag.
• To install a new bag, slide the bottom
of the green bag collar into the bag
holder until it “snaps” into place
(Fig.3).
• Push the top of the bag collar upward
until the collar “snaps” into place on the
vacuum (Fig. 4).
• Tuck the bag corners into the bag
compartment then zip the bag
compartment closed.
Fig. 1
Fig. 2
MAINTENANCE AND CARE
Fig. 3
Fig. 4
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
