5Dateq LPM 7.4 Manual Mounting EN
Connections
BALANCED Electronically alanced master outputs for the left and right channel on
MASTER L / R XLR connectors for Master 1 & 2. This type of output guarantees a perfect
signal transport, even when long audio ca les are eing used. These
outputs are equipped with relays to prevent audi le ‘ lo s’ on connected
equipment when the LPM 7.4 is switched on or off.
MASTER 1 & 2 Un alanced master output on cinch-connectors. Can e used to connect
the LPM 7.4 to an amplifier or a recorder.
MON Un alanced monitor output on cinch connectors. Can e used to connect a
second amplifier with monitor speakers for the DJ or a second room.
PFL Un alanced output on cinch connectors. This output follows the pre-fader
listening. This output can e used to connect an (monitor) amplifier or
recorder.
REC Un alanced recorder output on cinch-connectors. This output is fixed-level
(independent from the master volume control).
EFFECT SEND Stereo postfader effect sends from microphone inputs. This output can
also e used as a cleanfeed output.
EFFECT RETURN Stereo effect return input. Can also e used as an extra input.
CHANNELS 1..7 Cinch connectors for all stereo channels. Channel 1, 2, 6 and 7 have two
identical line inputs. Channels 3, 4 and 5 have oth an input for turnta les
(phono) and an input for equipment like CD-players, samplers, key oards
and recorders (line). When turnta les are eing used, these must e
earthen y means of the earth-clamp.
CHANNELS 1..7 Electronically alanced microphone input on XLR connector. When used
un alanced, connect pin 1 and 3 with the shielding of the ca le. Both
channels are equipped with a secondary stereo line input.
CUE Channel 3, 4 and 5 are equipped with a remote start connector. As soon as
the fader of the concerning channel is opened, the contact etween tip and
ring of this mini jack (3,5 mm) connection is made. With this the connected
equipment can e remote started.
The remote-connection is NOT suitab e for switching mains vo tage!
FUSE Mains fuse. Dimension 5x20mm (small), 315mA slow.
MAINS Euro-style mains inlet. Before connecting the LPM 7.4for the fist time,
check if your LPM 7.4 is meant for the mains voltage in your country (la el
on the connector oard at the rear).
For a cinch-connectors:
White = Left, Red = Right.
