Operation of the machine
EASYLAM EXPERT 80C is supplied as a table-top unit without stand. In the start-up phase the operator
stands in front of the machine. The machine is switched on via the main switch. With the start/stop switch
starts the laminating process. Alternatively you can use the foot pedal to continuously adjust the speed.
General information
The material axles are equipped with adjustable slipping clutches/brakes. Each material has own cha-
racteristics, which vary according to temperature, humidity, adhesive used, type of film, etc. The ideal
working condition is that in which the material on the upper roller is stretched and applied with minimal
braking without wrinkles. The search for this „Ideal setting“ begins by looking for the point where the brake
unit only works lightly in order to then, if necessary, to become gradually stronger. Take care not to stretch
the film too much, to prevent it from being initially stretched and then warping the laminated product.
If the protective liner is to be rolled up, it is sufficient if it is slightly tightened. Therefore make sure that the
roll-up clutch is carefully adjusted.
Assembly lever:
The lever on the right side must be screwed on before commissioning.
Connect power supply and pedal: as shown.
- 5-
OPERATION
Operating personnel
The machine may only be operated by qualified personnel.
Material guide
The material axis can carry laminate with silicone paper as well as double-sided adhesive film. To insert the rolls,
refer to the illustrations and proceed as follows:
Mounting the material axis
The axes have different mounts on the laminator.
The material axis with the red dot must be inserted on the left first.
Next Page 8
