Care and Operang Instrucons SAVE THESE
INSTRUCTIONS
WARNINGS:
•Pump must ALWAYS be submerged in water. DO NOT RUN DRY.
•Keep ALL electrical connecons out of the water.
•Never plug into a power outlet if any part of the product appears to be damaged.
•Check for leaks aer inial setup and occasionally aerwards.
•DO NOT use any household cleaners on any of the surfaces.
•NEVER allow water to freeze in the fountain. ALWAYS drain fountain basin before
temperatures go below freezing.
•ALWAYS use a “Drip Loop” when operating the pump (see Fig.1). The drip loop simply allows
a portion of the cord to drop down below your outlet before rising back up to it. This will
prevent any water from running into your outlet.
MAINTENANCE:
•Change water periodically to reduce scaling & mineral buildup. Use of Distilled water will help
prevent buildup.
•Check water level and add as necessary to maintain proper level.
•Drain all water from basin and remove & rinse pump if fountain will be out of service for any
extended period of me.
•Remove pump from fountain periodically and rinse with fresh water to remove any debris or
buildup.
•Rinse basin periodically with tap water and wipe away any buildup.
Limited Warranty
E. G. Danner will repair or replace any unit found to be mechanically defective within 90 days of purchase. For
warranty issues please contact Danner Customer Service for information before returning product. A dated proof
of purchase must be presented to validate any warranty claim. Damages or injuries resulting from negligence,
abuse or misuse of this product are excluded from this warranty. This warranty gives you specific legal
rights and you may have other rights which vary from state to state.
DANNERMFG.INC. Islandia, NY 11749-1489 Phone 631-234-5261.
Visit our website at www.Dannermfg.com
Fig. 1
WINTER STORAGE:
Although these fountains are designed and rated for outdoor use, winter weather conditions in
some regions may adversely affect their finish, performance and lifespan. If the temperature in
your region is at risk of dropping below 34° F, your fountain should be “winterized” before those
temperatures arrive. Follow the simple steps below to winterize your fountain and assure a
trouble-free startup in the spring:
1. Remove power from the pump and completely drain all the water from the fountain basin.
2. Remove the pump from the fountain basin & disconnect it from the fill tube.
3. Disconnect the LED connection lead.
4. Clean the pump as stated in the "Maintenance" section above.
5. Allow all parts to dry or assist with compressed air. Then store all the components in a
temperature controlled area such as a basement or garage.
ZG0388 Rev.A 06/21
