Danfoss VLT Soft Starter MCD 600 Manual de usuario

1 Description

1.1 Introduction

WARNING

SHOCK HAZARD

The soft starter contains dangerous voltages when connected to mains voltage. Attaching or removing accessories when the soft

starter is connected to mains may cause death or serious injury.

Isolate the soft starter from mains voltage before attaching or removing accessories.

Fit finger guards to all terminals, even if no cable is connected.

Finger guards fit over the soft starter's power terminals to increase IP rating and prevent accidental contact with live terminals.

Finger guards provide IP20 protection when used with cables of diameter 22 mm or greater.

1.2 Parts List

Item

Quantity

Finger guard

Retaining brackets

Cable ties

Installation guide

Table 1: Code Number

Kit

Ordering number

Finger guard kit IP20, models 0144B–0579B and 0160C~0448C

175G0186

Finger guard kit, models 0654B–1250B

175G0202

NOTICE

Finger guards are not available for models 0590C–1134C.

Installation Guide

Finger Guards

VLT® Soft Starter MCD 600

Danfoss A/S

Ulsnaes 1

DK-6300 Graasten

vlt-drives.danfoss.com

Danfoss can accept no responsibility for possible errors in catalogs, brochures, and other printed material. Danfoss reserves the right to alter its products without notice.

This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary in specifications already

*175R1176*

*M0014601*

2 Installation

2.1 Installing the Finger Guards

Procedure

Disconnect the soft starter from mains and control voltage.

Place 1 retaining bracket over each busbar and clip into the base of the soft starter.

Feed each power cable through the narrow end of each finger guard.

Connect the cables to the appropriate terminals of the soft starter.

If the cables do not fit through the finger guards, shorten the finger guards at the narrow end to make a bigger opening.

Push the finger guard over each retaining bracket and secure in place with a cable tie.

e77ha756.10

Illustration 1: Parts Included in the Finger Guard Kit

Retaining brackets

Finger guards

Cable ties

Installation

Finger Guards

Installation Guide

Otros manuales para VLT Soft Starter MCD 600

Tabla de contenidos

Otros manuales de Equipos industriales de Danfoss

Danfoss

Danfoss APP 11-13 Manual de usuario

Danfoss

Danfoss BOCK FK40 Manual de usuario

Danfoss

Danfoss ET5040 Manual de usuario

Danfoss

Danfoss Optyma Slim Pack Manual de usuario

Danfoss

Danfoss AK-PI 100 Manual de usuario

Danfoss

Danfoss VVX-I Manual de usuario

Danfoss

Danfoss Termix VVX-IV 7 Series Manual de usuario

Danfoss

Danfoss MPE 70 Manual de usuario

Danfoss

Danfoss S 22 Manual de usuario

Danfoss

Danfoss iC7 Series Manual de usuario

Danfoss

Danfoss IPS 8 Guía del usuario

Danfoss

Danfoss iSave 21 Manual de usuario

Danfoss

Danfoss AFQM 2 PN16 Manual de usuario

Danfoss

Danfoss VLT HVAC Drive FC 102 Manual de usuario

Danfoss

Danfoss FIA SS 15-65 Manual de usuario

Danfoss

Danfoss EC-LTS1200-410 Manual de usuario

Danfoss

Danfoss Brazed Plate Heat Exchanger Manual de usuario

Danfoss

Danfoss BHO 64A Manual de usuario

Danfoss

Danfoss Kompakt H28 Manual de usuario

Danfoss

Danfoss Aeroquip FT1370 Manual de usuario

Danfoss

Danfoss Aeroquip FT1360 Manual de usuario

Danfoss

Danfoss iSave 40 Manual de usuario

Danfoss

Danfoss ED-DT318B Instrucciones de funcionamiento

Danfoss

Danfoss DHP-AQ Guía de inicio rápido

Manuales populares de Equipos industriales de otras marcas

ABB

ABB Unifix AD Manual

Mark 7

Mark 7 Evolution Manual de usuario

Husky

Husky HyPET Manual de usuario

bora

bora PM-1800 Manual de usuario

Grizzly

Grizzly T32428 Manual de usuario

Siemens

Siemens 8MF1 Series Manual de usuario

ABB

ABB HT610965 Manual de usuario

ABB

ABB SafeLink Manual de usuario

Phoenix

Phoenix PHX-150 Manual de usuario

ABB

ABB A165-L32 Manual de usuario

ABB

ABB HT842936 Manual de usuario

Rioned

Rioned UrbanJet Manual de usuario

Hermetica

Hermetica 10 Series Manual de usuario

HORNER

HORNER OEE Solution Manual de usuario

Hammerhead

Hammerhead HG375 Manual de usuario

SCHUNK

SCHUNK VERO-S NSE-A3 138 Instrucciones de uso

ABB

ABB HT566657 Manual de usuario

Webasto

Webasto GSE CAN Manual de usuario