Dali PHANTOM IW SUB S-100 Manual de usuario

DALI PHANTOM

IW SUB S-100

INSTALLATION MANUAL

Contents

2.0 Safe Precautions 4

3.0 Unpacking 5

4.0 Positioning and Installation 6

4.1 Positioning 7

4.2 In-wall Installation 9

4.2.1 Cables 9

4.2.2 Wall Aperture 10

4.2.3 In-wall Installation 11

4.2.4 On-wall Installation 15

4.2.5 Unmounted Installation 17

5.0 Cleaning 19

6.0 Disposal 19

7.0 Technical Speciﬁcations 20

Congratulations on your new DALI PHANTOM

IW SUB S-100 In-wall subwoofer. In order to

get the most from your purchase, please read

this manual carefully before you unpack and

install your new subwoofer. You can ﬁnd more

information on our website: www.dali-speakers.

com or by contacting your authorised DALI

retailer.

The DALI PHANTOM IW SUB S-100 subwoofer

is designed to be used with the matching DALI

PHANTOM CI AMP-2500 DSP ampliﬁer.

Comprehensive information on ampliﬁer to

subwoofer routing and connections, can be

found in the CI AMP-2500 DSP Installation

Manual available for download from dali-

speakers.com

NOTE

The matching DALI PHANTOM CI AMP-2500

DSP power ampliﬁer is required for the correct

operation of PHANTOM SUB S-100 subwoofers.

Each CI AMP-2500 DSP can power up to

four SUB S-100 subwoofers. The SUB S-100

subwoofer has been developed with- and is to

be ampliﬁed by, the AMP-2500 DSP ampliﬁer to

achieve the best performance.

NOTE

Comprehensive information on AMP-2500

DSP ampliﬁer installation can be found in the

AMP-2500 DSP installation manual available for

download from dali-speakers.com.

2.0 Safety Precautions

• Always follow all safe precautions.

• It is recommended that the PHANTOM IW SUB S-100

should be installed by competent professional audio

installation technicians.

• The SUB S-100 must only be used indoors and never in

extreme humid, hot or cold temperatures.

• The SUB S-100 must only be used with the matching AMP-

2500 DSP ampliﬁer.

• The SUB S-100 should not be exposed to continual direct

sunlight.

• Ensure that there are no service installations such as

electrical or data cables, gas or water pipes, or ventilation

ducts present in the wall at the SUB S-100 mounting

location.

• Ensure that the wall is easily able to support the weight of the

SUB S-100 subwoofer. If necessary consult an appropriately

qualiﬁed structural engineer for advice.

• When installing a SUB S-100 in a plasterboard/dry wall we

recommend that two layers of plasterboard are used in the area

around the subwoofer. If it is not possible to use two layers of

plasterboard, we recommend one of these measures:

• Reinforce the single layer plasterboard beneath the dogleg

clamps using wood pieces measuring at least 75 mm x 30 mm x

3 mm thick (3 in x 1.2 in x 0.125 in). Or…

• Install the SUB S-100 on-wall using a DALI PHANTOM S-80

On-Wall Frame (OW FRAME S-80).

• If the SUB S-100 subwoofer is to be installed in a wall where

a vapour barrier is present, ensure that the barrier is not

compromised during installation.

• Ensure that the AMP-2500 DSP driving ampliﬁer is switched o

when connecting cables between the SUB S-100 subwoofer and

the ampliﬁer.

3.0 Unpacking

Take care not to damage the box contents

when unpacking the SUB S-100 subwoofer.

Once unpacking is complete, check that all

components listed and illustrated in Diagram 1

are present.

1 x DALI PHANTOM

IW SUB S-100

1 x Grille (magnetic) 1 x Cut-out template 4 x Rubber pads

DIAGRAM 1: CONTENTS

We recommend that packaging materials are

retained in case the SUB S-100 subwoofer requires

relocation. If however the packaging materials are

to be discarded, please ensure they are disposed of

responsibly and recycled where possible.

4.0 Positioning and Installation

The SUB S-100 is a passive In-wall subwoofer designed for use in both

conventional stereo and multi-channel home theatre audio systems.

SUBS-100 subwoofers can be installed singularly or in multiples.

Although the SUB S-100 is primarily intended for In-wall installation, it

can also be installed on-wall using an appropriate DALI On-wall Frame, or

be used unmounted lying on its back, also using an On-wall Frame as an

external cabinet.

ON-WALL

INSTALLATION

IN-WALL

INSTALLATION

UNMOUNTED

INSTALLATION

DIAGRAM 2: IN-WALL/ON-WALL SUBWOOFER POSITIONING

Example single In-wall or on-wall subwoofer positions Example multiple In-wall or on-wall subwoofer positions

4.1 Positioning

By their very nature, the positioning of

subwoofers such as the SUB S-100 is

less critical than the positioning of stereo

speakers, but still there are some guidelines

to follow, described below and illustrated in

the Diagrams 2 and 3, that will help ensure

optimal performance.

• If a single SUB S-100 is to be installed, it is

best located near the ﬂoor of the listening

room in or on the wall that also carries

the front le and right channel speakers.

The closer the subwoofer is to the corner

of the room, the more it will gain acoustic

reinforcement from the room and the less

volume level it will require.

• If a pair of SUB S-100 subwoofers are to

be installed, they are best located near the

ﬂoor of the listening room in or on the wall

that also carries the front le and right

channel speakers. As with single subwoofer

installations, the closer the subwoofers

are to the corner of the room, the more

they will gain acoustic reinforcement from

the room and the less volume level they will

require.

>50 mm / 1,98 in

DIAGRAM 3: UNMOUNTED SUBWOOFER POSITIONING

Examples concealed installation on the floor beneath furniture

• If SUB S-100 subwoofers are to be installed on the surface of a

wall using an On-wall Frame, or unmounted lying on their back using

On-wall Frames as cabinets, the same location guidelines as for In-

wall installation should generally be followed. The use of SUB S-100

subwoofers unmounted lying on their back however does potentially

enable concealed installation on the ﬂoor beneath furniture.

• In either single or multiple subwoofer installations, if it is not practical

to install SUB S-100 subwoofers in the same wall as the front le and

right channel speakers, installation in the side walls of the room, close

to the front corners is also viable.

4.2 In-wall Installation

4.2.1 Cables

The choice of cables used to connect SUB S-100 subwoofers to the

AMP-2500 DSP power ampliﬁer is important. Replacing cables following

installation is potentially dicult so it is best to select quali cables from

the start. Your authorised DALI retailer will be able to advise on cable

choice.

When connecting cables to the subwoofer and the ampliﬁer it is

important that correct polari is retained. The red (positive +)

subwoofer terminal must be connected to the positive (+) ampliﬁer

terminal. The black (negative -) subwoofer terminal must be connected

to the negative (-) ampliﬁer terminal.

To insert the cable end into the spring loaded terminals of the IW SUB

S-100 subwoofer, remove the cable insulation so that approximately

12 mm (½ in) of bare wire is exposed. Press the top of the terminal

down and insert the bare wire into the opening. When the wire is fully in

place with no loose strands exposed, release the terminal. Use of the

subwoofer terminals is illustrated in Diagram 4.

DIAGRAM 4:

SUBWOOFER CONNECTION TERMINALS

The SUB S-100 subwoofer can be mounted in stud (dry wall) and

plasterboard constructed walls with a minimum free depth of 102

mm (4.02 in). The minimum and maximum plasterboard thickness that

can be accommodated by the SUB S-100 subwoofer ﬁxings is 10 mm

(0.4in) and 50 mm (2.0 in) respectively. The SUB S-100 subwoofer

also requires 19mm (0.74 in) free space to the side, top and boom

in order to enable its dogleg clamps to be deployed. Diagram 5

illustrates SUB S-100 installation dimensions.

If SUB S-100 is to be installed in a particularly thick wall, it may be

necessary to dismount its dogleg clamps from their screws then and

replace them. Dogleg clamps make it possible to install SUB S-100 in

a wall up to 70 mm (2.75 in) thick.

The supplied cut-out template can be used initially to visualise

where a SUB S-100 is to be installed. As part of this exercise, use

a wall stud and pipe/cable ﬁnding tool to ensure that the wall space

in which a subwoofer is to be installed is free of obstructions. It is

also important to ensure that the 102 mm (4.02 in) minimum depth

clearance required for SUB S-100 subwoofers is available. If the free

depth available at the installation position is unknown, a test hole can

be drilled and a depth measuring gauge inserted.

DIAGRAM 5:

SUBWOOFER INSTALLATION DIMENSIONS

615 mm

24.2 in

Min.

19 mm

0.75 in

Min.

102 mm

4.02 in

370 mm

14.6 in

Minimum depth

102 mm

4.02 in

Max. 50 mm / 2 in

Min. 10 mm / 0.4 in

Reversed doglegs

Max. 70 mm / 2.8 in

Min. 30 mm / 1,2 in

4.2.2 Wall Aperture

Otros manuales para PHANTOM IW SUB S-100

Tabla de contenidos

Otros manuales de Oradores de Dali

Dali

Dali ZENSOR 1 Manual de usuario

Dali

Dali elegance Manual de usuario

Dali

Dali skyline 1000 Manual de usuario

Dali

Dali ALTECO C-1 Manual de usuario

Dali

Dali MOTIF LCR Manual de usuario

Dali

Dali Euphonia IWS 3 Phantom Guía de referencia rápida

Dali

Dali Euphonia AS 2 Manual de usuario

Dali

Dali Opticon Manual de usuario

Dali

Dali MENTOR SUB Manual de usuario

Dali

Dali PHANTOM H Series Manual de usuario

Dali

Dali Helicon 400 LE Manual de usuario

Dali

Dali IKON 1 Manual de usuario

Dali

Dali CALLISTO Manual de usuario

Dali

Dali RUBICON C Manual de usuario

Dali

Dali PHANTOM S Series Manual de usuario

Dali

Dali Lektor Manual de usuario

Dali

Dali MENUET Manual de usuario

Dali

Dali SUITE Manual de usuario

Dali

Dali FAZON MIKRO Manual de usuario

Dali

Dali MS 4 Manual de usuario

Dali

Dali SUB E-9 F Manual de usuario

Dali

Dali KORE Manual de usuario

Dali

Dali IKON 1 Manual de usuario

Dali

Dali RUBICON Manual de usuario

Manuales populares de Oradores de otras marcas

argon audio

argon audio IE20 Manual de usuario

Denon

Denon SC-N7 Manual de usuario

Gemline

Gemline Ace 3952 Manual de usuario

Focal

Focal ON WALL 300 Manual de instrucciones

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manual de usuario

SoundLogic

SoundLogic BCCS-6/6395 Manual de usuario

Peavey

Peavey DTH 218 Manual de usuario

Avantree

Avantree Pluto Air Manual de usuario

Morel

Morel Integra Series INTEGRA OVATION 4 Manual de usuario

Oppo

Oppo SONICA Manual de usuario

Bose

Bose SoundLink Wireless Music System Manual de usuario

Rocksteady

Rocksteady Stadium Manual de usuario

Bowers & Wilkins

Bowers & Wilkins 4 Manual de usuario

Sonance

Sonance SONOS OUTDOOR Series Manual de usuario

Electro-Voice

Electro-Voice EVID FM4.2 Manual de usuario

Pioneer

Pioneer XW-HTD630 Manual de usuario

Onn

Onn BWA16AA002 Manual de usuario

HP GL313AA - USB Speakers PC Multimedia Manual de usuario