Dacor ACTK27 Manual de usuario
1
PART NAME
DUCT (A)-1
DUCT (A)-2
DUCT (A)-3
DUCT (B)
DUCT (C)
STOPPER
SASH (SIDE)
SASH (U AND L)
CUSHION (A)
CUSHION (B)
SCREW (A)
SCREW (B)
Q'TY
1
1
1
1
1
2
2
2
1
1
10
4
DUCT (A)-1 DUCT (A)-2
DUCT (A)-3 DUCT (B)
STOPPER
DUCT (C)
SASH
(U AND L)
CUSHION (B)
(thick)
CUSHION (A)
(thin)
(FOR ACTK27)
IMPORTANT: This Built-In Kit is designed for use with those Dacor Microwave Ovens specifying ACTK27 or
ACTK30 Built-In Kit on rating label on the front of the oven.
READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING
INSTALLATION!
INSTALLATION INSTRUCTIONS
*For walls other than wood, you may need appropriate screws to install the SASH and STOPPER.
*Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing a kit.
Also remove the turntable tray and turntable support from the oven cavity.
*Because these kits are metal, due caution should be used in handling and installation to avoid the
possibility of injury.
*Two wooden supports must be provided, nominal 2"x 2"x 155/8" (actual 19/16"x19/16"). Contact cement is
needed for attaching. These items can be purchased from a building supply store. Check to see that the
actual height of the wood is 19/16" (4.0 cm).
SASH (SIDE) SCREW (A) SCREW (B)
(FOR ACTK30)
ACTK27
BUILT-IN KIT MODELS ACTK30
followed by letter indicating color S=stainless steel, R=arctic white, B=black
Part No. 900930 Rev. C
ACTK27S/R/B 30S/R/B 11.8.12, 0:40 PM1
2
ACTK27: 25
1
/
4
" (64.1 cm)
or
ACTK30: 28
1
/
4
" (71.8 cm)
18
3
/
8
"±
1
/
8
" (46.7 cm)
2"(A)
2"(A)
24" (61.0 cm)
15
5
/
8
" (39.8 cm)
ACTK30: 11
1
/
2
" (29.2 cm)
or
ACTK27: 10" (25.4 cm)
191/8"
5"
A: nominal 2" (actual 19/16"/4.0 cm)
91/8"(23.2 cm)
(12.2 cm)
(48.6 cm)
STEP 1: CABINET OR WALL OPENING
Provide an opening in the wall or cabinet as indicated in Sketch 1.
The depth should be 24" (61.0 cm). The floor of the opening should be constructed of plywood
strong enough to support the weight of the oven (about 100 lbs.) and should be level for proper
operation of the oven. See page 6 for cabinet/cutout layout dimensions.
NOTE: While the proper functioning of the oven does not require that the opening be enclosed
(with sides, ceiling and rear partition), this may be required by local code, and it is
suggested that the local code be checked for any such requirement.
ELECTRICAL SUPPLY
At the rear of the opening, provide a 3 pronged, polarized, electrical outlet, 115-120 volt A.C., 15
Amp. or larger. This outlet should not be located in the shaded area of Sketch 1.
OVEN SUPPORTS
Cement two 2" x 2" x 155/8" wooden supports as indicated in Sketch 1. Follow contact cement
instructions carefully.
STEP 2: INSTALLATION OF KIT
(a) Insert the edge of DUCT (B) into the hold lip of DUCT (C). Secure together by using a SCREW (A)
provided in the kit.
Remove the existing screw (#1) at upper right rear of the oven and secure DUCT (C) with the
screw (#1) just removed from the oven. Secure DUCT (B) with SCREW (A) through the duct and
into the original screw hole in the oven. See Sketch 2.
2
1
ACTK27S/R/B 30S/R/B 11.8.12, 0:40 PM2
3
(d) Position DUCT (A)-3 on top of the oven
and insert it into DUCT (A)-2. Secure
DUCT (A)-3 using three SCREWS (A)
provided.
Remove the backing paper from the
CUSHION (A). Attach CUSHION (A) along
the flange of DUCT (A)-3.
See Sketch 5.
4
(c) Position DUCT (A)-2 on top of the oven
and insert it into the hold lip of DUCT
(A)-1. Secure DUCT (A)-2 to DUCT (A)-1
using two SCREWS (A) provided.
See Sketch 4.
3
5
CUSHION (A)
(b) Position DUCT (A)-1 on the top of the oven inserting edge of DUCT (BC) into hold lip of DUCT (A)-1.
Then tighten two SCREWS (A), securing DUCT (A)-1 to DUCT (BC). See Sketch 3.
ACTK27S/R/B 30S/R/B 11.8.12, 0:40 PM3
4
STEP 3: INSTALLATION
(a) Place the oven with the right side on a flat surface. Remove the backing paper from the
CUSHION (B). Attach CUSHION (B) beside the screws which fasten the bottom plate. See Sketch
6.
(c) Place the oven adjacent to the wall or cabinet opening. Connect the electrical cord to the
electrical outlet. Then slide the oven into place. Be sure the oven is placed at the center of the
opening. See Sketch 8.
7
(b) Return the oven to the original position. Install a STOPPER at each of the right and left lower
front corners of the oven as indicated in Sketch 7. Remove the existing screws (#3 and #4) in
these locations and use them to secure the STOPPERS to the oven making sure to use the lower
hole in each STOPPER.
6
Bottom plate
CUSHION (B)
Screws
8
#3
#4
STOPPER
(ACTK30)
STOPPER
(ACTK30)
STOPPER
(ACTK27)
STOPPER
(ACTK27)
#4
#3
ACTK27S/R/B 30S/R/B 11.8.12, 0:41 PM4
5
STEP 4: (a) Position one of SASH (U AND L) over SASH (SIDE) on both sides and position above the oven
and against the wall (or cabinet). Make sure that the upper and vertical SASHES line up properly,
vertically and horizontally with the oven to present a neat and symmetrical appearance. Then
loosely secure the upper SASH (U AND L) to the wall (or cabinet) through upper hole in SASH
(SIDE) using one of SCREW (B) provided. Repeat on opposite side. See Sketch 9.
(b) Place the lower one of SASH (U AND L) against the wall (or cabinet) and up against the bottom
of the oven. Secure the lower SASH (U AND L) to the wall (or cabinet) through the lower hole
in SASH (SIDE) using a SCREW (B) provided. Repeat on opposite side and tighten all screws.
See Sketch 9.
9
SCREW (B)
SASH (SIDE)
SASH (U AND L)
SASH (U AND L)
SASH (SIDE)
SCREW (B)
SCREW (B)
SCREW (B)
ACTK27S/R/B 30S/R/B 11.8.12, 0:41 PM5
6
1 5/8" Min.
(4.1 cm)
3/4" Min.
(1.9 cm)
Microwave cutout
Wall oven cutout
Distinctive Appliances Corporation
600 Anton Blvd. Suite 1000
Costa Mesa, CA 92626
For warranty service: (877) 377-3226
Customer Service: (800) 793-0093
Fax: (626) 403-3130
http://www.dacor.com
TINSEB127WRRZ-DA12 Printed in Japan
CABINET CUTOUT DIMENSIONS
OVER WALL OVEN INSTALLATION OVER WARMING DRAWER INSTALLATION
1 3/8"
(3.5 cm)
Min.
Microwave cutout
3/4"
(1.9 cm)
Min.
Warming
drawer cutout
Microwave cutout
Microwave cutout
Wall oven cutout Warming
drawer cutout
ACTK27S/R/B 30S/R/B 11.8.12, 0:41 PM6
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Horno de Dacor
Dacor
Dacor SGM464GG Manual técnico
Dacor
Dacor Discovery MOH230 Manual de usuario
Dacor
Dacor EOR series Manual de usuario
Dacor
Dacor DOB30P977S Series Manual de usuario
Dacor
Dacor MCS130S Instrucciones de instalación
Dacor
Dacor 106733 Manual de usuario
Dacor
Dacor Discovery EO127 Manual de usuario
Dacor
Dacor Dacor Wall Manual de usuario
Dacor
Dacor EORS127 Manual técnico
Dacor
Dacor Renaissance RO130 Manual de usuario
Dacor
Dacor Renaissance EOR Series Manual de usuario
Dacor
Dacor Wall Oven Manual de usuario
Dacor
Dacor Discovery EO Series Manual de usuario
Dacor
Dacor EORS127 Manual de usuario
Dacor
Dacor Renaissance ROV130 Manual de usuario
Dacor
Dacor EPICURE ECD227 Manual de usuario
Dacor
Dacor ECD Series, ECS Series, MCD Se Manual de usuario
Dacor
Dacor EOR series Manual de usuario
Dacor
Dacor Distinctive DTO130 Manual de usuario
Dacor
Dacor Millennia DO130S Manual de usuario
