D-Link DMC-1910 Manual de usuario
Before Your Begin
This Quick Installation Guide gives step-by-step instructions for setting up the D-Link DMC-
1910 1000BASE-TX to 1000BASE-LX Single-Fiber Dual-Wavelength Media Converter Kit. The
model you have purchased may appear slightly different from those shown in the illustrations.
For more detailed information about the media converter, its components, making network
connections and technical specifications, please refer to the User’s Manual included with your
media converter.
Check Your Package Contents
These are the items included with your DMC-1910 purchase:
If any of the above items are missing, please contact your reseller.
©2005 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective
holders. Software and specifications subject to change without notice.
DMC-1910
1000BASE-TX to 1000BASE-LX
Single-Fiber Media Converter Kit
• DMC-1910R and DMC-1910T 1000BASE-TX to
1000BASE-LX Single-Fiber Dual-Wavelength
Media Converter Kit
• User Manual
• Quick Installation Guide
• 7.5V DC, 1.5A Power Adapter Using a powe
r
supply with a
different voltage rating
will damage and void
the warranty for this
product.
2
Setup The DMC-1910 Single Fiber
Media Converter
As with any electric device, you should place the equipment where it will
not be subjected to extreme temperatures, humidity, or electromagnetic
interference. Specifically, the site you select should meet the following
requirements:
A. The ambient temperature should be between 32 and 104 degrees
Fahrenheit (0 to 40 degrees Celsius).
B. The relative humidity should be less than 90 percent, non-condensing.
C. Surrounding electrical devices should not exceed the electromagnetic
field (RFC) standards for IEC 801-3, Level 2 (3V/M) field strength.
D. Make sure that the equipment receives adequate ventilation. Do not
block the ventilation holes on each side of the media converter or the
fan exhaust port on the side or rear of the equipment.
E. The power outlet should be within 1.8 meters of the switch.
Connecting the power
1. This Converter is a plug-and-play device.
2. Connect the supplied AC to DC power adaptor with a power voltage
of 7.5Vdc/1.5Amp to the receptacle on the rear panel of the converter,
and then attach the plug into a standard AC outlet with a voltage
range from 100 to 260 Vac.
Sliding Switch
There is a two pin DIP switch on the module which define as switch 1 and switch 2:
Sw itch 1 : O n -> Forced M ode
O ff -> A u to N e g o tia tio n m o d e
Sw itch 2 : O n - > LLR enable
O ff -> L L R d is a b le
12
on
12
on
3
Switch 1: Fiber mode switch
When the switch was turned to “On”, it means that the fiber was turned to
forced mode, and “Off” for auto-negotiation mode.
Note: Be sure the opposite end is using the same setting (forced or Auto-
negotiation). And when using two converters at the same time, the two
converters MUST set to forced mode.
Switch 2: LLR
When the switch was turned to “On”, it means that the LLR was enabled and
“Off” for disabled.
Note: When using two converters, don’t enable the both devices’ LLR
function at the same time.
Installing in a Chassis
The Converter can be fit into any of the expansion slots on a special designed
chassis.
yFirst, install the converter onto a carrier supplied with the chassis:
Step 1- Unscrew the carrier from the desired expansion slot on the chassis.
Step 2- Remove the screw on the converter as shown below.
Step 3- Fit the converter onto the carrier and use the screw to secure it.
Unscrew and pull out the media converter board
4
LED Indicators
The LED indicators give you instant feedback on status of the converter:
LEDs State Indication
Lights on Power on
Power
(PWR) Lights off Power off
Lights on Linking
Lights
Blinking
Data transmitting and
receiving
Link and Activity
(LINK/ACT)
Lights off Not Linking
5
6
Technical Support
You can find software updates and user documentation on the
D-Link website.
Tech Support for customers within Australia:
D-Link Technical Support over the Telephone:
1300-766-868
Monday to Friday 8:00am to 8:00pm EST
Saturday 9:00am to 1:00pm EST
D-Link Technical Support over the Internet:
http://www.dlink.com.au
email:[email protected]
Tech Support for customers within New Zealand:
D-Link Technical Support over the Telephone:
0800-900-900
Monday to Friday 8:30am to 8:30pm
Saturday 9:00am to 5:00pm
D-Link Technical Support over the Internet:
http://www.dlink.co.nz
email:[email protected]
7
Technical Support
You can find software updates and user documentation on the
D-Link website.
Tech Support for customers within South Eastern
Asia and Korea:
D-Link South Eastern Asia and Korea Technical Support
over the Telephone:
+65-6895-5355
Monday to Friday 9:00am to 12:30pm, 2:00pm-6:00pm
Singapore Time
D-Link Technical Support over the Internet:
email:[email protected]
8
Technical Support
You can find software updates and user documentation on the
D-Link website.
Tech Support for customers within India
D-Link Technical Support over the Telephone:
+91-22-26526741
+91-22-26526696 –ext 161 to 167
Monday to Friday 9:30AM to 7:00PM
D-Link Technical Support over the Internet:
http://ww.dlink.co.in
http://www.dlink.co.in/dlink/drivers/support.asp
ftp://support.dlink.co.in
9
Technical Support
You can find software updates and user documentation on the
D-Link website.
D-Link provides free technical support for customers for the
duration of the warranty period on this product.
Customers can contact D-Link technical support through our
web site or by phone.
Tech Support for customers within the Russia
D-Link Technical Support over the Telephone:
(095) 744-00-99
Monday to Friday 10:00am to 6:30pm
D-Link Technical Support over the Internet
http://www.dlink.ru
10
Technical Support
You can find software updates and user documentation on the D-Link website.
Tech Support for customers within the U.A.E & North Africa:
D-Link Technical Support over the Telephone:
(971) 4-391-6480 (U.A.E)
Sunday to Wednesday 9:00am to 6:00pm GMT+4
Thursday 9:00am to 1:00pm GMT+4
D-Link Middle East & North Africa
D-Link Technical Support over the Internet:
http://support.dlink-me.com
email:[email protected]
Tech Support for customers within Israel:
D-Link Technical Support over the Telephone:
(972) 971-5701
Sunday to Thursday 9:00am to 5:00pm
D-Link Technical Support over the Internet:
http://www.dlink.co.il/forum
Tech Support for customers within Turkey:
D-Link Technical Support over the Telephone:
(+90) 212-289 56 59
Monday to Friday 9:00am to 6:00pm
D-Link Technical Support over the Internet:
http://www.dlink.com.tr
Tech Support for customers within Egypt:
D-Link Technical Support over the Telephone:
(202) 414-4295
Sunday to Thursday 9:00am to 5:00pm
D-Link Technical Support over the Internet:
http://support.dlink-me.com
Tabla de contenidos
Idiomas:
Otros manuales de Convertidor de medios de D-Link
D-Link
D-Link DVS-210-1 Manual de usuario
D-Link
D-Link 1000BASE-TX Manual de usuario
D-Link
D-Link DMC-1910R Manual de usuario
D-Link
D-Link DCF-650WK Manual de usuario
D-Link
D-Link DUB-AV300 Instrucciones de montaje
D-Link
D-Link DMC 1000 - Modular Expansion Base Manual de usuario
D-Link
D-Link DMC-530SC Manual de usuario
D-Link
D-Link 1000BASE-TX Manual de usuario
D-Link
D-Link DMC-700SC - Media Converter - External Manual de usuario
D-Link
D-Link DMC-G01LC Manual de usuario
D-Link
D-Link DMC-805X Manual de usuario
D-Link
D-Link DMC-300SC - Media Converter - External Manual de usuario
D-Link
D-Link DMC-300SC - Media Converter - External Manual de usuario
D-Link
D-Link DFE-855 Manual de usuario
D-Link
D-Link DMC-810SC Manual de usuario
D-Link
D-Link DMC-G01LC Manual de usuario
D-Link
D-Link DMC-805G Manual de usuario
D-Link
D-Link 10/100BASE-TX to 100BASE-FX Media Converter Manual de usuario
D-Link
D-Link DIS-M100G-SW Manual de usuario
D-Link
D-Link DUB-AV300 Manual de usuario
