applied to all contaminated surfaces. Once the liquid sanitizing and deodorizing
has been applied and dried, the Crystalair ozone generator may be placed in the
treated area at a setting of medium to high to eliminate the gaseous odor
absorbed by the walls and furniture etc. Use a strong fan to help force ozone in
to the pores of walls and furniture fabric. Note # Ozone may be set on a low
setting before the technician does anything to deodorize the air in order
to make the environment more comfortable to work in.
SMOKING LOUNGES:
Suggested Size: PRO-360, CA-15, CA-55-2, CA-45-2, PRO-3600-1. Dependent
on the size of room and contamination level.
Crystalair ozone generator should be properly sized for the specific area and
number of possible smokers. Place the ozone generator close to the ceiling and
away from roof exhaust vents. Complement the ozone generator with an
oscillating fan to circulate and mix the ozone and contaminated air together to
speed up the deodorization process. Adjust Crystalair ozone generator so that
there is just a fresh smell in theair..Begin with the ozone generator on low
setting and work your way up slowly. One person at the establishment should be
in charge of adjusting the ozone generator output as the number of smokers
increase or decrease. If ozone is set for 40 smokers and 30 vacate, then the
ozone generator should be adjusted to lower setting, otherwise the air
will become excessively ozonated and possibly cause sore throat or headache. An
ozone monitor controller may be installed to eliminate the need to constantly
adjust the ozone output.
OFFICES AND STORE FRONTS:
Suggested Size: PRO-360, CA-15, CA-55-1, 3400-1 Dependent on the size of
room and contamination level.
The same procedures are used here as in the smoking lounges with one
exception, That usually there is no smoking in offices and store fronts, therefore
a smaller ozone generator may be required.
SMOKE DAMAGE CAUSED BY FIRE :
Suggested Size: PRO-10000, PRO-5000 Dependent on the size of room and
contamination level.
In cases of small fire and smoke damage (e.g.: Grease Fire on stove, Severe
toaster fire, fire place back through, mattress fire, electrical fire etc). With smoke
fumesthe premises shouldbe thoroughly cleaned including the forced air furnace
system before deodorization begins. Place a Crystalair ozone generator on each
level of the building accompanied with a good blower fan to force theozone
throughthe small pores of the walls, carpet, and furniture. This process may take
up to 24 hours for adequate resultsto be achieved. Furniture and mattresses may
need additional treatment by draping a sheet of plastic overthem and placing an
ozone generator underneath for approx. 1-2 hours.
MOLD AND MILDEW:
Suggested Size: PRO-10000, PRO-5000, PRO-360 CA-15 or CA-55-1
Crystalairozone generators reduce or eliminate the ability for the exposed mold,
mildew and fungus to grow. Mold and mildew grow in dark and humid places
where there is a lack of oxygen. In all cases the moisture and humidity in the
walls, floor etc., must be removed to effectively eliminate the problem. Once
moisture is removed, all visible mold and mildew must be removed, then a shock
treatmentprocedure can be preformed lasting for 2-6 hrs. A small ozone
generator can be used to help control continuous mildew problem odors.
AUTOMOBILES TRUCKS BOATS & RVs:
Suggested Size: PRO 360, PRO 36R,PRO 3400-1, PRO-3600-1,
PRO-3600-5
Cigarette smoke and most other organic vapors can be removed from a car,
truck, boat, motor home etc in 30-45 minutes. Place Crystalair ozone generator
in automobile, roll windows down ½ inch, and adjust vent fan on full. Operate
ozone at half to full for 30-45 minutes.Air out auto and smell for lingering odors.
Repeat the procedure if necessary.
CAUTION;
Some auto odors are a result of chemical fragrance deodorizers that are non
ozone depleting and therefore are very difficult to eliminate. Animal dander and
oils embedded under the carpet, and sometimes must be lifted and cleaned with
C20 or equivalent liquid deodorizer before treatment with ozone.
MUSTY BOOKS: Suggested Size: PRO-3600-1, PRO-3600-5
Books must be placed in a room and be opened as wide as possible. Arrange
Crystalair ozone generator and fan to blow over the books. This process should
take no more than one hour. Repeat if necessary.
FURNITURE AND CLOTHING ARTICLES: PRO 3600-1, PRO 3600-5, PRO-5000.
Make or utilize a room of proper size to accommodate all the articles to be
deodorized. Place circulating fans in the room to vigorously blow the ozone
around the room to penetrate the porous materials. Rout a four inch vent hose
from the ozone output to a four inch cut out in the wall of the deodorization
room. This procedure may go on for 1-12 hrs depending on the circumstances.
All procedures are basic. For more intense and extensive procedures, consult
Crystalair or refer to fire and flood manual for comprehensive procedures
RULES OF THUMB:
a.Odors created in a hot environment are embeddeddeeper in the pores of the
materials such as curtains, furniture, wallboard etc. This is due to pores
expanding when hot and closing when cold. A warm environment will always
produce better results than a cold one when deodorizing a gaseous odor.
b.Humidityalways produces or enhances an odor. Existing odors are amplified
to the human nose and odor causing contaminants like bacteria and fungus
flourish in warm and humid environment.
c.Overkill and persistence is the successful way to deodorizing.
d.An additional fan of high output is necessary to in all ozone treatments for
optimum results. The fan will force the ozone into the small pores of the material
to remove the odors absorbed.
e.In all decomposed protein, use a powerful satirizer or bactericide and a
powerful liquid deodorizer like Epolean N-100, N-7C or equivalent.
f.Always use respirator and gloves when handling contaminated materials like
rotten meats or dead animals.
