CRUSSIS ACTIVE Series Manual de usuario
Installation instructions for kick scooters
series ACTIVE, URBAN, ROAD
www.kickscooters-crussis.eu
Step 1.
Step 4.
Step 7.
Step 10.
Step 2.
Step 5.
Step 8.
Step 11.
Step 3.
Step 6.
Step 9.
Step 12.
Make sure that cartoon is not damaged Remove the kick scooter out of the box Wheels are attached to the frame
Remove the tape holding front and rear wheel Put wheels aside Remove the protecting material from frame
Remove the protecting material from handlebars Assemling of the kick scooter is only
in attaching wheels and handlebars
Loosen the screws on the stem
and align so that it faces forward while riding
In this step set the direction of the stem
roughly. You will align it precisely
later with the wheel on
Tighten the screws on the stem with force 4 NM Remove the screws from the front part
of the stem
www.kickscooters-crussis.eu
Step 13. Step 14. Step 15.
Step 16. Step 17. Step 18.
Step 19. Step 20. Step 21.
Step 22. Step 23. Step 24.
At the front and rear break put cable guard
into cable bridge
Tighten quick release.
Mind the direction of the wheel
Check the slope of the handlebars so it will
suit the angle of the brake levers.
We recommend setting at 45 degrees
Stem and front wheel must form a single axis.
Make sure that stem is properly tightened
with force 4 NM
Attach the handlebars
Put back the front part of the stem
and lightly tighten, adjust the angle of
the handlebar and screw it with 4 NM
Put wheels back on
Correct position of the quick release axle
to the fork after tightening
Adjust the boot (gum) Test the brakes If the brake is rubbing the rim adjust the position
of the brake pad. With tightening
the screw distance will increase
We wish you many happy kilometers
on your new
kick scooter CRUSSIS!
Este manual sirve para los siguientes modelos
2
Otros manuales de Scooter de CRUSSIS
