Cree SmartCast FLEX Series Manual de usuario

FLEX Series with Cree SmartCast®Technology

Specification Troffers

Includes: FLX14™, FLX22™ and FLX24™

1 of 3 LPN00438X0001A1_C

INSTALLATION INSTRUCTIONS

INSTRUCTIONS D’INSTALLATION

TO INSTALL:

T- BAR CEILING MOUNTING

STEP 1:

Bring the FLEX troffer up into the

T-Bar grid.

STEP 2:

Locate the luminaire hooks and

bend them out 90 degrees for

installation. See Figure 1.

NOTE: The luminaire hooks ship

bent in and need to be bent out

for installation.

STEP 3:

Then bend the luminaire hooks

against the T-Bar to secure the

luminaire. See Figure 1.

• The FLEX Series of

specification troffers is for non-

insulated ceiling applications

using T-Bar ceiling grid,

drywall grid adaptors, and

suspended mount.

• Designed for use in 120-

277V 50-60 Hz or 347V 60Hz

protected circuit (fuse box,

circuit breaker). Supply wire

sized as per NEC or governing

code(s), 90C rated.

• Make sure to cap off all unused

leads.

FLX14™

FLX22™

FLX24™

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should

always be followed including the following:

READ AND FOLLOW ALL SAFETY

INSTRUCTIONS

1. DANGER- Risk of shock- Disconnect power before installation.

DANGER – Risque de choc – Couper l’alimentation avant l’installation.

2. This luminaire must be installed in accordance with the NEC or your

local electrical code. If you are not familiar with these codes and

requirements, consult a qualied electrician.

Ce produit doit être installé conformément à NEC ou votre code

électrique local. Si vous n’êtes pas familier avec ces codes et ces

exigences, veuillez contacter un électricien qualié.

3. Suitable for damp locations.

Convient aux emplacements humides.

4. Access above ceiling required. Do not install insulation within 3" (76mm) of

any part of the luminaire.

Accès requis au-dessus du plafond. Ne pas mettre l’isolant à moins de 76

mm (3 po) de toute partie du luminaire.

SAVE THESE INSTRUCTIONS FOR

FUTURE REFERENCE

Luminaire Hooks

T-bar

1st:

90° Bend

2nd: Bend

Against T-bar

T-bar

2 of 3 LPN00438X0001A1_C

RF Module

SUSPENDED MOUNTING

STEP 1:

Attach customer supplied cables to the (2) cable

slots on each side of the housing.

See Figure 2 and 3.

STEP 2:

Attach customer supplied cables to mounting

surface using customer supplied hardware.

Ensuring that mounting surface can support the

luminaire.

STEP 3:

Attach the RF Module to the luminaire by clicking it

into place as Shown in Figure 3.

RESET RF MODULE

NOTE: The Blue LED is located behind the CREE

logo on the RF Module. The CREE logo with

illuminate blue when the Blue LED is active.

STEP 1:

Actuate RESET button through the access hole.

Push and hold until LED on RF module begins

blinking rapidly (approximately 6-7 seconds). See

Figure 5.

STEP 2:

Release for 1 sec.

STEP 3:

Press/Hold RESET button for 0.5 sec. Light will turn

off for a few seconds then go to full bright and the

Blue LED on the RF Module should begin a 2 blink

sequence. Figure 4.

CLEANING LENS

STEP 1:

Remove lens and end cap assembly by pulling

straight downward gently. See Figure 5.

STEP 3:

After cleaning is complete insert lens and end cap

assembly back into the luminaire housing. Check

end caps for any visible gap between the end cap

and end panel. If necessary push end cap against

the end panel to eliminate gaps.

Check lens for any visible gap between the lens and

luminaire.

TROUBLESHOOTING:

Out of the box, if the light does not turn on when

power is applied:

• Check Wiring with power off

• If wired correctly, check to see if Blue LED

blinking on the RF Module.

• If Blue LED is blinking, then perform a

RESET

(See RESET RF MODULE section).

• If Blue LED is on solid or off, call Cree

Customer Service.

• If you have done a RESET, and the light is

still off, call Cree Customer Service.

If light is unresponsive, use Cree Configuration Tool

to verify configuration.

Power Supply

Junction Box

Cover

Cable Slots

RF Module

Access Hole, Reset

Button Inside Blue LED

Placement

Lens

3 of 3 LPN00438X0001A1_C

www.lighting.cree.com

See http://lighting.cree.com/warranty for warranty and specifications. Cree®and the Cree Logo are registered trademarks, and

FLX14™, FLX22™ and FLX24™ are trademarks of Cree, Inc. Armstrong®is a registered trademark of AWI Licensing LLC.

FCC NOTICE

CAUTION: Changes or modifications not expressly approved could void your authority to use this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will

be required to correct the interference at his own expense.

CAN ICES-005 (A)/NMB-005 (A)

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux

conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,

même si le brouillage est susceptible d’en compromettre le fonctionnement.

ELECTRICAL CONNECTIONS- 120-277V INPUT

STEP 1:

Make the following Electrical Connections::

a. For 120/277V connect the black fixture lead to the voltage supply

or Hot 1 (for 208/240V wiring).

b. For 120/277V connect the white fixture lead to the neutral supply

or Hot 2 (for 208/240V wiring).

c. Connect the green or green/yellow ground lead to ground.

LINE

OR HOT 1

GREEN

LINE-BLACK

GROUND-GREEN

NEUTRAL-WHITE

NEUTRAL

OR HOT 2

SUPPLY WIRING

LUMINAIRE

ELECTRICAL CONNECTIONS- 347V INPUT

STEP 1:

Make the following Electrical Connections::

a. For 347V connect the red fixture lead to the voltage supply.

b. For 347V connect the white fixture lead to the neutral supply.

c. Connect the green or green/yellow ground lead to ground.

LINE

OR HOT 1

GREEN

LINE-RED

GROUND-GREEN

NEUTRAL-WHITE

NEUTRAL

OR HOT 2

SUPPLY WIRING

LUMINAIRE

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Equipo de iluminación de Cree

Cree

Cree ESSENTIA ESA-ADR-414 Manual de usuario

Cree

Cree LQ6 Series Manual de usuario

Cree

Cree XLamp MH Series Manual de usuario

Cree

Cree ZR Series Manual de usuario

Cree

Cree ESSENTIA AE Series Manual de usuario

Cree

Cree OSQ Series Manual de usuario

Cree

Cree CXB Series Manual de usuario

Cree

Cree FLEX Series Manual de usuario

Cree

Cree TDS Series Manual de usuario

Cree

Cree CR150-650L Manual de usuario

Cree

Cree TRDL6 Series Manual de usuario

Cree

Cree OSQ HO Series Manual de usuario

Cree

Cree CR Series Manual de usuario

Cree

Cree OSQ Series Manual de usuario

Cree

Cree EB14SMK Manual de usuario

Cree

Cree LXB Series Manual de usuario

Cree

Cree C-AR Series Manual de usuario

Cree

Cree Link With SmartCast Technology Manual de usuario

Cree

Cree LS8 Manual de usuario

Cree

Cree XLamp ML Family LEDs Manual de usuario

Cree

Cree OSQ Series Manual de usuario

Cree

Cree ESSENTIA S-CT-FB-25L Manual de usuario

Cree

Cree OSQ Series Manual de usuario

Cree

Cree Essentia S-DL4-EB Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario