8
Power: 5V +/-10% DC power supply 1000mA
Ethernet: Unique MAC Address
RJ45 Connection
10/100 MBit/s
Serial: 9-way D-type RS232 socket for serial connection to a PC in standalone mode.
USB: Mini USB Cable for programming firmware.
RF: 2400MHz antenna for RF Wrench communication that can be placed in different
orientations.
Low power 0dBm and uses worldwide ISM band (2400MHz).
Transducer:WrenchStar Multi. Maximum number 5.
Number of Jobs: Stores 256 different Jobs, any of which can be selected and downloaded to
WrenchStar Multi.
Offline mode: Downloads a Job to a WrenchStar Multi and uploads results when the WrenchStar
Multi is within range.
Polls WrenchStar Multi to see if the results are available.
Pairing: Can be easily Paired with WrenchStar Multi using a single push Button operation or
via web Page.
Construction: Aluminium enclosure
Dimensions: 217mm x 120mm x 56mm
Weight: 760g
Mounting: Flange for mounting to a surface with 4 bolts. (See pg. 6)
LEDs: Power Status
Host communication (informs whether the communications is good, absent
incorrect).
Wrench communication (informs whether the WrenchStar Multi is Paired, in range
or has a Job loaded).
TDC 9TCI Data Collector status – Connected or disconnected.
Operation: Accepts Open Protocol commands via Ethernet to select a Job and use with the
Wrench (tool).
Has Web Status Page that allows Ethernet properties, RF properties, logging of
messages, and Wrench Status to be monitored.
Wrench Status Web Page mirrors the LED Status on TCI and also shows last Torque
and Angle reading from Wrench plus its Torque Status (LO, OK and HI).
Standalone mode – Jobs can be selected and results posted to PC or Web Page.
Setup: Via Web Page.
Time / Date: Real Time Clock (read and write)
(TCI MULTI) SPECIFICATION
