Craig CHT985 Manual de usuario

29 INCH STEREO

SOUND BAR SYSTEM

with Digital Optical Input and

Bluetooth®Wireless Technology

Model: CHT985

PLEASE READ BEFORE OPERATING THIS EQUIPMENT.

Owner's Manual

29 INCH STEREO

SOUND BAR SYSTEM

with Digital Optical Input and

Bluetooth®Wireless Technology

Size: 148.5(W) x 210(H)mm (A5)

WARNING:Changes or modifications to this unit

not expressly approved by the party responsible

for compliance could void the user’s authority to

operate the equipment.

NOTE: This equipment has been tested and

found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide

reasonable protection against harmful interference

in a residential installation. This equipment

generates, uses, and can radiate radio frequency

energy and, if not installed and used in

accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference

will not occur in a particular installation. If this

equipment does cause harmful interference to

radio or television reception, which can be

determined by turning the equipment off and on,

the user is encouraged to try to correct the

interference by one or more of the following

measures:

•Reorient or relocate the receiving antenna.

Increase the separation between the

equipment and receiver.

Connect the equipment into an outlet on a

circuit different from that to which the receiver

is connected.

Consult the dealer or an experienced radio/TV

technician for help.

•

FCC Warnings

FCC NOTICE:

To assure continued compliance, follow the attached

installation instructions and use only shielded cables

when connecting to other devices. Modifications not

authorized by the manufacturer may void user’s

authority to operate this device.

IMPORTANT SAFETY INSTRUCTIONS

This equipment should be installed and operated with

minimum distance 20 cm between the radiator and your

body.

IMPORTANT SAFETY INSTRUCTIONS

NOTES:

To the DC IN jack on the rear of the unit.

1. Placing on the table

2. Mounting the Speaker Bar onto a wall

Distance Between Two Brackets

1. Insert the small plug from the supplied AC/DC Adapter to the DC IN Jack on the rear of unit.

2. Connect the AC/DC Adapter to the wall outlet having AC 100-240V~; 50/60Hz.

To the wall outlet

2-3 inches



This AC/DC Adaptor intended to be correctly orientated in a vertical or floor mount position.

To save energy, unplug the AC/DC Adaptor from the wall outlet if you may not use the unit

for an extended period of time.

POWER SOURCE

INSTALLATION

DC IN

DC 5.8V,1.5A

The Red

Standby Indicator on the front of unit will illuminate.

When placing the Sound Bar on an entertainment center, bookshelf, or any type of enclosed

space, be sure to allow at least 2-3 inches of space around the Sound Bar for ventilation. If the

Sound Bar is enclosed in a tight space, without ventilation, heat generated from the Sound Bar

could produce a potential heat hazard.

19.3 inches

We recommend having this unit professionally mounted. By using wall mounting accessories

(not included), the unit can be mounted onto a wall.

OPTIC AL IN

AU N

L R

DC IN

DC 5.8V,1 .5A

X 2 I

X 1 I

Mounting to a wall

2.1 Mountingto a wooden wall

2.2 Mountingto a brick wall

(1) (2)

19.3 inches

A. Mark the position of the mounting screws on the wall using a pencil.

B. Drill the supplied mounting screws directly into the marks that you have made on the wall

and leave approx. 0.3 inches length to hook the sound bar.

C. Put the sound bar onto the mounting screws. Make sure they are firm and stable.

A. Mark the position of the mounting screws on the wall using a pencil.

E. Put the sound bar onto the mounting screws. Make sure they are firm and stable.

B. Drill 2 holes on wall with a powerful electric drill.

C. Insert the supplied plastic inserts into the holes by hammer (not included).

D. Secure the supplied mounting screws into the plastic insert and leave approx. 0.3 inch

length to hook the sound bar.

Front View

RearView

LOCATION OF CONTROLS

1231

4567

8910 11

Top View

5. AUX IN 2 Jack

7. DC IN Jack

8. STANDBY/SOURCE Button

9. (Play/Pause) Button

10. (Volume Down/Skip Backward) Button

11. (Volume Up/Skip Forward) Button

6. AUX IN 1 Jacks

4. OPTICAL IN Jack

3. Indicators

2. Remote Sensor

1. Speakers

OPTICAL IN

AU N

AU N 1

L R

DC IN

DC 5.8V,1.5A

X I

X 2 I

Remove and discard the insulation film as illustrated on the right.

LOCATION OF CONTROLS - REMOTE CONTROL

BUTTON CELL INSTALLATION - REMOTE CONTROL

86. (Mute) Button

RELEASE

PUS H

OPE N

R202 5

Fig.1 Fig.2 Fig.3

1. (Standby On/Off) Button

2. (Play/Pause) Button

3. (Skip Backward) Button

4. SOURCE Button

5. VOL- (Volume Down) Button

7. (Skip Forward) Button

8. VOL+ (Volume Up) Button

First Time Use:

If the button cell is drained, replace it by a new one as below:

1. Push and slide out the battery holder as Fig.1 below.

2. Replace the button cell with a new CR2025 button cell as the polarity

markings on the rear of the Remote Control as Fig.2 below.

3. Close the battery hold as Fig.3 below.

30 °

Approx. 16 feet

EFFECTIVE DISTANCE OF REMOTE TRANSMITTER

When there is an obstacle between the unit and the transmitter, the unit may not operate.

Follow these Battery Precaution when using a battery in this device:

1. Use only the size and type of battery specified.

6. Do not dispose of battery in fire. Battery may explodes or leak.

7. Clean the battery contacts and also those of the device prior to battery installation.

BATTERY PRECAUTIONS:

2. Be sure to follow the correct polarity when installing the battery as indicated in the battery

compartment. A reversed battery may cause damage to the device.

3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries

with fresh ones.

4. If the batteries in the device are consumed or the device is not to be used for a long period of

time, remove the batteries to prevent damage or injury from possible battery leakage.

5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.

(Follow battery manufacturer’s instructions.)

8. This product contains a coin/button cell battery. If the coin/button cell battery is

swallowed, it can cause severe internal burn in just 2 hours and can lead to death.

Keep new and used batteries away from children. If the battery compartment does not close

securely, stop using the product and keep it away from children.

If you think batteries might have been swallowed or placed inside any part of the body, seek

immediate medical attention.

NOTES:

When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines

on the REMOTE SENSOR of the unit, the operation of the remote may be unstable.

OPERATIONS

4. During playback:

GENERAL OPERATION:

1. Connected the unit to AC power as previously instructed. The Red Standby Indicator on the

front of unit will illuminate.

2. Press and hold the STANDBY/SOURCE Button on the top of unit approximately 2 seconds or

press the Button on the Remote Control to power on the unit from Standby mode.

3. Press and release the STANDBY/SOURCE Button on the top of unit or press the SOURCE

of unit will turn the color with your selection (see list below):

BT (Bluetooth) Blue

Optical In Indigo (Blue + Green Mixed)

AUX IN 1 Colorful (Red + Blue + Green Mixed)

AUX IN 2 Purple (Red + Blue Mixed)

A. Press and release the or buttons on the unit or press the VOL + or - buttons on the

Remote Control repeatedly to adjust volume level as desired.

B. Press the (Mute) Button on the Remote Control to mute the sound temporary, press again

to turn it back.

5. When finished listening, press and hold the STANDBY/SOURCE Button on the top of unit

approximately 2 seconds or press the Button on the Remote Control to turn the unit to

Standby mode.

Playback Mode: Color of the INDICATOR on front panel

Button on the Remote Control repeatedly to switch to desired playback mode. The color of the

indicator on the front

6. If you will not use the unit for an extended period of time, unplug the AC/DC Adaptor from wall

outlet.

First time use or re-pairing the unit to a new BT Device, pair as follows:

3. If pairing is complete you may now play music with your external BT Device.

4. During playback:

If while pairing you are asked for a code please try "0000" or "1234".

1. Power on the external BT Device and enter to BT mode.

4. After pairing is complete you may now play music with your external BT Device.

BT MODE:

BT (Bluetooth) pairing:

Notes:

Normal operation after pairing:

1. Power on the unit and enter to BT mode as previously instructed. The color of the indicator on

the front of unit will turn to Blue and blink.

2. Power on the external BT Device and enter to BT searching mode. Start pairing following the

on screen instructions from the external BT Device. After paired, the Blue indicator will stop

blinking.

Press and hold the or buttons on the unit or press the or buttons on Remote

Control repeatedly to skip tracks.

When the external BT Device searched the unit, our model number "CHT985" will appear on

the display of external BT Device.

2. Power on the unit and enter to BT mode as previously instructed. The color of the indicator on

the front of unit will turn to Blue and blink.

3. Wait a few seconds until the unit is automatically paired to the external BT Device. The blue

indicator will stop blinking.

Press the Button on the unit or Remote Control to pause, press again to resume normal

playback.

Tabla de contenidos

Otros manuales de Sistema de altavoces de Craig

Craig

Craig CHT823DG Manual de usuario

Craig

Craig CHT756 Manual de usuario

Craig

Craig CHT940DO Manual de usuario

Craig

Craig CHT940 Series Manual de usuario

Craig

Craig CHT912 Manual de usuario

Craig

Craig CHT914c Manual de usuario

Craig

Craig TA-304B Manual de usuario

Craig

Craig CHT939 Manual de usuario

Craig

Craig CHT915 Manual de usuario

Craig

Craig CHT9810 Manual de usuario

Craig

Craig CHT973 Manual de usuario

Craig

Craig CHT988 Manual de usuario

Craig

Craig CHT921 Manual de usuario

Craig

Craig CHT884 Manual de usuario

Craig

Craig CHT820DG Manual de usuario

Manuales populares de Sistema de altavoces de otras marcas

JVC

JVC CA-MXK5R Manual de usuario

LG NB4532B Manual de usuario

JVC

JVC CA-FSH100 Manual de usuario

5Core

5Core Pro Series Manual de usuario

EAW

EAW MQV1394e Manual de usuario

Lynx

Lynx GXR-LA10A Manual de usuario

iLive

iLive ITB066B Manual de usuario

RDX

RDX QuickStation 4 Manual de usuario

Electro-Voice

Electro-Voice S-122 Manual de usuario

Sven

Sven SPS-619 GOLD Manual de usuario

Pioneer

Pioneer CS-7070 Manual de usuario

EAW

EAW UB82e Manual de usuario

Sondpex

Sondpex Active Speaker System and Digital Music... Manual de usuario

JVC

JVC NX-PN7 Manual de usuario

Marshall Amplification

Marshall Amplification AR-DM61-BT Manual de usuario

Yamaha

Yamaha NX-A01 - Speaker Sys Manual de usuario

SE Audiotechnik

SE Audiotechnik I-LINE Manual de usuario

Gemini

Gemini WRX-843 Series Manual de usuario