3.INSTRUCTIONS FOR USE
3.1 INSTALLING THE VACUUM GRIPPER
In order to ensure flawless installation and operation, the following rules must also be observed:
. Vacuum grippers must be carefully removed from their packaging.
. Vacuum grippers must be protected against any and all damage.
. During installation and maintenance work, the vacuum generator must be de-energized and secured against
any unauthorized activation.
. Any attempt to alter the vacuum gripper is strictly prohibited.
. The area surrounding the vacuum gripper and the location where it is used must be kept clean (no outdoor
use).
. Only the fittings/connectors provided may be used.
. During installation, only flexible tubes and tubes that are suitable for the specific operating material may be
used (tubes that come loose or electrical connection lines constitute a major safety hazard—including risk of
death!).
. Conductive and live cable lines must be insulated, of an adequate size, and properly installed.
. Pneumatic and electric lines must be connected to the component in a stable and safe manner.
. Ensure that any physical contact with electric parts is prevented (protect electrical contacts).
. Only available fastening means described in this document maybe used and tightening torques must be used
accordingly.
. The possibility of power or pneumatic supply interruption must be taken into consideration to ensure people
and systems are protected at all times.
. Emergency stops should be accounted for when designing the system.
3.2 COMMISSIONING AND DECOMMISSIONING THE VACUUM GRIPPER
Commissioning:
. Ensure the flexible tubes for compressed air and power supply are connected correctly
using the appropriate connectors.
Decommissioning (prior to any disassembly or maintenance work)
. Ensure the gripper is not holding any objects to be handled (load may drop).
3.3 OPERATING THE VACUUM GRIPPER
Intended use
The vacuum gripper is solely intended for use in automated applications and in secure areas.
Use cases depend on the gripping interfaces used => see chapter 6
Unintended use
The vacuum gripper may not be used for the following:
- Manual applications
- Uses other than those established by the manufacturer or specified in this manual
- In direct contact with hazardous materials (molten masses, radioactive products), water, steam, or
in environments where dripping or splashing water, oil, etc. may occur
- In explosive, acidic, alkaline, or saline atmospheres
- In environments subject to strong vibrations and/or shocks
