Courtyard CY460 Manual de usuario
CY460 & CY460D
Sync Pulse & Test Pattern Generator
28 February 2017
CY460_Operational_Manual_405 Page 2 of 218
The information is this document is subject to change without notice and should not be
construed as a commitment by Courtyard Electronics Limited. Courtyard Electronics
Limited shall not be liable for errors contained herein or for incidental consequential damages
in connection with the furnishing, performance, or use of this material.
This document contains proprietary information which is protected by copyright. All rights
are reserved. No part of this document may be photocopied, reproduced or translated into
another language without the written prior consent of Courtyard Electronics Limited.
© Courtyard Electronics Ltd 2012, 2013, 2014, 2015, 2016, 2017
Courtyard Electronics Limited
8 Campbell Court, Bramley, Hampshire RG26 5EG. England.
Telephone : +44 (0)1252 712030.
http : //www.courtyard.co.uk e-mail : [email protected]
28 February 2017
CY460_Operational_Manual_405 Page 3 of 218
This Manual
Scope
This manual provides all the information you will need to effectively operate and maintain your
CY460 Sync Pulse & Test Pattern Generator. It describes installation, operation, maintenance and
troubleshooting.
Locating Information
Following this introduction is a Table of Contents that indicates on which page in this manual a topic
can be found.
Organisation
The manual is divided into two main parts: Installation & Planning and Operation & Maintenance.
The first part describes the product from a technical standpoint and provides details and procedures
regarding the installation of the product. The second part describes how to use and look after the
product, and also provides important specifications and connectivity information.
28 February 2017
CY460_Operational_Manual_405 Page 4 of 218
Table of Contents
General Safety Summary ........................................................................................................ 11
Symbols and Terms................................................................................................................ 11
Avoiding Fire or Personal Injury ......................................................................................... 13
Environmental Considerations ............................................................................................... 16
RoHS & WEEE ...................................................................................................................... 16
Restriction of Hazardous Substances (RoHS) ..................................................................... 16
Waste Electrical and Electronic Equipment (WEEE) ........................................................ 16
Equipment Recycling ............................................................................................................. 16
Preface ..................................................................................................................................... 18
About This Manual ................................................................................................................ 18
Related Documents ................................................................................................................ 18
1.0 Getting Started............................................................................................................ 19
1.1 Product Description .................................................................................................. 19
1.2 Functional Diagrams ................................................................................................ 21
1.3 Initial Product Inspection ........................................................................................ 25
1.4 Installation and Planning ......................................................................................... 26
Rack Mount Installation ........................................................................................................ 26
Operating Environment – Requirements ............................................................................. 26
Connecting Power .................................................................................................................. 27
AC Power Requirement ......................................................................................................... 27
Connecting the Power Cable ................................................................................................. 27
1.5 Repackaging for Shipment ....................................................................................... 28
1.6 Functional Check Procedure ................................................................................... 29
Required Equipment.............................................................................................................. 29
Functional Check Procedure and First Time Operation .................................................... 29
Initial Power-Up ..................................................................................................................... 29
Initial Configuration .............................................................................................................. 30
Operational Configuration .................................................................................................... 37
1.7 Standard Accessories ................................................................................................ 38
Documents and CD-ROM ..................................................................................................... 38
Power Cords ........................................................................................................................... 39
1.8 Optional Accessories: ............................................................................................... 40
Documents .............................................................................................................................. 40
1.9 Options:...................................................................................................................... 40
Rack mount............................................................................................................................. 40
Additional Features................................................................................................................ 40
2.0 Operating Basics ........................................................................................................ 41
2.1 Front Panel Buttons and Indicators ........................................................................ 41
CY460 Sync Pulse and Test Pattern Generator – Front Panel Controls and Indicators . 41
2.2 Rear Panel Connectors ............................................................................................. 43
CY460 Sync Pulse and Test Pattern Generator – Rear Panel Connectors ....................... 43
2.3 Operating Basics ....................................................................................................... 46
2.4 Software Field Upgrade ............................................................................................ 47
3.0 Menu System .............................................................................................................. 50
3.1 Menu Screens and Maps .......................................................................................... 50
3.2 Audio Menu ............................................................................................................... 53
3.3 Video Menu ............................................................................................................... 58
3.4 Timecode Menu ......................................................................................................... 76
3.5 Genlock Menu ......................................................................................................... 107
3.6 System Setup Menu ................................................................................................ 114
Temperature Report ............................................................................................................ 114
Event Report ......................................................................................................................... 116
System Report ...................................................................................................................... 118
28 February 2017
CY460_Operational_Manual_405 Page 5 of 218
GPS Report ........................................................................................................................... 122
Configuration Menu ............................................................................................................ 124
Network Menu ...................................................................................................................... 128
NTP Menu............................................................................................................................. 130
PTP Menu ............................................................................................................................. 130
DashBoard Menu ................................................................................................................. 134
Backup Device Menu ........................................................................................................... 136
SNMP Menu ......................................................................................................................... 130
Option Enable Menu ............................................................................................................ 138
Calibration Menu ................................................................................................................. 140
4.0 Troubleshooting ....................................................................................................... 144
5.0 Warranty ................................................................................................................... 146
Appendix A : Specifications ............................................................................................ 147
Appendix B : Connector Pinouts..................................................................................... 167
Appendix D : Rack Mounting .......................................................................................... 174
Minimum Tool and Equipment List .................................................................................. 174
Installation Instructions ...................................................................................................... 175
Appendix E : User Maintenance ..................................................................................... 176
General Care ........................................................................................................................ 176
Exterior Cleaning ................................................................................................................. 176
Preventive Maintenance ...................................................................................................... 177
Servicing ............................................................................................................................... 177
Service Safety - Summary ................................................................................................... 177
Important Information ........................................................................................................ 178
Appendix F : Circuit Description .................................................................................... 179
Circuit Description............................................................................................................... 179
Power Supply section ........................................................................................................... 179
CPU section ........................................................................................................................... 179
Clock Oscillator section ....................................................................................................... 180
Spartan section ..................................................................................................................... 180
SDI Video Output section .................................................................................................... 181
Analog Video Output section .............................................................................................. 181
Genlock Video Input section ............................................................................................... 181
Appendix G : Characters Available For Use In Idents .................................................. 183
Appendix H : DC Power Option .................................................................................. 19494
Redundant power ................................................................................................................. 194
Appendix I : List of Test Patterns .................................................................................. 195
Appendix J : Connecting to DashBoard ........................................................................ 201
General Usage ...................................................................................................................... 201
Connecting to DashBoard ................................................................................................... 203
Appendix X : NTP Option ............................................................................................... 206
Introduction .......................................................................................................................... 206
Installation ............................................................................................................................ 206
Connections .......................................................................................................................... 206
Background Information..................................................................................................... 207
Appendix Y : GPS Installation ........................................................................................ 211
Introduction .......................................................................................................................... 211
Components .......................................................................................................................... 211
Coaxial Cable lengths .......................................................................................................... 212
Installation ............................................................................................................................ 212
Antenna ................................................................................................................................. 212
Coaxial Cable ....................................................................................................................... 212
Background Information..................................................................................................... 213
28 February 2017
CY460_Operational_Manual_405 Page 6 of 218
28 February 2017
CY460_Operational_Manual_405 Page 7 of 218
Contents
This Manual
Scope
Locating Information
Organisation
Table of Contents
Installation and Planning
General Safety Summary
Avoiding Fire or Personal Injury
Symbols and Terms
Environmental Considerations
RoHS & WEEE
Restriction of Hazardous Substances (RoHS)
Waste Electrical and Electronic Equipment (WEEE)
Equipment Recycling
Preface
About This Manual
Related Documents
1.0 Getting Started
1.1 Product Description
Key Features
1.2 Functional Diagrams
1.3 Initial Product Inspection
1.4 Installation and Planning
Rack Mount Installation
Operating Environment – Requirements
Connecting Power
AC Power Requirement
Connecting the Power Cable
1.5 Repackaging for Shipment
1.6 Functional Check Procedure
Required Equipment
Functional Check Procedure and First Time Operation
Initial Power Up
Initial Configuration
Operational Configuration
1.7 Standard Accessories
Documents and CDROM
Power Cords
1.8 Optional Accessories
Documents
1.9 Options
Rack Mount
Additional Features
Operation and Maintenance
2.0 Operating Basics
2.1 Front Panel Buttons and Indicators
2.2 Rear Panel Connectors
28 February 2017
CY460_Operational_Manual_405 Page 8 of 218
2.3 Operating Basics
2.4 Updating Software
3.0 Menu System
3.1 Menu Screens and Maps
3.2 Audio Menu
3.3 Video Menu
3.4 Timecode Menu
3.5 Genlock Menu
3.6 System Setup Menu
4.0 Troubleshooting
5.0 Warranty
Appendices
Appendix A Specifications
Appendix B Connector Pinout Data
Appendix C
Appendix D Rack Mounting
Minimum Tool and Equipment List
Installation Instructions
Appendix E User Maintenance
General Care
Exterior Cleaning
Preventative Maintenance
Servicing
Service Safety – Summary
Important Information
Appendix F Circuit Description
Power Supply section
CPU section
Clock Oscillator section
Spartan section
SDI Video Output section
Analogue Video Output section
Genlock Video Input section
Appendix G Characters available for use in Idents
Appendix H DC Power Option
Redundant Power
Appendix I List of Test Patterns
Appendix J Connecting to DashBoard
General Usage
Connecting to DashBoard
Appendix X NTP Option
Introduction
Installation
Connections
Background Information
Appendix Y GPS Installation
Introduction
Components
Installation
Antenna
Coaxial Cable
Background Information
28 February 2017
CY460_Operational_Manual_405 Page 9 of 218
List of Figures
Figure 1.1 Courtyard WEEE Flow Chart
Figure 1.2a CY460 SPG – Inputs and Audio Outputs
Figure 1.2b CY460 SPG – SDI Pattern and Black Outputs
Figure 1.2c CY460 SPG – Composite Pattern & Tri-Sync/Composite Black Outputs
Figure 1.2d CY460 SPG – TimeCode
Figure 1.2e CY460 SPG – Module Interconnect
Figure 2.1 CY460 Sync Pulse and Test Pattern Generator – Front Panel (Single Supply
option)
Figure 2.2 CY460 Sync Pulse and Test Pattern Generator – Rear Panel
Figure 2.3 CY460 Sync Pulse and Test Pattern Generator – Rear Panel (mechanical)
Figure 3.1 CY460 SPG – Menu Map (diagrammatic)
Figure 3.2 CY460 SPG – Setting Time and Date Parameters
Figure 3.3 CY460 SPG – Genlocking to External Video Reference
Figure B.1 Molex Microclasp Connector Pinouts
Figure X.1 NTP Client Flowchart
Figure X.2 NTP Time Stratum Determination
Figure Y.1 Phasing to GPS Flowchart
List of Pictures
Picture 3.1 CY460 SPG – Time Screen
Picture 3.2 CY460 SPG – Logo Screen
Picture 3.3 CY460 SPG – Menu Map (pictorial)
Picture A.1 CY460 SPG – 270Mbps Eye and Jitter
Picture A.2 CY460 SPG – 1.5Gbps Eye and Jitter
Picture A.3 CY460 SPG – 3Gbps Eye and Jitter
Picture B.1 Molex Micro-Clasp Breakout Cable Assemblies
Picture Y.1 GPS Antenna
List of Tables
Table 1.1 CY460 SPG – AC line power requirement
Table 1.2 Power Cord Identification
Section 3.4 Timecode Menu
Leap Seconds in recent years
ISO 3166-1 Country Code list
ISO 3166-2 State Code list – Australia
ISO 3166-2 State Code list – Canada
ISO 3166-2 State Code list – China
ISO 3166-2 State Code list – Russia
ISO 3166-2 State Code list – USA
Table A.1 Video Reference Inputs
Table A.2 Frequency Reference Inputs
Table A.3 GPS Receiver Antenna Input
28 February 2017
CY460_Operational_Manual_405 Page 10 of 218
Table A.4 Frequency Reference Outputs
Table A.5 1Hz Frequency Reference Output
Table A.6 Analog Video Outputs
Table A.7 Serial Digital Interface
Table A.8 AES/EBU Audio Unbalanced Outputs
Table A.9 AES/EBU Audio Balanced Outputs
Table A.10 LTC Outputs
Table A.11 Analog Audio Outputs
Table A.12 Programmable Pulse Unbalanced Outputs
Table A.13 GPI (General Purpose Interface)
Table A.14 RS232 Interface
Table A.15 ONAIR Interface – for use with CY465 Changeover Unit
Table A.21 Ethernet Interface
Table A.22 SNMP Error Report
Table A.31 AC Power Source
Table A.32 Clearance
Table A.33 Mechanical characteristics
Table A.34 Environment characteristics
Table A.35 Certifications and Compliances
Table B.1 BALANCED Connector Pinout.
Table B.2 GPI/RS232 Connector Pinout
Table D.1 Tools required for Rack Mount installation
Table X.1 NTP – Required Time Corrections
Table Y.1 GPS – Required Time Corrections
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
