Cornelius Pre-Mix Dispenser Universal C-750 Manual de usuario

November 13, 2002

185211001

IMI Cornelius Inc, 1989–2002

Revision:A

IMI CORNELIUS INC.

One Cornelius Place

Anoka. MN 55303-6234

Telephone (800) 238–3600

Facsimile (763) 422–3246

WATER TANK SEAL KIT (P/N 308979000)

UNIVERSAL C-750 PRE-MIX DISPENSER

These Instructions outline installation of the Water Tank Seal Kit (P/N 308979000) on the Universal C-750

Pre-Mix Dispenser.

DISPENSER

INSULATED

REFRIGERATION

LINE

NO TAG

2185211001

NOTE: Only qualified personnel should install this kit.

1. Unpack loose–shipped parts. Make sure all parts are present and in good condition.

Table 1. Loose-Shipped Parts

Item

No. Part No. Name Qty.

1 200468012 Sheet Metal Screw, Phil Truss Hd, No. 8 by 3/4-in. 12

2 308981044 Front Cover Plate 1

3 308982044 Back Cover Plate 1

4 313093000 Plug, 2-in. 1

5 172127000 Plug 1

6 960265000 Permagum Sealer,12-in. long 1

8 960115000 Rubatex Insulation,1/8 by 1/2-in. (78-in. long) 1

INSTALLING WATER TANK SEAL KIT

IMPORTANT: This kit is intended to seal the water tank to prevent leakage from splashing water when

moving or transporting the Dispenser. IT IS NOT INTENDED THAT THE DISPENSER MAY BE LAID ON

IT’S SIDE WHEN WATER TANK IS FULL OF WATER.

1. If Dispenser is in operation, place power switch on back of Dispenser in ‘‘OFF’’ position.

2. Remove four screws securing Dispenser top cover, then lift cover straight up and off.

NOTE: Front of Dispenser is the side facing the dispensing valves.

3. Place RUBATEX INSULATION (item NO TAG) all the way around outer edges of FRONT COVER PLATE

(item 2) and BACK COVER PLATE (item 3) as shown in illustration. FILL ANY GAPS AT BUTT EDGES

OF RUBATEX INSULATION WITH SMALL PIECES OF PERMAGUM SEALER (item 6).

4. Place FRONT COVER PLATE (item 2) in position on top of water tank as shown in illustration. IT MAY BE

NECESSARY TO VERY CAREFULLY REFORM OR REPOSITION INSULATED REFRIGERATION LINE

ANGLE TO FIT INTO CUTOUT AREA IN CORNER OF FRONT COVER PLATE.

5. Secure back side of front cover plate to agitator motor support plate with four THREAD CUTTING

SCREWS (item NO TAG).

6. Secure rest of front cover plate to plastic motor tank rim with six SHEET METAL SCREWS (item 1). DO

NOT OVERTIGHTEN SCREWS INTO PLASTIC.

7. Place BACK COVER PLATE (item 3) in position on top of water tank as shown in illustration.

8. Secure front side of back cover plate to agitator motor support plate with four THREAD CUTTING

SCREWS (item NO TAG).

9. Secure rest of back cover plate to plastic water tank rim with five SHEET METAL SCREWS (item 1). DO

NOT OVERTIGHTEN SCREWS INTO PLASTIC.

10. Place PLUG (item 4) in agitator motor plate water fill hole.

1852110013

11. If installing kit on a four-flavor Dispenser, install PLUG (item 5) in 1/2-inch hole in top of agitator motor

plate.

12. Fill area between insulated refrigeration line and cutout area in front cover plate with PERMAGUM SEAL-

ER (item 6). Also, overlap front cover plate and insulated refrigeration line with permagum sealer to prevent

water leak.

13. If new Dispenser installation, refer to manual provided with Dispenser and complete installation as

instructed.

14. Install Dispenser top cover and secure with four screws.

15. If Dispenser was in operation before start of Kit installation, place power switch in ‘‘ON’’ position.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorios de Cornelius

Cornelius

Cornelius Energize 2 HC Manual de usuario

Cornelius

Cornelius Duette 3 Manual de usuario

Cornelius

Cornelius Triton HC Series Manual de instrucciones

Cornelius

Cornelius P/N 631500074 Manual de usuario

Cornelius

Cornelius Energize Series Manual

Cornelius

Cornelius Triton 200 HC Manual de instrucciones

Cornelius

Cornelius Remcor 2849949020 Manual de usuario

Cornelius

Cornelius 0 Manual de usuario

Cornelius

Cornelius Universal 750 Pre-Mix Manual de usuario

Cornelius

Cornelius P/N 3626 Manual de usuario

Cornelius

Cornelius Maxi series Manual de usuario

Cornelius

Cornelius P/N 620043511 Manual de usuario

Cornelius

Cornelius Triton Series Manual de instrucciones

Cornelius

Cornelius CR R134a Series Manual de instrucciones

Cornelius

Cornelius 000 PLUS Manual de usuario

Cornelius

Cornelius COR9530UBCST Manual de usuario

Cornelius

Cornelius Energize Series Manual de instrucciones

Cornelius

Cornelius P/N 620037008 Manual de usuario

Cornelius

Cornelius P/N 620024406 Manual de usuario

Cornelius

Cornelius Energize Series Manual de usuario

Cornelius

Cornelius Energize 1 HC Series Manual de usuario

Cornelius

Cornelius Door Latch Manual de usuario

Cornelius

Cornelius Linus Series Manual de usuario

Cornelius

Cornelius COR15BBCD Manual de usuario

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario