88
88
8
During operation, the standard bleed system
will drain small amounts of water. This ensures
fresh water is continually added to dilute salt
accumulation in the water caused through
evaporation. This helps keep the cooler in good
condition and ensure optimum performance.
The bleed rate will depend on local operating
conditions and will be set by the installer.
STST
STST
STANDAND
ANDAND
ANDARD BLEED SYSTEM AND DRAIN VARD BLEED SYSTEM AND DRAIN V
ARD BLEED SYSTEM AND DRAIN VARD BLEED SYSTEM AND DRAIN V
ARD BLEED SYSTEM AND DRAIN VALAL
ALAL
ALVEVE
VEVE
VE
STANDARD BLEED SYSTEM
AUTOMATIC DRAIN VALVE
This cooler comes with a standard bleed sys-
tem or the optional automatic drain valve. If the drain valve was installed instead of the
standard bleed system then your cooler will au-
tomatically drain after a set time of continuous
operation. This ensures the water is always fresh
and helps maintain your cooler in good condi-
tion to ensure optimum cooling performance.
The frequency of the automatic drain may have
been adjusted by your installer according to the
general water quality in your area.
When the cooler is turned off for 72 hours,
the drain valve will open automatically and
empty water from the cooler. When the cooler
is turned on again, fan operation will delay
for a few minutes while the tank refills and the
cooling pads are saturated again.
At any time when the thermostat is OFF, you
can drain the cooler by pressing and holding
▲and ▼for 1 second.The display will show
“dr” to confirm the operation has activated.
