commtech wireless 7950 Manual de usuario
THE 7950 PAGER
1.1 Case Layout
1.2 Hand Programming Menu
With the pager turned on, hold down the Escape Key and Read Key for 3 seconds.
You will be prompted for a four digit numeric password.
PASSWORD:0000
Use the Escape Key to increase the selected digit and the Read Key to decrease the
selected digit. Press the Arrow Key to move along to the next digit. After the correct digits
are entered, press the Arrow Key to proceed to the first screen. By default this password is
0200.
Once you are in the programming menu, you will see the first four cap codes ready for viewing or
editing. There are eight cap codes available in total. The A, B, C, D, E, F, G, H at the start of the line
corresponds to cap code 1 to 8.
A: [ ON]0000008
B: [ ON] 0000016
C: [ ON] 0000024
D: [ ON] 0000032
NOTE: If you just need to change frequency or baud rate and not any capcodes, you can press the
Arrow Key to jump to that screen.
Each cap code can be enabled or disabled if required. This is what the ON or OFF field before each
cap code refer to.
Use the Escape Key and Read Key to change the selected field. Use the Arrow
Key to move to the next field.
Manual Pager Hand Programming
Page 2© CommtechWireless
Once you have scrolled through all of the fields on this first screen, you will be taken to the
second screen which contains the next four cap codes.
E: [ ON] 0000008
F: [ ON] 0000016
G: [ ON] 0000024
H: [ ON] 0000032
Once you have scrolled through all of the fields on this second screen, you will be taken to the
third screen which contains settings for the pagers baud rate, polarity and frequency.
BAUDRATE: 512 BPS
POLARITY: NORMAL
FREQ: 148.3375 M
PROGRAM EXIT
Use the Escape Key and Read Key to change the selected field. Use the Arrow
Key to move to the next field. These settings must match that of your paging system.
To save any changes you have made, move the cursor to the “Program” field and press the
Read Key. The screen will display EEPROM PROGRAMMING followed by **FINISHED**. The pager
will then resume normal operation with the newly programmed settings.
EEPROM PROGRAMMING
To exit the programming menu without saving any changes, move the cursor to the “Exit” field
and press the Read Key. The pager will then resume normal operation.
Otros manuales para 7950
2
Tabla de contenidos
Otros manuales de Buscapersonas de commtech wireless
commtech wireless
commtech wireless 4130 Manual de usuario
commtech wireless
commtech wireless Mercury 8-Line Manual de usuario
commtech wireless
commtech wireless 7900 Manual de usuario
commtech wireless
commtech wireless 6120 Manual de usuario
commtech wireless
commtech wireless 7950 Manual de usuario
commtech wireless
commtech wireless Mercury Wall Pager Manual de usuario
commtech wireless
commtech wireless 7900 Manual del propietario
commtech wireless
commtech wireless 7950 V2 Manual de usuario
commtech wireless
commtech wireless 7950 Manual de usuario
