Comfort Company RADIUS BACK Manual de usuario

RADIUS BACK®

24 INCHES OR LARGER

IS-RADIUSBACK24

REV0713

RADIUS BACK®24” OR LARGER

Parts Included:

1 - Complete Radius Back®Assembly

1 - 5mm Hex Key

1 - 2.5mm Hex Key

1 - 5/32 in. Hex Key

1 - 1/8 in. Hex Key

Loosen the two clamp bolts (A) on both sides using the 5mm Hex Key. Tighten the clamps onto the left and

right wheelchair canes.

Gently loosen bolts (I) and (J) on both sides to allow for adjustment of all mounting brackets using the

1/8 in. Hex Key.

The mounting brackets adjust in and out to accommodate varying sized wheelchairs. The Radius-Back®can fit onto a

wheelchair 1" narrower to 1" wider of the purchased size.

Tip: Make sure the clamps are the same height relative to one another on the canes.

Tip: Make sure the clamps sit square to the wheelchair.

Note: The quick release levers may be tight when first actuated, but will loosen after 1-3 times.

If the backrest was able to be removed and reinstalled smoothly, no additional height adjustments are

needed. If further adjustments are needed, repeat step 5. Fully tighten bolts (B) when adjustments are

complete using the 5/32 in. Hex Key.

Slightly loosen bolts (B) on the upper mounting bracket on both sides using the 5/32 in. Hex Key. Slide the

upper mounting bracket in or out, making sure to make all adjustments symmetric, until the wheelchair

canes are relaxed.

Angle and Depth Adjustment: Loosen the two bolts (D) on both sides using the 5mm Hex Key. The back-

rest can be slid forward/backwards, and can also be rotated angularly. Tighten all four bolts when the

backrest depth and angle are adjusted.

Tighten set screw (E) on both sides using the supplied 2.5mm Hex Key to lock angle rotation. These set

screws intersect with the top bolts and prevents angle rotation.

Tighten set screw (F) on both sides using the 2.5mm Hex Key to prevent vertical movement and angular

rotation of the clamps.

Attach the cane mounts (G) facing forward as shown at the desired height, keeping each cane mount

symmetrical. To attach the cane mount, remove one side screw securing the metal strap, wrap the strap

around the cane, tighten both side strap bolts, and tighten the rear screw to secure.

Place the mounting peg (G) into the groove on the cane mount (H) on both sides.

The installation of the backrest is complete. Now make adjustments for depth, angle, and

height. The user can be seated during this process.

To adjust the height of the back, burn new holes into the back cover, lining up with the desired holes in

the wood insert. The bolts (B) can be inserted into the adjusted height setting. Keep the height on both

the left and right assembly symmetrical.

When the upper mounting brackets appear to be in line, finger-tighten bolts (B) on both sides, open quick

release levers (C), and remove/reinstall the backrest.

IMPORTANT: When installation and adjustments are complete, all bolts should be tightened

to a minimum of 85 in-lbs. *This does not include set screws.

When hardware is properly placed, be sure to secure bolts (I) and (J) tightly on both sides.

Tabla de contenidos

Otros manuales de Silla de ruedas de Comfort Company

Comfort Company

Comfort Company Lateral Pad with Cane Mount Manual de usuario

Comfort Company

Comfort Company ACTA-EMBRACE Back Manual de usuario

Comfort Company

Comfort Company Quick Release Amputee Support Instrucciones de montaje

Comfort Company

Comfort Company ACTA-BACK Manual de usuario

Comfort Company

Comfort Company Body Point Shoulder Harness Manual de usuario

Comfort Company

Comfort Company SWING AWAY AMPUTEE Manual de usuario

Comfort Company

Comfort Company Quick Release Amputee Support Instrucciones de montaje

Comfort Company

Comfort Company ACTA-RELIEF Manual de usuario

Comfort Company

Comfort Company Compass 4 Manual de usuario

Comfort Company

Comfort Company Quick Release Hip Guide Hardware Manual de usuario

Comfort Company

Comfort Company LATERAL TRUNK SUPPORT Manual de usuario

Comfort Company

Comfort Company HIP GUIDE ASSEMBLY Manual de usuario

Comfort Company

Comfort Company SIDEMINDER WITH HEADREST Manual de usuario

Comfort Company

Comfort Company ACTA-RELIEF Manual de usuario

Comfort Company

Comfort Company FLEXION FOOTBOX DOUBLE Manual de usuario

Comfort Company

Comfort Company Sit N’ Shape Manual de usuario

Comfort Company

Comfort Company Comfort Foot Double Manual de usuario

Comfort Company

Comfort Company ACTA-CONTOUR Manual de usuario

Comfort Company

Comfort Company COMFORT FOOT Manual de usuario

Comfort Company

Comfort Company FLEXION FOOTBOX SINGLE Manual de usuario

Comfort Company

Comfort Company Acta-Relief Manual de usuario

Comfort Company

Comfort Company Acta-Relief Manual de usuario

Manuales populares de Silla de ruedas de otras marcas

Otto Bock

Otto Bock Skippi plus Manual de usuario

Invacare

Invacare Action 4NG series Manual de usuario

SORG

SORG LoopSORG 802 Manual de usuario

Designability

Designability WizzyBug Instrucciones de instalación

Vermeiren

Vermeiren RAPIDO Manual de usuario

Excel

Excel G5 KIDS 0285 Manual de usuario

M. Bartels

M. Bartels SA-3 Manual de usuario

nino robotics

nino robotics NIno Manual de usuario

Vermeiren

Vermeiren Turios Manual de usuario

Invacare

Invacare MK5 EX Manual de usuario

Invacare

Invacare Solara Spree GT Manual

Nova

Nova TKW-12 Manual de usuario

BCW

BCW Advantage Manual de usuario

You-Q

You-Q Luca Manual de usuario

interco

interco Ortolight Standard Manual de instrucciones

Nova

Nova 7190L Manual de usuario

Vermeiren

Vermeiren EZ1 Manual de usuario

PaceSaver

PaceSaver Scout M-300 Manual de usuario