CNW Instruction Manual
CNW
NARROW WRAP
currentlighting.com/columbialighting
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 2
Rev 07/20/22
COL_CNW_inst_R01
STEP 1
Remove the lens from the housing by pressing the provided suction cup to the lens near one end of the luminaire.
Pull up on the suction cup to detach the lens from the luminaire housing.
SURFACE MOUNTING
CAUTION! — READ THIS FIRST — IMPORTANT SAFETY INSTRUCTIONS
WARNING
• To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards read all
warnings and instructions included with and on the fixture box and all fixture labels.
• Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires should be performed by a qualified licensed electrician.
• For the installation: If you are unsure about the installation or maintenance of the luminaires, consult a qualified licensed electrician and check your
local electrical code.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• Do not make or alter any open holes in an enclosure of wiring or electrical components during installation.
WARNING
• Turn o electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn o the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label information.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
• Risk of burn. Disconnect power and allow fixture to cool before handling..
NOTICE: Green ground screw provided in proper location. Do not relocate.
NOTICE: Minimum 90° supply conductors.
NOTICE: Specifications and dimensions subject to change without notice.
NOTICE: Suitable for Dry or Damp location.
NOTE: Components shown in images are
representative only and may vary based
on the conguration ordered.
LED DRIVER
Black (Line)
White (Neutral)
Green (Grd)
Dimming wire
to 0—10V IEC
Le
LED load
Pink (Dim+)
Blue (-)
Red (+)
Gray (Dim-)
General Wiring Diagram
REMOVE
Lens
Suction cup APRESS
Housing
Lens
BPULL
