ColorKey VividPar HEX 6 Manual de usuario

VividPar HEX 6

RGBAW+UV Wash Light

CKU-2250

USER MANUAL

Table of Contents

INTRODUCTION .....................................................................................................................................3

SERVICE & SUPPORT...........................................................................................................................3

DISPLAY OPERATION...........................................................................................................................4

MENU GUIDE..........................................................................................................................................5

DMX VALUES..........................................................................................................................................6

6 CHANNELS MODE ..............................................................................................................................6

10 CHANNELS MODE............................................................................................................................6

IR REMOTE OVERVIEW.........................................................................................................................7

OPERATION............................................................................................................................................9

TROUBLESHOOTING ..........................................................................................................................10

TECHNICAL INFORMATION................................................................................................................11

Please read these instructions carefully before use. Operating this fixture according

to these instructions is important to avoid any possible damage or accidents caused

by misuse.

Introduction

Package Contents

•VividPar HEX 6

•Power Cable

•IR Remote

•Brackets

•User Manual

Caution! Opening this unit voids warranty. Contact ColorKey for any service requests.

Warning! To avoid electrical shock, be sure to disconnect power before any service or

when moving or setting up the fixture.

Caution! Avoid direct eye exposure with the fixture when on.

•This fixture is for indoor use only.

•Do not install or operate this fixture near flammable materials.

•This device must be installed, operated, and maintained by a qualified

professional.

•Please check if the voltage is in accordance with the rated power before

installing.

•Do not operate this fixture if the power cord has been damaged. Turn off fixture

and replace with a power cord of similar rating.

Service & Support

Your ColorKey product includes a 2-year warranty. For technical support or to register

your product, please visit https://www.colorkeyled.com/support/

You can also reach us by phone Monday thru Friday, 8:30am –5pm PST

at (818) 578-4030.

Display Operation

Menu: Access the menu/Scroll through menu options (*Hold Menu for two

seconds exit menu and return to your chosen program)

Up: Scroll through menu selection or increase parameter

Down: Scroll through menu selection or parameters decrease

Enter: Open/Select the current menu option

Menu Guide

Menu Item

Values

Function

Addr

001-512

DMX Address setting

ChNd

6ch / 10ch

Channel selection mode

SLNd

NASt / SL1 /

SL2 / SL3 / SL4

Master / Slave mode 1 / Slave mode 2 / Slave

mode 3 / Slave mode 4 (see pg 9 &10)

ShNd

CoLo

Auto

SoUn

FAdE

Performance modes –Static color select,

Auto color scroll, Color fades, Sound active

Led

On / Off

Turn LED display on or off during use

diSP

disp

Flip LED display direction

bALA

rEd, GrEE, bLuE

Manual white balance adjustment. Add or

decrease red, green, and blue values to create

desired White Balance

NAnu

rEd

GrEE

bLuE

Uhbe

Anbe

Manual Mode –Create color displays by

increasing or decreasing the values for each

colors LED value parameter from 0-255.

*Example –for only Red, rEd will be 255, all

other colors 0.

teSt

Test

Auto-test –the light will automatically engage

color LEDs to test.

FhrS

0-9999

Displays lifetime fixture use hours

Yes / No

IR Remote sensor on (Yes) / off (No)

teNP

Temperature

Displays temperature

DMX Values

6 Channels Mode

Channel

Value

Function

0-255

Red

0-255

Green

0-255

Blue

0-255

White

0-255

Amber

0-255

10 Channels Mode

Value

Function

0-255

Red

0-255

Green

0-255

Blue

0-255

Amber

0-255

White

0-255

Master Dimmer

3-255

Strobe

8-255

Auto color scroll

008-199

Color auto scroll speed

200-255

Sound control

IR Remote Overview

To use the IR remote, simply point the remote at the IR receiver on the lighting

fixture. The IR receiver on the VividPar HEX 6 is located on the face with the

LED lenses.

Black Out

Black Out mode instantly turns all LED’s off.

Press the Black Out button to engage or disengage Black Out mode.

Auto

In Auto mode, the light loops through various preprogrammed colors.

To turn on Auto mode, press the Auto button, then press (+) or (-) to increase or

decrease the speed of the program.

Sound

Sound-Active mode enables the light to respond to ambient sounds in the room

using the fixture’s built-in microphone.

Press the Sound button to activate Sound-Active mode. Press (+) or (-) to

increase or decrease sound sensitivity based on the playback level of the music.

Strobe

In Strobe mode, the light will strobe while the button is pressed.

To turn on Strobe mode, press and hold the Strobe button, this mode can be

engaged while running other programs for added effect.When Strobe is released,

the light will continue previous operating program.

Manual Color Mixing

VividPar can create an almost unlimited number of colors by mixing the Red,

Green, Blue, Amber, UV and White LEDs.

To begin mixing colors, press the Red (R), Green (G), Blue (B), Amber (A),

UV (UV), White (W) button, then press (+) or (-) to increase or decrease the

brightness of each color. Continue with the next color until you achieve your

desired color.

Fade

In Fade Mode, the light creates smooth, gradual color transitions.

To turn on Fade mode, press the Fade button, then press (+) or (-) to increase or

decrease the speed of the program.

Color Presets

10 preset colors can be accessed from the IR Remote. Press any number between

(0) and (9) to set a color.

0 - White

1 - Red

2 - Magenta

3 - Yellow

4 - Green

5 - Blue

6 - UV

7 - Purple

8 - Pink

9 - Orange

Operation

Using a DMX controller:

•Use a DMX cable to connect your VividPar HEX 6 to the DMX in/out sockets on

the bottom of the light.

Using Master/Slave Mode:

The Master/Slave mode allows a group of VividPar HEX 6 units (the slaves) to

duplicate the output of another VividPar HEX 6 (the master) without a DMX

controller.

1. Set each of the slaves:

◼Go to SLNd in the main menu and press enter.

◼Select SL1.

2. Set the master:

◼Go to SLNd in the main menu and press enter.

◼Select NASt.

•The master (NASt) is the unit that runs your program whether in one of the static

color modes or various Auto programs.

Using Slave modes (SL1,SL2,SL3,SL4) to create a light show

Using 5 or more lights for best effect, VividPar HEX 6 can help create auto-light

shows by setting lights in order from Master, SL1, SL2, SL3, SL4 and engaging Auto

Programs on the Master fixture.

1. Set each of the desired slaves SL1, SL2, SL3, SL4:

◼Go to SLNd in the main menu and press enter.

◼Select SL1.

◼Repeat steps for each slave fixture SL2, SL3, and SL4

2. Set the master:

◼Go to SLNd in the main menu and press enter.

◼Select NASt.

•For best effect, have lights connected in sequence from Master, to SL1, to SL2, to

SL3, to SL4.

•Accessing the (ShNd) programs on the Master light will now create varying displays

of synchronized light on the master and slave fixtures through (Auto) and (SoUn)

functions.

Troubleshooting

Problems

Solutions

No DMX Control

Ensure your DMX controller is sending signal and you are

using a proper and working DMX cable.

No response with IR

Remote

Engage and disengage Blackout as it may be active and

keeping the light dark

No response with IR

Remote

Ensure IR remote is enabled in Menu (rF) setting to YES

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Equipo de iluminación de ColorKey

ColorKey

ColorKey Odin FX CKU-1060 Manual de usuario

ColorKey

ColorKey Kraken FX Manual de usuario

ColorKey

ColorKey AirBar HEX 6 Manual de usuario

ColorKey

ColorKey LED Par 64 Manual de usuario

ColorKey

ColorKey KasBar COB Tri 5 Manual de usuario

ColorKey

ColorKey Mover Halo Beam QUAD MKII Manual de usuario

ColorKey

ColorKey AirPar COB QUAD Manual de usuario

ColorKey

ColorKey WaferPar QUAD-W 7 Manual de usuario

ColorKey

ColorKey PARTYBAR Mobile 150 Manual de usuario

ColorKey

ColorKey VividPar HEX 12 Manual de usuario

ColorKey

ColorKey WaferPar HEX 12 MK II Manual de usuario

ColorKey

ColorKey Mover MicroBeam QUAD-W CKU01-5010 Manual de usuario

ColorKey

ColorKey Odin FX Manual de usuario

ColorKey

ColorKey StagePar COB TRI Manual de usuario

ColorKey

ColorKey Dazzler FX Manual de usuario

ColorKey

ColorKey MobilePar Hex 6I Manual de usuario

ColorKey

ColorKey Mover Miniwash QUAD 4 MKII Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario