CODELOCKS CL600 Manual de usuario

https://codelocks.zohodesk.eu/portal/en/kb/articles/cl600-code-change-guide

Codelocks Support

CL600 - Code Change Guide

Many Codes to Choose From

The CL600 range has been designed so the code can be changed on the door in seconds. The code chamber

(models 600, 610 and 620) consists of 13 buttons and a ‘C’ button which is used to re-set the code chamber after

an incorrect entry, and must always be used as the first digit of a code. Buttons may only be used ONCE in a

code. For example 1212 is NOT possible.

The CL600 ranges code or combination, can be entered in any order or sequence; eg 1234 can be 4321 or 1342 or

whatever sequence is most convenient to remember.

With 13 buttons, a total of 8,191 different codes are available, any of which can be entered in any sequence.

The total is arrived at as follows:

Note:Models 605, 615 and 625 have 12 coded buttons giving 4,095 different codes.Most people will set the

code in the range of 4 to 7 digits, and the total number of codes in this range is 5,434. The lock is supplied with a

random factory set code (see code card). At any time this can be quickly changed to a new code of your choice.

Typically codes are 4 to 7 digits long. Shorter codes are possible (1-2 digits) but are not recommended.

Passage Free Mode Models 605, 615 and 625

The above feature can be identified with a black dot on the ‘Z’ button.

To set the lock in passage free mode enter the code followed by the ‘Z’ button. The lock will now be in free

passage mode.

To put the lock back into code access only press the passage set ‘Z’ button once followed by the C button.



https://codelocks.zohodesk.eu/portal/en/kb/articles/cl600-code-change-guide



Code Change Instructions

The CL600 range offers significant advantages over other similar mechanical digital locks by allowing the code

to be changed in seconds on the door.

Note: Models 605, 615, 625 only – Before changing code press the ‘Z’ and ‘C’ button to ensure that the lock is

not in free passage mode.

1. Choose code.

2. Insert key and turn anticlockwise to stop for right hand hung doors, or clockwise to stop for left hand hung

doors. Fig 1.

3. Push the code change tool onto each button in turn, pushing in the buttons approx 2mm (3/32”) turn

anticlockwise 180°. All buttons should now be in the non code position.

4. Test that all buttons are in non code position (perform step 6 before testing buttons) then depress the lever

handle which should retract the latch. If latch cannot be retracted press ‘C’ button and repeat step 3.

5. To select a button as a code button, push code tool over button. Press in button with tool approx 2mm (3/32”)

and turn clockwise 180°. Fig 2.

6. Now turn the key clockwise for right hand hung doors, or anticlockwise for left hand hung doors retracting the

latch which will relock the code buttons. Fig 3.

7. Return the key to centre and remove.

8. Before closing door test code.

https://codelocks.zohodesk.eu/portal/en/kb/articles/cl600-code-change-guide



Removal of front load cylinders to repin or replace with cylinders by a different manufacturer.

1.Remove handle and cylinder cover.

2.Turn Key 90° anticlockwise and remove the cylinder from boss

https://codelocks.zohodesk.eu/portal/en/kb/articles/cl600-code-change-guide

3.To replace cylinder, reinsert and turn 90° clockwise. Replace the cylinder cover and handle.

*If intending to use a cylinder from a different manufacturer it is advisable to confirm beforehand that the new

cylinder will fit the boss.

Notethat the CL600 uses a 6 pin screw cap cylinder.

If using a screw cap cylinder other than supplied, the tail piece from the Codelocks screw cap cylinder will need

to be fitted as follows:

4.Hold down the control pin in the end of the cylinder and unscrew the cap.

Caution!Do not insert the key in the cylinder once you have removed the screw cap!

5.Refit the tailpiece, hold down the control pin and screw the cap on fully without tightening. Ensure the control

pin projects to lock the cap.

https://codelocks.zohodesk.eu/portal/en/kb/articles/cl600-code-change-guide

Test the key operation

If the key is difficult to insert, or tight when turning, then the cap may be too tight. Loosen the cap one notch at a

time and try the key again. If the key inserts and turns OK, but is difficult to remove, then the cap may be too

loose.

Tighten up the cap one notch at a time.

Adjust the cap until the key inserts, turns and removes easily.



Dimensions

https://codelocks.zohodesk.eu/portal/en/kb/articles/cl600-code-change-guide

Features

■ On door code change in seconds.

■ Code free entry mode (models 605, 615, 625 only).

■ Inside handle always retracts the latch for exit.

■ Weather resistant.

■ Tamper resistant, with stainless steel buttons, and clutch protection if the outside handle is forced.

■ Reversible handles.

■ Easy code change as often as required.

■ Fits doors between 35mm (1 3⁄8”) and 60mm (2 3⁄8”) thick without modification.

Features - Model 620/625 Only

■ Split follower lock enables inside handle to retract latch and deadbolt simultaneously, satisfying ‘means of

escape’ requirements for exit at all times. Prevents accidental lock-ins.

■ Deadbolt thrown by key to lock out code users after work hours.

■ Key will retract the latchbolt giving access for admin functions.

■ D bl E fil li d ith 3 k A E fil li d b d

https://codelocks.zohodesk.eu/portal/en/kb/articles/cl600-code-change-guide

■ Double Euro-profile cylinder with 3 keys. Any Euro-profile cylinder may be used.

■ On multiple door installations consideration should be given to having all cylinders keyed alike, with restricted

key issue, for ease of management.



Maintenance

No maintenance of the working parts is necessary.DO NOT OIL.To maintain the finish the lock should be

cleaned regularly with a soft cloth. A silicone spray or similar should be used to provide a protective film against

grit and grime.



CC-CL600-0812

Otros manuales para CL600

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cerradura de puerta de CODELOCKS

CODELOCKS

CODELOCKS CL5010BB Manual de usuario

CODELOCKS

CODELOCKS KL1200 Manual de usuario

CODELOCKS

CODELOCKS 0460 Manual de usuario

CODELOCKS

CODELOCKS CL5510 Manual de usuario

CODELOCKS

CODELOCKS KitLock KL1O Manual de usuario

CODELOCKS

CODELOCKS 2010 Manual de usuario

CODELOCKS

CODELOCKS GLASS DOOR LOCK Manual de usuario

CODELOCKS

CODELOCKS CL400 Manual de usuario

CODELOCKS

CODELOCKS CODELOCK 300 Manual de usuario

CODELOCKS

CODELOCKS 400 mechanical Guía del administrador

CODELOCKS

CODELOCKS CL1200 Manual de usuario

CODELOCKS

CODELOCKS KL1000 Manual de usuario

CODELOCKS

CODELOCKS 4010 Manual de usuario

CODELOCKS

CODELOCKS CL410 Manual de usuario

CODELOCKS

CODELOCKS Codelock 100 Manual de usuario

CODELOCKS

CODELOCKS CL5000 Manual de usuario

CODELOCKS

CODELOCKS CL500 Guía del administrador

CODELOCKS

CODELOCKS CL5510 Manual de usuario

CODELOCKS

CODELOCKS CL610 Manual de usuario

CODELOCKS

CODELOCKS KL1000 G3 NetCode Manual de usuario

CODELOCKS

CODELOCKS KL1000 Classic+ Manual de usuario

CODELOCKS

CODELOCKS 4OOO ELECTRONIC Manual de usuario

CODELOCKS

CODELOCKS CL5500 SERIES Manual de usuario

CODELOCKS

CODELOCKS CL460 Manual de usuario

Manuales populares de Cerradura de puerta de otras marcas

Assa Abloy

Assa Abloy effeff 827A-IP Manual de usuario

We.lock

We.lock SECBNEBL51 Manual de usuario

Iseo

Iseo MA1A Manual de usuario

ID Lock

ID Lock 150 Manual de usuario

Lockly

Lockly ACCESS TOUCH PRO Manual de usuario

iLoq

iLoq G50S Manual de usuario

SDC

SDC Z7835 Manual de usuario

ilco

ilco 452 Manual de usuario

Samsung

Samsung shs-h705 Manual de usuario

TRU-BOLT

TRU-BOLT 08102017 Manual de usuario

CDVI

CDVI 500-LADJ Manual de usuario

Igloohome

Igloohome Deadbolt 2S Metal Grey Instrucciones de instalación y mantenimiento

eSSL

eSSL FL-300 Manual de usuario

JAKO

JAKO JKBTNX4 Manual de usuario

Dorma

Dorma MUNDUS PREMIUM GK 50 Guía del usuario

SCOOP

SCOOP Pullbloc 4.1 FS Panik Manual de usuario

Yale

Yale MORTISE 8800 SERIES Manual de usuario

Siegenia

Siegenia KFV AS3500 Manual de usuario