Brezza
BrezzaBrezza
Brezza
Assembly Instructions
___________________________________________________________________________________
Picture 1
Turn the hull of the ship upside down and drill a 4 mm hole in the fixing point of the fin keel and a 10 mm hole in the
fixing point of the rudder socket.
Picture 2
From the outside of the hull, insert the rudder socket (6) and glue with special glue for plastic model constructionss.
From the inside of the hull, insert and glue as well the counter socket (5) onto the rudder socket (6).
Picture 3
Turn the ship deck upside down and create the opening for the battery/receiver compartment removing the indicated
part.
(In order to be more accurate, we suggest to drill first 2 mm holes in the four corners and then to use a small cutter.)
Picture 4
Equivalent to the previous picture (but this time working from the top), create the opening for the servo compartment,
leaving a border of about 5-6 mm along the perimeter.
Picture 5
Drill holes into the deck in the marked positions with the diameters indicated in the picture.
Picture 6
Turn the deck and using a cutter, remove the lower exceeding part of the deck (the cutting line is indicated in the
picture as a dotted line).
Picture 7
Working from the top, remove the upper exceeding rims of the plastic parts (A), (B) and (C) with a cutter, leaving a
surrounding border of about 2 – 2,5 mm on (C).
On part (A) make the openings for the servos (dotted part) and glue the two supporting fillets exactly where the
screws for the servos are going to be placed later.
Remove the exceeding parts from element (D) leaving a surrounding border of about 4 – 5 mm.
Picture 8
Equivalent to the previous picture, cut out from below parts (E) and (F). Cut out the plastic rectangle (G), in order to
make the cover for the opening of the servo compartment. Slightly round off the edges.
In a later step make four small holes for fixing with the self-tapping screws.
Picture 9
With special glue for plastic model constructions stick on parts (A), (F) and (E) (on the inner part of the hull),
respecting the indicated measures in the picture.
After the glue has dried out, the reinforcement of the fin keel (E) has to be perforated for the passage of the screws
(as a reference use the previously drilled holes in the hull).
Picture 10
In case you decided to paint your boat, before proceeding with the assembly, we recommend to do so now.
First grind the surface with abrasive paper (grain size 400 – 500) and then paint as you desire. In painting hull and
deck separately you can avoid the masking of accessories which should not be painted.
Picture 11
Insert from underneath the deck piece (8) into the previously drilled 5,5 mm hole and from above insert the fairleads
(11) in the indicated spots.
Fix everything with a drop of acrylic glue.
Picture 12
With a 3 mm bit drill holes into the centre of the two smaller sides of element (D) (picture 12a). Pass through these
holes the plastic sheathing and let it stick out by about 100 mm from the anterior part (picture 12b).
Place part (D) on the inside of the deck onto the left side and glue using special glue for plastic model constructions
(picture 12c). Insert the other side of the sheathing into the fairlead (11).
If necessary, shorten the sheathing and adapt its length. Fix with a drop of acrylic glue.
