CMP Huron Manual de usuario
Huron (LDAL Cable Cleat)Huron
(LDAL Cable Cleat)
Features
• Third party certification to IEC 61914:2009
• 5000 series aluminium
• 19 - 128mm in 23 sizes for trefoil formation /
application
• Operating temperature of -50°C to +60°C
• Low Smoke & Fume (LSF) liners as standard
• One or Two M10 fixing design
www.cmp-products.com
Cleat Installation
Instructions
FI530 REV 0
CMP Cleat Installation Instructions
1. Place the cable cleat in desired
location on mounting surface and
unhinge the cable cleat.
2. Insert base booster if required.
4. Tighten down to specified
torque rating of 8Nm (2 bolt option
pictured).
6. Using supplied mouthpiece
fittings, tighten down to no more
than 8Nm with 19mm nut spanner.
3. Secure cleat to the mounting surface
using 1x M10 bolt (3a) or 2 x M10 bolts (3b),
adding a washing and nut on both sides.
5. Place the cable into the cleat
and pull the hinged arm over the
cables.
Nut
Spacer
Note: Cleat marking can be found on hinged arm
Booster (3a)
(3b)
Otros manuales de Cables y conectores de CMP
CMP
CMP E1FW Manual de servicio
CMP
CMP PXRC-REX Manual de usuario
CMP
CMP T3CDS Manual de usuario
CMP
CMP TMC2 Manual de usuario
CMP
CMP A2FFC Manual de usuario
CMP
CMP PXSS2K-REX Manual de usuario
CMP
CMP PXSS2K Manual de servicio
CMP
CMP CW Manual de usuario
CMP
CMP C2K Manual de usuario
CMP
CMP A2F Manual de usuario
