• Keep the handles dry, clean, and free of oil and grease.
• Do not touch rotating parts.
• Persons under 16 years are not allowed to use the tool.
• During use, the user and other persons standing nearby have to wear suitable
goggles, helmets, ear protectors, dust mask, protective clothes and boots.
• During manual operation, always hold the tool with both hands and be fall-
safe. Consider the tool’s reaction torque in case of blocking.
• Always work with concentration. Always work in a carefully considered
way and do not use the tool if you are lacking consideration.
• During manual operation, work with a special circumspection when dry
drilling with dimensions between 100 and 132 mm!
For further safety instructions, see the enclosure.
The The Clipacore Diamond Core Drill is designed according to protective
class II. Prior to putting the tool into operation, check the mains voltage for
conformity.
Voltage variations between + 6 % and – 10 % are permissible.
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unindented responding.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage Cross section in sq. mm
1.5 2.5
110V 20 m 40 m
230V 50 m 80 m
Additional Handle
For manual drilling, the The Clipacore Diamond Core Drill may be used only
together with its additional handle which comes with the tools. Place it on the
gearing collar from the front and fix it by counterclockwise rotation.
Electrical Connection
Switching ON and OFF
Short-time operation
ON: Press the ON/OFF switch
OFF: Release the ON/OFF switch
Long-time operation
ON: Keeping the ON/Of switch pressed, push in the arrestor button.
OFF: Press and release the ON/OFF switch again.
Attention!
Use the arrestor button only during operation with drill rig. Its use
during manual operation is not allowed. If the machine stops for any
reason or due to power failure, immediately release the arrestor button
by pressing the ON/OFF switch.
The Clipacore Diamond Core Drill is equipped with an electronic switch.
With this switch the speed can be regulated according to the pressure on
the button. Only use the electronic switch when you want to start or stop
the machine in order to avoid material splashing around. A permanent use
with reduced speed can cause an overload because the motor then gets
less cooling air and therefore the machine will be overheated much faster.
Changing Gears
The Clipacore Diamond Core Drill is equipped with a 2-gear gearing. Select the
speed according to the drilling diameter.
Use the gear selector to change to next higher or lower gear.
If gear changing is too heavy, slightly turn the working spindle to ease gear
changing.
Switching the tool on and off for a moment may also help to ease gear selection.
Warning!
•
Never apply force, and change the gear only when the tool is running down.
• Never use tools, such as hammers or pliers to change the gear.
Drilling
Dust which occurs during your work is hazardous to health. That is why it is
advisable to use a dust extractor and to wear a dust mask on dry drilling.
In case the core bit gets jammed, do not try to release it by switching the drill on
and off. This would cause premature wearing of the safety clutch. Switch the drill
off immediately and cautiously pull the tool out of the borehole.
!
!
