climachill PAC20A Manual de usuario
PORTABLE AIR CONDITIONER
Instruction Manual for PAC20A
PAC20A
19,500btu Portable Air Conditioner
Please read this manual carefully prior to operating the product.
Please keep ALL packaging for duration of Warranty Period
1
TABLE OF CONTENTS
IMPORTANT SAFEGUARDS 1-2
INTRODUCTION / WARRANTY 3
SPECIFICATOIN / PRODUCT DIAGRAM 4-5
INSTALLATION 6
OPERATION 8
EFFICIENCY BOOSTING 12
DRAINAGE 13
MAINTENANCE 15
TECHNICAL SUPPORT / CUSTOMER SERVICE CONTACT 16
IMPORTANT SAFEGUARDS
Before installing and using your portable air conditioner, it is important that you read this owner’s
manual carefully. Store this manual in a safe place for future reference.
This instruction manual is used for guidance and does not form part of a contract. It reserves the
right to make technical changes without prior notice.
1. Always place the unit on a level surface.
2. The appliance shall be installed in accordance with national wiring regulation.
3. The unit must be connected to a correctly grounded power supply. For your safety, this
unit is grounded through the power cord plug when connected to a grounded wall outlet.
Do not use an adapter plug or extension cord.
4. Do not install the unit in an area where gas leakage may occur and/or in an explosive
atmosphere.
5. Do not apply an insecticide or any type of flammable spray on the unit.
6. Confirm drainage piping is connected properly.
7. Do not start or stop the unit by inserting or pulling out the power plug.
8. Do not operate with wet hands.
9. Close supervision is necessary when the unit is used near children. The unit in not
intended for use by children.
10. Do not insert anything into the air outlet. Do not obstruct air inlet or outlet grills.
11. Do not expose skin or eyes directly to cool air for a long period of time.
12. If an abnormal odour or smoke comes out of the unit, disconnect the unit immediately
and contact a qualified service technician.
13. When opening the filter cover, do not touch the metal parts in the unit’s interior.
14. Do not immerse the unit in water or any type of liquid. Do not use the unit in the
immediate surroundings of a bath, shower, or swimming pool, or in any other steamy,
wet areas.
15. When cleaning the unit, always turn the unit off and unplug the power cord.
16. Always inspect the power cord for signs of damage before use. If the power cord is
damaged, it must be replaced by the manufacturer or a qualified service technician.
17. Do not place a plant or allow a pet in the direct path of the airflow to avoid injury.
18. Do not put a stove, etc, where it would be exposed to the direct airflow. It may affect
combustion.
19. Do not sit on the unit or place anything on it.
2
20. Before storing, the water must be drained from the unit and the filters cleaned.
21. The appliance must be placed in an area without any continuously sources of ignition (for
example: open flames , gas or electrical appliances in operation).
22. Do not puncture and do not burn.
23. This appliance contains Y g (see rating label back of unit ) of R410a refrigerant gas.
24. R410a is a refrigerant gas that complies with the European directives on the environment.
Do not puncture any part of the refrigerant circuit.
25. If the appliance is installed, operated or stored in a nonventilated area, the room must be
designed to prevent to the accumulation of refrigerant leaks resulting in a risk of fire or
explosion due to ignition of the refrigerant caused by electric heaters, stoves, or other
sources of ignition.
26. The appliance must be stored in such a way as to prevent mechanical failure.
27. Contact authorized service technician for repair or maintenance of this unit.
28. Unplug the unit if strange sounds, smell, or smoke comes from it.
29. Keep Filters Clean
30. Keep Curtains Closed During the sunniest part of the day
31. Do not use extension leads
32. Only use in the up-right position
33. For Indoor Use Only
General Information
Recycling
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this product for environmental safe
recycling.
Warning
The unit creates water which is collected in an internal water tank which has a rubber drain plug,
it is very unlikely but if this tank becomes damaged during transport or the rubber bung comes
out then it is possible that the unit will leak water when it is operated. Prior to use make sure the
drain plug is in place & then during first use periodically check the unit to make sure it isn’t
leaking water (look at bottom / under the unit) – during first use do not turn the unit on and leave
it unattended for a long period of time without checking.
3
INTRODUCTION
Thank you for purchasing this Portable Air Conditioner. This unit is designed to improve indoor
living and working comfort by providing cooling and dehumidifying with minimal installation.
Please complete the following information for future reference. Retain this owner’s manual with
your sales receipt as a permanent record of your purchase.
Date of Purchase: _______________________________________________________
Place of Purchase: _______________________________________________________
Invoice Number: _______________________________________________________
WARRANTY
This product comes with a 12month warranty from date of purchase (as indicated on original
sales receipt).
Please note that it is a warranty condition that ALL of the original packaging is kept for the
duration of the warranty period, (the main box can be folded flat for storage).
If you need to make a warranty claim and the unit requires returning to us then we are only able
to organise collection of the unit if it is in its original packaging (this is an insurance requirement
of our courier). Failure to keep the original packaging means we are unable to organise
collection of the product from you
4
SPECIFICATION
Model no.
PAC20A
Power supply
220-240V~, 50Hz
Cooling capacity
19,500BTU/hr
5.7kw/hr
Power consumption
2200W/10.2A
Air volume
661 m3/hr
Moisture removal
57.6L/day
Compressor
Rotary
Refrigerant
R-410A
Fan speed
3
Timer
24 hours
Working temperature
18 ~ 32oC
Exhaust pipe
Ø 165 x 1500 mm
N.W.
42kg
Product size (W x D x H)
453x427x806 mm
REMARK:
1. Measuring condition for above is as per EN 14511 :
Cooling – DB=35°C , WB=24°C
DB = temperature of dry bulb = room temperature
WB = temperature of wet bulb = relative humidity.
2. Test condition for data in our rating label is as per safety regulation: EN 60335-2-40
3. Current & Fuse : F2L250V or T2L250V
This equipment contains fluorinated greenhouse gas R-410a.
The fluorinated greenhouse gas is contained in a hermetically sealed equipment.
Nature of gas: R410A (HFC32: 50% - HFC125: 50%)
Amount of gas : 980g (Equivalent to 2.04624 Ton Co2)
Potential global warming (GWP): 2088
5
PARTS
1. Control Panel
2. Air outlet
3. Side air filter (air inlet)
4. Caster
5. Handle
6. Air filter (air inlet)
7. Exhaust air outlet
8. Cord hanger
9. Drainage knob / drainage point
10. Handle
11. Water bottle (for energy efficiency boosting)
Accessories
12. Exhaust hose.
13. Remote control
14. Drain tube for continuous drainage
15. Round Adapter –for connecting the
unit and the exhaust pipe
16. Flat Adaptor – for connecting the
exhaust pipe and the window spacer
17. Window spacer - for filling the open
window space
18. Window spacer - for filling the open
window space
19. Window spacer - for filling the open
window space and with hole for
connection to exhaust hose
20. Active carbon filter
6
INSTALLATION
The unit is a portable air conditioner that may be moved from room to room.
1. Using the supplied window spacer
Offer window spacer to the window gap and adjust the length as you need.
Feed exhaust hose through the window spacer and slide window across so that spacer is
held securely. This technique may also be used for sash windows. Note: Take care to
maintain protection against intruders
Use only the hose provided and clip
exhaust hose and unit adaptor to the back
of the air conditioner
Avoid kinks and bends in the exhaust hose
as this will cause expelled moist air to build
up causing the unit to overheat and shut
down.
The hose may be extended from 300mm to
1500mm but for maximum efficiency use
the shortest length possible.
Extendable slide
Window spacer
7
Installation of the carbon filter
This machine is equipped with the active carbon filter. The activated carbon is charcoal that
has been treated with oxygen to open up millions of tiny pores between the carbon atoms. It is
used to get rid of unwanted odors (smoke, fumes, and animal odor). Please note, the carbon
filter is not washable, its life span is variable and depends on the ambient conditions where the
unit is used. The filter should be checked periodically and replaced if necessary (normally, it’s
6 months), below is the installation of the active carbon filter along with this unit:
1.
Separate the filter frame the unit.
2.
Take out the carbon filter from its bag.
3.
Apply the carbon filter on the unit.
4.
Fix back the filter frame on the unit.
8
OPERATION
Control panel with press button
1. ON/OFF (POWER) button
2. MODE button
3. SPEED (ventilation) button
4. TIMER button
5. TEMPERATURE DOWN button
6. TEMPERATURE UP button
7. SLEEP button
a. Water full indicator
b. AUTO mode indicator
c. DEHUMIDIFY (DRY) mode indicator
d. Medium fan speed indicator
e. High fan speed indicator
f. Timer indicator
g. Compressor operation indicator
h. FAN mode indicator
i. COOL mode indicator
j. Low fan speed indicator
k. Sleep mode indicator
BEFORE USE
Check that the Exhaust Hose has been mounted properly (see ‘Installation’ section). If
the exhaust Hose is not correctly used, hot air will blow back into the room you are trying
cool
Check that the drain plug at the bottom rear of the unit is securely plugged in, to prevent
water leaks (see page 13 – Water Drainage)
Check that the local mains power matches that shown on the rating label of the unit
Check that the location of the unit is suitable (flat, stable surface; away from sources
water / heat)
If the unit has recently been transported, let it stand for 1 hour to allow the contents to
settle
9
OPEN & ADJUST THE MAIN AIR VENT
Before using the unit, you must open the
horizontal louver!
Adjust the louvers to your desired direction
TURNING ON/OFF
Touch ON/OFF button, the unit will start in AUTO (automatic) mode.
Automatic mode
In automatic mode, the unit can cool or ventilate depending on ambient temperature and setpoint
adjustment. The unit is preset as follows:
1. If ambient temperature is > 23°C , the unit will be in automatic cooling mode. Default
setting 24°C. During this operation, the indicator for AUTO and COOL mode light up.
2. If the ambient temperature is < 24°C, but > 20°C, the unit will work in ventilation mode.
During this operation, the indicator for AUTO and FAN mode light up.
Setpoint setting in automatic cooling mode 18-32°C
Tabla de contenidos
Otros manuales de Acondicionador de aire de climachill
climachill
climachill PAC12K Manual de usuario
climachill
climachill PAC12J Manual de usuario
climachill
climachill PAC15H Manual de usuario
climachill
climachill PAC18L Manual de usuario
climachill
climachill PAC12L Manual de usuario
climachill
climachill PAC15K Manual de usuario
climachill
climachill PAC15L Manual de usuario
