10
5. By default, the HD Capture Box will assume you are
trying to record an HDMI video source. If so, skip to the
next step. If you are trying to record from AV/VGA/YPbPr,
hold down the “Source” button on the HD Capture Box
until it is set to the correct source, or press the “VGA,”
“YPbPr,” or “AV” buttons on the remote control.
6. Once a live signal is coming from your video source to
the HD Capture Box, you should see a live preview of your
video source on your TV screen. (If not, see the notice on
page 8. Also, check your signal and make sure your TV is
set to the correct HDMI input.)
7. Plug in a USB flash drive or hard drive into the USB
port (#5) on the HD Capture Box.
NOTE! For best results, we highly recommend using a
brand new, name-brand USB flash drive (i.e. SanDisk,
Samsung, etc.) that is formatted to a FAT32 or NTFS
file system.
8. To start recording, press the “REC/STOP” button on
the HD Capture Box, or press the “REC” button on the
remote control. The “REC/STOP” button will flash while
the unit is recording or saving a file.
9. To stop recording, press the “REC/STOP” button
again on the HD Capture Box, or press the “STOP” button
on the remote control.