Clarke CL6FS Manual de usuario

OPERATION INSTRUCTIONS

GC0315

PORTABLE WORK LIGHT

MODEL NO: CL6FS

PART NO: 4003530

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INTRODUCTION

Thank you for purchasing this CLARKE Worklight.

Before attempting to use this product, please read this manual thoroughly and

follow the instructions carefully. In doing so you will ensure the safety of yourself

and that of others around you, and you can look forward to your purchase

giving you long and satisfactory service.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12

months from the date of purchase. Please keep your receipt which will be

required as proof of purchase.

This guarantee is invalid if the product is found to have been abused or

tampered with in any way, or not used for the purpose for which it was

intended.

Faulty goods should be returned to their place of purchase, no product can

be returned to us without prior permission. This guarantee does not effect your

statutory rights.

SPECIFICATIONS

CL6FS

Voltage 230V -50Hz

Wattage 6W

Range of tilt 55-120 degrees

Weight 1.5 kg

Dimensions (L x W x H) 210 x 230 x 320 mm

Light Output (Lumens) 500

Efficiency 80 lm/w

Weighted Energy Consumption 6kWh/1000h

Energy Efficiency Class A++, A+,A

LED life expectancy 50,000 hours

Waterproof protection grade IP44 (splashproof)

Lens material Tempered Glass

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SAFETY PRECAUTIONS

1. Do not use this worklight in hazardous locations, such as flammable or

explosive environments.

2. If used with an extension cable always ensure that the extension cable is

fully unwound.

3. Check that the power supply is compatable with the worklight as

indicated on the label. We recommend that a Residual Current Device

(RCD) is used in conjunction with this product.

4. Do not use this worklight if it has a broken lens, casing or damaged supply

cable. Have parts replaced by a qualified electrician.

5. Always ensure trailing cables do not cause a risk of tripping etc or pass over

sharp edges/objects.

6. Before moving your worklight or replacing a broken part, always ensure

that the power supply is disconnected at the mains.

7. Do not look directly into the lamp when switched on as this can damage

the eyes.

8. This unit must not be immersed in water.

9. Do not move your worklight or replace lamps or broken parts with wet

hands, or when standing on a wet or damp surface or in water. Always

ensure the power supply is disconnected at the mains.

10. Please read all of the safety and operating instructions carefully before

using this product. The following safety symbols may be found on the

product.

Read this instruction

booklet carefully

before use.

Always replace broken

glass.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

Before switching the product on, make sure that the voltage of your electricity supply is

the same as that indicated on the rating plate. This product is designed to operate on

230VAC 50Hz. Connecting it to any other power source may cause damage.

This product may be fitted with a non-rewireable plug. If it is necessary to change the

fuse in the plug, the fuse cover must be refitted. If the fuse cover becomes lost or

damaged, the plug must not be used until a suitable replacement is obtained.

If the plug has to be changed because it is not suitable for your socket, or due to

damage, it should be cut off and a replacement fitted, following the wiring instructions

shown below. The old plug must be disposed of safely, as insertion into a mains socket

could cause an electrical hazard.

If the colours of the wires in the power cable of this product do not correspond with the

markings on the terminals of your plug, proceed as follows.

• The wire which is coloured Blue must be connected to the terminal which is

marked Nor coloured Black.

• The wire which is coloured Brown must be connected to the terminal which

is marked Lor coloured Red..

We strongly recommend that this machine is connected to the mains supply

via a Residual Current Device (RCD)

If in any doubt, consult a qualified electrician. DO NOT attempt any repairs

yourself.

This symbol indicates that this is a Class II product and does not require

an earth connection.

WARNING! Read these electrical safety instructions thoroughly

before connecting the product to the mains supply.

WARNING! The wires in the power cable of this product are

coloured in accordance with the following code:

Blue = Neutral Brown = Live

Plug must be BS1363/A approved.

Always fit a 13 Amp fuse.

Ensure that the outer sheath of the cable is firmly held by the clamp

Neutral

(Blue)

Live

(Brown)

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ASSEMBLY INSTRUCTIONS

The worklight is supplied within a carry

frame, which is assembled as follows:

Remove the locking screw from the

base of the carry frame, then insert

the tubular base into the frame

attachment, as shown.

Line up the holes in the two sections of

the frame then replace and tighten

the fixing screw.

Use the fixing screw to adjust the

angle of the worklight as required.

PARTS REPLACEMENT

Clean the lens at regular intervals using a non-abrasive glass cleaner.

Immediately replace a cracked or broken protective glass. Always use original

parts for this which can be purchased from your Clarke Spares Department.

There are no other user serviceable parts inside the light. DO NOT disassemble

the unit.

When re-assembling the lens assembly, ensuring the screws line up with the

screw holes in the back of the lens, and gently tighten all screws. DO NOT

force or overtighten. If the screws do not go back easily, remove and recheck

the alignment.

ENVIRONMENTAL RECYCLING POLICY

Through purchase of this product, the customer is taking on the

obligation to deal with the WEEE in accordance with the WEEE

regulations in relation to the treatment, recycling & recovery and

environmentally sound disposal of the WEEE.

In effect, this means that this product must not be disposed of with general

household waste. It must be disposed of according to the laws governing

Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal

facility.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DECLARATION OF CONFORMITY

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

NOTES

_____________________________________________________________________________

Tabla de contenidos

Otros manuales de Luz de trabajo de Clarke

Clarke

Clarke CTL24/3 Manual de usuario

Clarke

Clarke RWL30 Manual de usuario

Clarke

Clarke COB10CR Manual de usuario

Clarke

Clarke MFL800R Manual de usuario

Clarke

Clarke LED1000R Manual de usuario

Clarke

Clarke HLC400T Manual del propietario

Clarke

Clarke CFL20Li Manual de instrucciones

Clarke

Clarke HLC400T/110 Manual del propietario

Clarke

Clarke SMD42C Manual del propietario

Clarke

Clarke COB10T Manual del propietario

Clarke

Clarke SMD84T/110 Manual del propietario

Clarke

Clarke SMD42T Manual del propietario

Clarke

Clarke UBL1600R Manual de usuario

Clarke

Clarke CWLCOB3 Manual de usuario

Clarke

Clarke GWL700R Manual de usuario

Clarke

Clarke COB10C Manual del propietario

Clarke

Clarke SMD2700L Manual de usuario

Clarke

Clarke SMD42T/110 Manual del propietario

Clarke

Clarke RWL36LI Manual de usuario

Clarke

Clarke HLC400 Manual del propietario

Clarke

Clarke COB10C/110 Manual del propietario

Clarke

Clarke HLC400/110 Manual del propietario

Clarke

Clarke LED700SR Manual de usuario

Clarke

Clarke SMD84T Manual del propietario

Manuales populares de Luz de trabajo de otras marcas

ANSMANN

ANSMANN POWERLIGHT 5.1 Manual de usuario

RTRMAX

RTRMAX RTX1868 Manual de usuario

FeinTech

FeinTech LAL00220 Manual de usuario

Bunker Hill Security

Bunker Hill Security 64735 Manual de usuario

Goobay

Goobay 30450 Manual de usuario

REV Ritter

REV Ritter SPOT Manual de usuario

Ignition

Ignition Stagepix Line 100 IP Manual de usuario

SCANGRIP

SCANGRIP DUO CONNECT Manual de usuario

Bosch

Bosch GLI 18 V Manual de usuario

Bayco

Bayco SL-1514 Manual de usuario

EUFAB

EUFAB SMD LED 8+1 Manual de usuario

DeWalt

DeWalt DCL510 Manual de usuario

PowerSmith

PowerSmith PWLD080T Manual de usuario

MaxLite

MaxLite 73683 Manual de usuario

Heitronic

Heitronic Trend 27867 Manual de usuario

Monzana

Monzana Gore MZCL10 Manual de usuario

EINHELL

EINHELL TE-CL 18/2000 LiAC Manual de usuario

Bayco

Bayco NIGHTSTICK Dual-Light Xtreme Lumens... Manual de usuario