Page 6
To change a watering program currently in use, enter the new LINE and FREQUENCY settings as desired.
The change will be rendered eective by the timer when appropriate.
Examples: - with watering in progress and line 2 active, the position of the LINE selectors is changed (say, from 10 min to 20 min): here will be no
change to the duration of the watering step already in progress on line 2, whereas the new setting of 20 minutes will take eect with the activa-
tion of line 3.
- changing the position of the FREQUENCY selector (say, from 8 to 12 hours): the new setting will take eect within 24 hours subsequent to the
change being made; thereafter, the watering cycles will be repeated at the new frequency selected, whilst the START time remains unchanged.
For Multipla 9V LCD (p/n): 8060
Multipla 9V LCD
Multipla 9V LCD
Example of programming: at 16:30, the duration is selected for all of the watering lines (LINE selectors) and the
frequency is set at 8h (FREQUENCY selector). Suppose that watering is not to start immediately, but at 22:30 (i.e.
after 6 hours): press the START+… button once, and then six times in succession, so that the display shows 6:00. The
time indicated in the display begins counting down, ultimately reaching 0:00 at 22:30; the watering cycle starts, and
will then be repeated every 8 hours as set with the FREQUENCY selector (i.e. at 22.30, at 06:30 and at 14:30).
For Multipla 9V LCD (p/n): 8060
16:30
User manual
User manual
1
12
23
3
LINE
MIN
from 10 min to 20 min
LINE
MIN
LINE
MIN
