
MIRAGESCALATOR
Prima di tutto è necessario
aspirare la polvere dai canali
della scala. Per effettuare questa
operazione occorre seguire le
seguenti indicazioni. Inserire un
sacchetto filtro di carta nel
contenitore (fig.1), chiudere il
contenitore (fig.2). Introdurre il
tubo flessibile (A) nel
bocchettone (1). Introdurre, poi, il
tubo flessibile (B) nel
bocchettone (2). In questa
condizione tutta la polvere
aspirata verrà trattenuta nel
sacco filtro. Quando questo sarà
pieno, andrà sostituito con un
nuovo sacchetto.
Per velocizzare l’operazione di
pulizia a secco oppure
successivamente quella di
lavaggio, è possibile collegare un
aspiratore di grande potenza. In
questo caso collegare all’interno
della macchina il tubo flessibile
(C) al bocchettone (2) (vedi
legenda) ed inserire la spina
nella presa di corrente (fig.3).
Si raccomanda di procedere con
la pulizia a secco da ambo i lati
della scala fino a quando si è
sicuri che nei canali non vi sia
più polvere.
A fine operazione collegare
l’accessorio manuale al
bocchettone (4) ed il tubo flex (A)
al raccordo (4) ed aspirare tutti i
residui rimasti vedi (fig.4). Una
pulizia a fondo richiederà
l’impiego di più sacchetti filtro
prima di procedere al lavaggio.
Per questa operazione si
consiglia di usare le spazzole in
tynex.
Per la fase successiva del
lavaggio, invece, è opportuno
usare spazzole in nylon 0,25.
Entrambi i tipi sono in dotazione.
MIRAGESCALATOR
First of all it is necessary to
suck up all the dust from the
grooves of escalator. To make
this procedure you have to
follow the above listed
directions. Put a paper filter
bag into the container (fig.1),
close the container (fig.2).
Insert the flexible pipe (A) into
the pipe union (1). Afterwards
insert the flexible pipe (B) into
the pipe union (2). So all the
sucked up dust will be
collected into the paper filter
bag. When it will be full, you
will have to replace it with a
new one.
In order to speed up the dry
cleaning, and afterwards, the
water cleaning, it is possible
to connect a powerful vacuum
cleaner. In this case connect
the flexible pipe (C), situated
inside the machine, at the
pipe union (2) (see “Legenda”)
and insert the plug into the
socket (fig.3).
We remind you to proceed
with the dry cleaning on both
sides of escalator till you’ll be
sure that the dust has been
totally collected from the
grooves.
At the end of this procedure,
connect the manual accessory
to the pipe union (4) and the
flexible pipe (A) at the
connector (4). For a deep
cleaning it is possible the
consumption of several paper
filter bags before the water
cleaning. To effect this last
procedure, we advise you to
use tynex brushes.
For the following washing
procedure, it’s suitable the use
of nylon 0,25 brushes. Both
fig.1
fig.2
fig.3
fig.4
A
C
2
43
1
C
LEGENDA
B
3