Chroma 19572 Manual de usuario

Ground Bond Tester

19572

User’s Manual

Version 2.0

April 2017

Legal Notices

The information in this document is subject to change without notice.

Chroma ATE INC. makes no warranty of any kind with regard to this manual, including, but not

limited to, the implied warranties of merchantability and fitness for a particular purpose.

Chroma ATE INC. shall not be held liable for errors contained herein or direct, indirect, special,

incidental or consequential damages in connection with the furnishing, performance, or use of

this material.

CHROMA ATE INC.

66 Huaya 1st Road, Guishan, Taoyuan 33383, Taiwan

adaptation, or translation of this document without prior written permission is prohibited,

except as allowed under the copyright laws.

iii

Warranty

All of Chroma’s instruments are warranted against defects in material and workmanship for a

period of one year from date of shipment. Chroma agrees to repair or replace any assembly

or component found to be defective, under normal use during this period. Chroma’s obligation

under this warranty is limited solely to repairing any such instrument, which in Chroma’s sole

opinion proves to be defective within the scope of the warranty when returned to the factory or

to an authorized service center. Purchaser is responsible for the shipping and cost of the

service item to Chroma factory or service center. Shipment should not be made without prior

authorization by Chroma.

This warranty does not apply to any products repaired or altered by persons not authorized by

Chroma, or not in accordance with instructions furnished by Chroma. If the instrument is

defective as a result of misuse, improper repair, or abnormal conditions or operations, repairs

will be billed at cost.

Chroma assumes no responsibility for its product being used in a hazardous or dangerous

manner either alone or in conjunction with other equipment. High voltage used in some

instruments may be dangerous if misused. Special disclaimers apply to these instruments.

Chroma assumes no liability for secondary charges or consequential damages and in any

event, Chroma's liability for breach of warranty under any contract or otherwise, shall not

exceed the purchase price of the specific instrument shipped and against which a claim is

made.

Any recommendations made by Chroma for use of its products are based upon tests believed

to be reliable, but Chroma makes no warranty of the results to be obtained. This warranty is in

lieu of all other warranties, expressed or implied, and no representative or person is

authorized to represent or assume for Chroma any liability in connection with the sale of our

products other than set forth herein.

CHROMA ATE INC.

66 Huaya 1st Road, Guishan,

Taoyuan 33383, Taiwan

Tel: 886-3-327-9999

Fax: 886-3-327-2886

e-mail: [email protected]

http://www.chromaate.com

Material Contents Declaration

The recycling label shown on the product indicates the Hazardous Substances contained in

the product as the table listed below.

: See <Table 1>.

: See <Table 2>.

Part Name

Hazardous Substances

Lead

Mercury

Cadmium

Hexavalent

Chromium

Polybrominated

Biphenyls/

Polybromodiphenyl

Ethers

Selected Phthalates

Group

Cr6+

PBB/PBDE

DEHP/BBP/DBP/DIBP

PCBA O O O O O O

CHASSIS O O O O O O

ACCESSORY O O O O O O

PACKAGE O O O O O O

“O” indicates that the level of the specified chemical substance is less than the threshold level

specified in the standards of SJ/T

-11363-2006 and EU Directive 2011/65/EU.

“

” indicates that the level of the specified chemical substance exceeds the threshold level

specified in the standards of SJ/T

-11363-2006 and EU Directive 2011/65/EU.

Remarks:

The CE marking on product is a declaration of product compliance with EU

Directive 2011/65/EU.

Disposal

Do not dispose of electrical appliances as unsorted municipal waste, use separate collection

facilities. Contact your local government for information regarding the collection systems

available. If electrical appliances are disposed of in landfills or dumps, hazardous substances

can leak into the groundwater and get into the food chain, damaging your health and

well-being. When replacing old appliances with new one, the retailer is legally obligated to

take back your old appliances for disposal at least for free of charge.

Part Name

Hazardous Substances

Lead

Mercury

Cadmium

Hexavalent

Chromium

Polybrominated

Biphenyls/

Polybromodiphenyl

Ethers

Selected Phthalates

Group

Cr6+

PBB/PBDE

DEHP/BBP/DBP/DIBP

PCBA O O O O O

CHASSIS O O O O O

ACCESSORY O O O O O

PACKAGE O O O O O O

“O” indicates that the level of the specified chemical substance is less than the threshold level

specified in the standards of

SJ/T-11363-2006 and EU Directive 2011/65/EU..

“

” indicates that the level of the specified chemical substance exceeds the threshold level

specified in the standards of SJ/T

-11363-2006 and EU Directive 2011/65/EU..

Chroma is not fully transitioned to lead-free solder assembly at this moment; however,

most of the components used are RoHS compliant.

The environment-friendly usage period of the product is assumed under the operating

environment specified in each product’s specification.

Disposal

Do not dispose of electrical appliances as unsorted municipal waste, use separate collection

facilities. Contact your local government for information regarding the collection systems

available. If electrical appliances are disposed of in landfills or dumps, hazardous substances

can leak into the groundwater and get into the food chain, damaging your health and

well-being. When replacing old appliances with new one, the retailer is legally obligated to

take back your old appliances for disposal at least for free of charge.

vii

Safety Summary

The following general safety precautions must be observed during all phases of operation,

service, and repair of this instrument. Failure to comply with these precautions or specific

WARNINGS given elsewhere in this manual will violate safety standards of design,

manufacture, and intended use of the instrument. Chroma assumes no liability for the

customer’s failure to comply with these requirements.

BEFORE APPLYING POWER

Verify that the power is set to match the rated input of this power

supply.

PROTECTIVE GROUNDING

Make sure to connect the protective grounding to prevent an

electric shock before turning on the power.

NECESSITY OF PROTECTIVE GROUNDING

Never cut off the internal or external protective grounding wire, or

disconnect the wiring of protective grounding terminal. Doing so

will cause a potential shock hazard that may bring injury to a

person.

FUSES

Only fuses with the required rated current, voltage, and specified

type (normal blow, time delay, etc.) should be used. Do not use

repaired fuses or short-circuited fuse holders. To do so could

cause a shock or fire hazard.

DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE

Do not operate the instrument in the presence of flammable

gases or fumes. The instrument should be used in an

environment of good ventilation.

DO NOT REMOVE THE COVER OF THE INSTRUMENT

Operating personnel must not remove the cover of the instrument.

Component replacement and internal adjustment can be done

only by qualified service personnel.

viii

Safety Symbols

DANGER – High voltage.

Explanation: To avoid injury, death of personnel, or damage to

the instrument, the operator must refer to the explanation in the

instruction manual.

High temperature: This symbol indicates the temperature is

hazardous to human beings

. Do not touch it to avoid any personal

injury.

Protective grounding terminal: This symbol indicates that the

terminal must be connected to ground before operation of the

equipment to protect against electrical shock in case of a fault.

Functional grounding: To identify an earth (ground) terminal in

cases where the protective ground is not explicitly stated. This

symbol indicates the power connector does not provide

grounding.

Frame or chassis: To identify a frame or chassis terminal.

Alternating Current (AC)

Direct Current (DC) / Alternating Current (AC)

Direct Current (DC)

Push-on/Push-off power switch

The WARNING sign highlights an essential operating or

maintenance procedure, practice, condition, statement, etc.,

which if not strictly observed, could result in injury to, or death of,

personnel or long term health hazards.

The CAUTION sign highlights an essential operating or

maintenance procedure, practice, condition, statement, etc.,

which if not strictly observed, could result in damage to, or

destruction of, equipment.

The Notice sign highlights an essential operating or maintenance

procedure, condition, or statement.

WARNING

CAUTION

Tabla de contenidos

Otros manuales de Equipo de prueba de Chroma

Chroma

Chroma 3300 Manual de usuario

Chroma

Chroma 63800 Series Manual del propietario

Chroma

Chroma 19020 Manual de usuario

Chroma

Chroma 11210 Manual de usuario

Chroma

Chroma 63200 Series Manual del propietario

Chroma

Chroma 19501 Series Manual de usuario

Chroma

Chroma 69225 Series Manual de usuario

Chroma

Chroma A195001 Manual de usuario

Chroma

Chroma 63200A Series Manual del propietario

Chroma

Chroma 63200 Series Manual de usuario

Chroma

Chroma A190519 Manual de usuario

Chroma

Chroma 19020 Manual de usuario

Chroma

Chroma 63200 Series Manual de usuario

Chroma

Chroma 19071 Manual de usuario

Chroma

Chroma 19071 Manual de usuario

Chroma

Chroma 19501-K Manual de usuario

Manuales populares de Equipo de prueba de otras marcas

SMART

SMART KANAAD SBT XTREME 3G Series Manual de usuario

Agilent Technologies

Agilent Technologies BERT Serial Manual de usuario

Agilent Technologies

Agilent Technologies N3280A Manual de usuario

Vernier

Vernier Go Direct Voltage Manual de usuario

Lifeloc

Lifeloc R.A.D.A.R. Manual de usuario

Fluke

Fluke T5-600 Instrucciones de funcionamiento e instalación

Mercury

Mercury TSL01 Manual de usuario

MAHA

MAHA MBT Series Manual de usuario

Fuji Electric

Fuji Electric P-61 Manual de usuario

ETC

ETC SealerAtor Manual de usuario

Skyfine

Skyfine ETHYWAY V2 Manual de usuario

Appion

Appion G5 Twin Manual de usuario

PCB Piezotronics

PCB Piezotronics 8159-0112A Manual de usuario

BW Technologies

BW Technologies MicroDock II Manual de usuario

Sun Nuclear

Sun Nuclear 1027 Manual de usuario

Biomark

Biomark HPR LITE READER Manual de usuario

Hioki

Hioki 3169-20 Manual de usuario

Ashcroft

Ashcroft ATE-100 Manual de usuario