Chroma PS08 Manual de usuario

Chroma-Q™

PS08

User Manual

Version 1.3 December 2006

PN: 139-0025

PS08 User Manual 1 V1.3 December 2006

Disclaimer

The information contained herein is offered in good faith and is believed to be accurate.

However, because conditions and methods of use of our products are beyond our control, this

information should not be used in substitution for customer's tests to ensure that Chroma-Q

products are safe, effective, and fully satisfactory for the intended end use. Suggestions of use

shall not be taken as inducements to infringe any patent. Chroma-Q sole warranty is that the

product will meet the sales specifications in effect at the time of shipment. Your exclusive

remedy for breach of such warranty is limited to refund of purchase price or replacement of any

product shown to be other than as warranted.

Chroma-Q reserves the right to change or make alteration to devices and their functionality

without notice due to our on going research and development.

The Chroma-Q PS08 has been designed specifically for the professional entertainment lighting

industry. Regular maintenance should be performed to ensure that the products perform well in

the entertainment environment.

If you experience any difficulties with any Chroma-Q products please contact your selling

dealer. If your selling dealer is unable to help please contact support@chroma-q.com. If the

selling dealer is unable to satisfy your servicing needs, please contact the following, for full

factory service:

Outside North America: North America:

Tel: +44 (0)1494 446000 Tel: 416-255-9494

Fax: +44 (0)1494 461024 Fax: 416-255-3514

[email protected] supp[email protected]

For further information please visit the Chroma-Q website at www.chroma-q.com.

Chroma-Q is a trademark, for more information on this visit www.chroma-q.com/trademarks.

The rights and ownership of all trademarks are recognised.

Approvals

PS08 User Manual 2 V1.3 December 2006

Table of Contents

1. Product Overview ……………………..………………………….………................ 3

2. Operation……………...…………………………………………………….…………. 3

Power

Data

Termination

Indicators

System Diagram

Load

Power Units

Installation

Compatibility

Control and Power Cables

PS08 User Manual 3 V1.3 December 2006

1. Product overview

The Chroma-Q PS08 supplies power and data to the Chroma-Q range of colour changers and

compatible products (see below). A maximum capacity of 8PU (Power Units), it can be

controlled remotely via ANSI E1.1 USITT DMX 512-A and delivers power and data via 2 XLR-4

outputs.

2. Operation

Power

Connect power through a fused male IEC chassis connector with input power of 100-240V, 50-

60 Hz. The standard fuse is a 5x20mm 3A GMA. It provides 2 circuits of combined 24VDC.

Data

Data input ANSI E1.1 USITT DMX 512-A from an external source or lighting control console

connects through a male XLR-5. A pass through connection is available on the female XLR-5.

Connect power and data from the female XLR-4 outputs of the PS08 to the colour changer

units.

Termination

Data termination is built in at the input.

Indicators

The red LED indicates mains power is present and the green LED indicates a DMX signal is

present.

System Diagram

The PS-08 has been designed for cable loops of up to 60m/200ft per output. Closing the loop

with a return cable will enhance the stability of the power delivered and connected to your data

line.

Load

To simplify the choice of power supply we use the "PU" (Power Unit) to calculate the load

requirements of the Chroma-Q system. The PS08 will supply up to 8 PU's, so you can plug-in 8

Chroma-Q Plus (8 x 1PU = 8PU).

Power Units

Chroma-Q Product Power Unit

Plus 1 PU

Broadway 1 PU

Cascade 1.5 PU

Universal 1.5 PU

M5 1.5 PU

M8 1.5 PU

Moving Mirror 1 PU

DMX Gobo Rotator 0.6 PU

PS08 User Manual 4 V1.3 December 2006

Installation

The Chroma-Q PS08 is designed to be screwed on to set or hung from truss. The L-shaped

bracket has multiple fixing slots to accept standard hook clamps or half couplers. Ensure

adequate ventilation around the holes on the enclosures. Inadequate ventilation may result to

premature failure of the unit.

Compatibility

The Chroma-Q PS08 is compatible with all Chroma-Q Colour Changers - Chroma-Q Plus,

Original, Broadway, Universal, Cascade, M5, M8, Moving Mirror, Twin Gobo Rotator, Twin

Effects Gobo Rotator, Twin DMX Gobo Rotator.

Control and Power Cables

The Chroma-Q utilises an XLR-4 pin cable system. This is used to supply power and data

transfer. Pins 1 and 4 supply 24VDC power and pins 2 and 3 supply ANSI E1.11 USITT

DMX512-A control protocol with a ground drain wire to the connector shell.

Only genuine Tourflex Datasafe Cable is recommended for use of the Chroma-Q colour

changing system.

Damage will occur if the power connections short circuit to the data or ground/shield

connections. When assembling XLR4-pin cables, heat shrink sleeves should be used on each

individual data pin and the drain wire to prevent short circuits.

The XLR-4 cable is wired pin to pin, in the following format:

Pin # Function

1 0V DC

2 Control data minus

3 Control data plus

4 +24V DC

Chassis Ground bonding

The XLR-5 cable is wired pin to pin, in the following format:

Pin # Function

1 Ground (screen)

2 Data minus

3 Data plus

4 Spare data minus

5 Spare data plus

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Fuente de alimentación de Chroma

Chroma

Chroma 62000L Series Manual de usuario

Chroma

Chroma Color Block PSU30 Manual de usuario

Chroma

Chroma 6330 Series Manual de usuario

Chroma

Chroma PS02 Manual de usuario

Chroma

Chroma Color Block PSU30 Manual de usuario

Chroma

Chroma Color Force Compact PSU15 Manual de usuario

Chroma

Chroma 8000 Manual de usuario

Chroma

Chroma Magic Box PS12 Manual de usuario

Chroma

Chroma 62000B Series Manual de usuario

Chroma

Chroma 63610-80-20 Manual del propietario

Chroma

Chroma 62000H Series Manual del propietario

Chroma

Chroma 62000H Series Manual del propietario

Chroma

Chroma 61601 Manual de usuario

Chroma

Chroma PS08 Manual de usuario

Chroma

Chroma Color Block PSU30 Manual de usuario

Chroma

Chroma 61601 Manual de usuario

Chroma

Chroma 62020H-150S Manual del propietario

Chroma

Chroma Color Block PSU-05B Manual de usuario

Chroma

Chroma 63200 Series Manual del propietario

Chroma

Chroma 62000D Series Manual del propietario

Chroma

Chroma 62000P Series Manual del propietario

Manuales populares de Fuente de alimentación de otras marcas

Monacor

Monacor PS-12CCD Manual de usuario

VOLTIMA

VOLTIMA MagicBox 15 Manual de usuario

Agilent Technologies

Agilent Technologies 6032A Manual de usuario

Miller

Miller Auto Deltaweld 452 Manual de usuario

BCP

BCP PUOUBK Hoja de instrucciones

HC 2210 Manual de usuario

Puls

Puls CT5.241 Manual de usuario

OCZ

OCZ ZX1250W Manual de usuario

iseg

iseg ECH 238 Manual de usuario

Power

Power XXL A Series Manual de usuario

Agilent Technologies

Agilent Technologies 6631B Manual de usuario

Renogy

Renogy PHOENIX 300 Manual de usuario

HP 6200B Manual de servicio

Epson

Epson Stylus Scan 2500 Manual de funcionamiento

Pulsar

Pulsar GREEN POWER CCTV PoE POE044816 Manual de usuario

Puls

Puls MiniLine ML50.100 Manual de usuario

Puls

Puls AS-Interface SLA4.100 Manual de usuario

Kenwood

Kenwood PS-60 Manual de usuario