chlorOrgano AL-790A Manual de usuario
Version 1.1 | June 2021
Instructions for Use
NaCl Acidulous Generator Model AL-790A
chlorOrgano
Functional Electrolyzed Water
2
Thank you for purchasing our product.
This instruction manual contains important information for using this device safely.
Read it carefully and use the product accordingly.
Read “Safety Precautions” (Pages 4 through 9) before using the device for a safe
operation. Keep this manual in a secure place and continue to refer to it for safe
operation and proper maintenance.
We are not responsible for product failure due to improper installation and/or use.
IMPORTANT – DO NOT DISCARD
3
Table of Contents
Safety Precautions ......................................................................................... 4
Main Features and Accessories ................................................................... 10
Control Panel Features ................................................................................ 12
Setting Panel ................................................................................................ 13
How to Install .............................................................................................. 14
How to Set for Operation ............................................................................ 15
How to Use .................................................................................................. 18
How to Replenish the Auxiliary Solution .................................................... 20
How to Measure the Chlorine Concentration .............................................. 22
How to Clean ............................................................................................... 23
How to Wall Mount ..................................................................................... 24
How to Troubleshoot ................................................................................... 26
Product Specifications ................................................................................. 28
Warranty Card ............................................................................................. 29
4
Safety Precautions (Please be sure to read this section.)
Explanation of Symbols
This instruction manual and the product labels explain how to handle and operate the
product safely in order to prevent harm to the operator and/or damage to property, using
several symbols as follows:
Symbols
Explanation
Not following the content of this label when operating the
device can lead to a possibility of imminent death or
serious injury.
WARNING
Not following the content of this label when operating the
device can lead to a possibility of death, serious injury
and/or damage to the device and property.
NOTE
Not following the content of this label when operating the
device can lead to a possibility of injury and/or damage to
the device and property.
This mark indicates "prohibited" action or use and can
be used in combination with another symbol.
This mark indicates “mandatory” action or use.
General Precautions
5
DO NOT attempt to modify, disassemble, or repair this device. Such actions
may cause fire or electric shock. Consult your dealer for repair.
DO NOT connect to a power source that is NOT 120 VAC; do not connect to
a DC power source. Do not connect to an overloaded socket; it will overheat
and may cause a fire.
DO NOT damage the power cord and plug; do not forcibly bend, pinch, or
kink the cord; do not stress the cord by putting weight on it or by pulling on
it to unplug from a power outlet. Use of damaged power cord or plug may
cause electric shot and/or fire.
DO NOT remove or insert the power plug with wet hands; it may cause an
electric shock.
Make sure the power plug is fully inserted into the outlet before turning on
the device; incomplete insertion may cause an electric shock or fire. Do not
use a damaged plug or insert into a loose power outlet.
If the device is accidentally dropped into water, unplug if from the power
outlet first and then touch the device; otherwise, it may cause an electric
shock. Consult your dealer for repair.
Remove dust, dirt, or other types of foreign material accumulated in the
power plug regularly; they can cause a fire. Unplug the power plug from the
outlet and wipe it down with a lint-free dry cloth.
If the device is accidentally dropped into water, unplug if from the power
outlet first before touching the device in the water; otherwise, it may cause an
electric shock. Consult your dealer for repair.
DO NOT drink the generated water of this device; ingestion of the generated
water may adversely affect the physical condition.
DO NOT mix the generated water of this device with medicines, pesticides,
detergents, etc. Toxic substances and gases may be generated, which can lead
to gas poisoning.
Precautions for Selecting a Location
6
Install in a well-ventilated place. Traces of gas may be generated during
production of the water.
WARNING
DO NOT install the device in the following areas as doing so may cause
damage to the device:
· Areas that are exposed to outdoor air, wind, or direct sunlight.
· Areas that are near the presence of explosive gas, flammable gas, or
corrosive gas
· Areas that are in direct line of warm or hot air exhaust from heating
appliances, cookware, and other equipment
· Areas that are damp and dusty
· Areas that are humid, such bathrooms and agricultural greenhouses
· Areas whose room temperature is higher than 104°F (40°C)
· Areas that are closed with poor ventilation.
· Areas that are likely to freeze
· Areas where water falls directly on the device.
· Areas where there is a high salt concentration in the air
Place the device on a level surface that is free from vibration and shock.
Ensure that the surface is fixed firmly in place so that it does not fall or tip
over; otherwise, injury and/or damage may result.
If necessary, secure the device on a wall using the wall hook set, sold
separately. Select a wall location with adequate strength to receive fasteners.
securely to hold up the device. Consult a local contractor if required.
DO NOT install the device upside down or sideways; doing so may cause
failure of the device.
Position the dispensing hose head in the sink, as residual generated water will
drip after use.
Precautions about the Water Supply
7
NOTE
Water Quality
Use only tap water conforming to the local water quality standards, suitable
for drinking, cooking, and the flushing of toilets. DO NOT use untreated
well water or industrial water.
Water Pressure
Use tap water with water pressure from 14.5 psi to 101.5 psi (0.1 ~ 0.7MPa).
DO NOT use well water or industrial water. If required to use tap water with
pressure greater than 101.5 psi, install an external pressure reducing valve.
Water Temperature
Use tap water with water temperature between 32°F and 95°F (0 °C to
35 °C). Freezing or hot water may cause deformation or breakage of resin
parts and result in a device failure.
Water Supply Hose or Pipe
A bend, kink, or any other defects in the water supply hose or pipe may cause
a water leak or malfunction; check the water supply hose before turning on
the tap.
Water Supply Control
The tap or faucet of tap water is the mechanism for controlling the water
supply into the device. DO NOT bend the dispensing hose or block the head
during water generation as doing so will cause back pressure, resulting in
leakage or device malfunction. Ensure to close the water tap after use.
In Case of Freeze Warning
and disconnect the device water supply hose from the tap; drain the water
inside from the water supply hose.
8
Use only the NaCl dedicated electrolyte auxiliary solution
DO NOT use any solution other than the NaCl dedicated electrolyte
auxiliary solution as an additive; not doing so can result in production of
toxic and harmful substances and toxic gases that can be life-threatening.
DO NOT mix
Dedicated electrolyte auxiliary solution is an acidic liquid containing NaCl
sodium chloride. Never mix it with any other aqueous solutions.
DO NOT drink
DO NOT drink dedicated electrolyte auxiliary solution. If accidentally
ingested, drink plenty of water.
9
Storage of Generated Water
NOTE
Storage of the generated water
When storing unused generated water in a container, keep the air in the
container to a minimum and keep the container in a cool and dark place.
In addition, it may deteriorate due to long-term storage and the desired
effect may not be obtained. Therefore, be sure to measure and confirm the
effective available free chlorine concentration before use.
10
Front
Back
A
K
I
H
G
J
F
C
E
D
B
Main Features and Accessories
A Electrolyte Solution Storage Tank Cover
B Digital Display
C Proximity Sensor
D Dispensing Hose
E Control Panel
F Power Switch
G Setting Panel Cover Door
H Dispensing Hose Head
I Water Inlet
J Electrical Plug (Three-pronged)
K Wall Hook Attachment Hole (3 Places)
Tabla de contenidos
