5
1. Keep the control unit away from drafty areas that may become damp or wet such as an
open window. The control unit should be placed on a dry, ventilated and firm floor, free
of surrounding fabric. Spacing of 1 foot should be left on all sides.
2. Never turn on the power before a good connection is made between the unit and the bed
pad to prevent loss of heat-conducting liquid inside the unit.
3. The control unit has not been filled with water before factory delivery; make sure to fill as
needed. If by mistake, substantial liquid is lost, please fill with water. [The fill hole is on the
right side of the unit.]
4. Avoid kinking the hose between the control unit and the bed pad.
5. Be careful with sharp objects on the bed pad as to not puncture the coils in the bed pad.
6. Children should be under adult supervision when using the ChiliPadTM.
7. The ChiliPadTM is to be used on alternating–current supply circuit of the proper voltage.
8. Turn off or unplug when not in use.
9. Excessive heating may result from folding bedding, other than a mattress, when in actual
use.
10. If improper operation of this bedding is observed, discontinue its use immediately and con-
sult the manufacturer or the dealer regarding its repair.
11. Wrapping of a cord around the controller may damage the cord. Loop loosely when
storing.
B: Before You Use
