Chetco Digital Instruments SeaSmart.Net Manual de usuario

SeaSmart.Net

™

Version 1.3.0 – Gateway Adapter

Chetco Digital Instruments

Preliminary Specification 041212

SeaSmart.Net™ is a trademark of Chetco Digital Instruments, Inc.

SeaGauge™ is a trademark of Chetco Digital Instruments, Inc.

vGauge™ is a trademark of Chetco Digital Instruments, Inc.

WARNING!

USE THIS UNIT ONLY AS AN AID TO MONITORING ENGINE

PERFORMANCE INFORMATION.

CAUTION

When showing sensor data, this unit will only show information based on the sender used

and its installed position.

The operating and storage temperature for your unit is from -4 degrees to+167 degrees

Fahrenheit (-20 to +75 degrees Celsius). Extended storage temperatures higher or lower than

specified will cause the liquid crystal display to fail. Neither this type of failure nor its

consequences are covered by the warranty. For more information, consult the factory

customer service department.

All features and specifications subject to change without notice.

Chetco Digital Instruments may find it necessary to change or end our policies, regulations,

and special offers at any time. We reserve the right to do so without notice.

All screens in this manual are simulated.

NOTICE!

Free software upgrades will be available on our website at http:// www.chetcodigital.com as

they are released. Please check our website periodically for these and other information as

they become available.

Thank you for choosing Chetco Digital Instruments

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the factory customer service department for help.

SPECIFICATIONS

...................................................................

NMEA 2000 Instrumentation Sentences Supported

126992 – System Time

127250 – Vessel Heading

127257 – Vessel Attitude

127251 – Rate of Turn

127488 – Engine Data - Rapid Update

127489 – Engine Data - Dynamic Update

127493 – Transmission Data - Dynamic Update

127497 – Trip Parameters - Dynamic Update

127505 – Fluid Data - Dynamic Update

127508 – Battery Status - Dynamic Update

127506 – DC Status - Detail

127513 – DC Config Detail

127501 – Binary Switch Status - Dynamic Update

130306 – Wind Data

130311 – Environmental Data

130312 – Temperature Data

129025 – Position Data - Rapid

130323 – Weather Station Location Data

129026 – SOG and COG Rapid Update

Table of Contents

Table of Contents ................................................................................................................................5



Introduction..........................................................................................................................................7



Welcome ...........................................................................................................................................7



Connections ...................................................................................................................................10



Web Brower Interface ..................................................................................................................11



Instrument Link Bar .................................................................................................................13



Data Logging Tool Bar ............................................................................................................13



Themes Toolbar........................................................................................................................14



Instance Tool Bar......................................................................................................................14



SeaSmart.Net Configuration.............................................................................................................16



SeaSmart Web................................................................................................................................19



File Upload.....................................................................................................................................20



Network Setup...............................................................................................................................20



Firmware Update System .............................................................................................................21



Port Mode.......................................................................................................................................23



ACCEPT MODE .....................................................................................................................23



CONNECT MODE ................................................................................................................25



PACKING MODE..................................................................................................................26



WLAN Profiles..............................................................................................................................28



FTP File Update ............................................................................................................................31



FTP Firmware Update..................................................................................................................37



XML Config...................................................................................................................................42



Quick Syntax Tour for XCRs..................................................................................................42



Record, Group, Item, and Value Tags...................................................................................43



Importing and Exporting an XML Configuration File .......................................................45



NSTALL OF

MART

XML FILE

...............................................................................46



SeaSmart XML ..........................................................................................................................48



Full Config......................................................................................................................................52



Connections........................................................................................................................................53



Power ..............................................................................................................................................53



NMEA 2000...................................................................................................................................53



Serial/USB......................................................................................................................................53



Ethernet ..........................................................................................................................................53



Dimensions .........................................................................................................................................55



One Year Warranty............................................................................................................................57



SeaSmart.Net SOFTWARE LICENSE AGREEMENT............................................................58



SeaSmart.Net Adapter Manual Version1.3

Introduction

Welcome

Thank you for purchasing a Chetco Digital Instruments SeaSmart.Net product.

SeaSmart.Net Gateway adapters bridge Serial communications between dissimilar networks such as

Ethernet,WiFi, NMEA 0183, and NMEA 2000. SeaSmart.Net gateways contain both hardware interfaces

and protocol translators to provide bi-directional communications between networks.

SeaSmart.Net adapters are available for -

NMEA 0183 to Ethernet 10/100 with Embedded Web Server

NMEA 0183 to WiFi 802.11 b/g with Embedded Web Server

NMEA 2000 to Ethernet 10/100 with Embedded Web Server

NMEA 2000 to WiFi 802.11 b/g with Embedded Web Sever

NMEA 2000 to USB/RS232 with external Web Server

Models with Embedded Web Servers allow direct viewing of translated data via standard Web Browser

devices as well as bridging between target TCP/UDP networks.

Web Browser enabled device PC based App using TCP/UDP connections

SeaSmart.Net Adapter Manual Version1.3

SeaSmart.Net WiFi adapter

Translates NMEA 2000 data to serial data and then

to 802.11 b/g WiFi.

SeaSmart.Net Protocol translator passes data to

embedded Web Server which is accessed over WiFI

Ad Hoc and Infrastructure networks using Web

Browser compatible devices

Optional pass-through allows direct access to NMEA

data for display on vDash PC Instrumentation S/W

over WiFi

SeaSmart.Net Ethernet adapter

Translates NMEA 2000 data to serial data and then

to 10/100 Ethernet (RJ45).

SeaSmart.Net Protocol translator passes data to

embedded Web Server which is accessed over

Ethernet Infrastructure networks using Web Browser

compatible devices

Optional pass-through allows direct access to NMEA

data for display on vDash PC Instrumentation S/W

via Ethernet.

SeaSmart.Net Serial adapter

Translates NMEA 2000 data to serial data via

RS232 and USB interfaces.

SeaSmart.Net Protocol translator converts RAW

NMEA 2000 to NMEA 0183 $IIXDR sentences

compatible with SeaGauge Color Displays and PC.

Optional pass-through allows direct access to NMEA

data for display on vDash PC Instrumentation S/W

using USB port.

SeaSmart.Net Adapter Manual Version1.3

The protocol translation is based on embedded microprocessor and can thus be easily updated in the field

via USB connection to any PC. The USB port provides power from the PC so no external power is required

when connected to a PC for programming.

The embedded Web Server contains a simple file system that allows Web content to be updated over the

connected network. The Web Server supports Dynamic HTML, JAVA Script, CGI, and AJAX protocols

and contains CGI scripts for bridging serial communications directly to hosted Web Pages.

SeaSmart.Net adapters are typically deployed where it is desired to bridge between NMEA 0183/NMEA

2000 networks and Ethernet/WiFi networks. Here, NMEA data is translated and passed on to both the

target network and embedded Web Server. Listeners on the Ethernet/WiFi networks can use both TCP and

UDP protocols to access the data. SeaSmart.Net adapters are configured to pass only selected data through

the gateway to reduce unnecessary traffic. Typically this configuration is only done on installation but can be

modified at anytime via connection to PC USB port.

SeaSmart.Net adapters can provide either a wired Ethernet or wireless WiFi connection to a local router

(Infrastructure Network). The router then interfaces to other devices on the network via additional wired or

wireless interfaces. It is possible and often practical, to use the WiFi features of a local router to service

other wireless clients.

SeaSmart.Net adapters with WiFi can also provide direct (point to point) connections with other Wireless

devices by using a Ad Hoc network which does not require a local router.

SeaSmart.Net Adapter Manual Version1.3

Connections

Installation of SeaSmart.Net adapters typically requires connecting the appropriate interface cables to each

network. Power is supplied from the NMEA 2000 network and is electrically isolated. When powering

from the NMEA 2000 network, Care must be taken to ensure not to exceed maximum current load of all

devices. Max load for SeaMart.Net adapters is 6 LEN

Two connectors on the input side provide the interface to the source networks (USB/Serial and/or NMEA

2000) The USB/Serial connector is a dual interface with only one active at a time (USB or RS232). The

appropriate USB or Serial interface cable must be used. The NMEA 2000 connector requires a supplied

Micro C adapter cable to connect to a NMEA 2000 bus “T” connector. SeaSmart.Net uses Opto-isolators

and thus is power and ground isolated from the NMEA 2000 network. SeaSmart.Net adapters only draw 1-6

LEN when powered via external source. When using SeaSmart.Net as a NMEA 2000 Gateway, the

USB/Serial interface is used off-line for configuration and firmware updates or as a second data port

accessible via the network.

For Ethernet devices the default configuration is to allow an External DHCP server to assign a network

address to the device. Access to the NMEA data is then done with TCP connection to the address or via

Web Browser to the same IP Address using Port 80. The Ethernet interface uses a supplied custom RJ45

cable with water-resist locking connector. The opposite RJ45 plug can be directly attached to any network

device or router. The Ethernet cable is a “straight-through” type.

Tabla de contenidos

Manuales populares de Adaptador de otras marcas

PCB Piezotronics

PCB Piezotronics 090B274 Manual de usuario

Auvidea

Auvidea J20 Manual del producto

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manual de usuario

Akribis

Akribis ITF-21-BISS-MIT Manual de usuario

Tenda

Tenda W54U Manual de usuario

ROHO

ROHO AGILITY Manual de usuario

PROLiNK

PROLiNK WN2001 Manual de usuario

Hawking

Hawking HUF2 Manual de usuario

Airlink101

Airlink101 AWLC4030 Manual de usuario

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manual de usuario

Philips

Philips SWA4554S/10 Manual de usuario

JVC

JVC TS-C9D2B Manual de instrucciones

NETGEAR

NETGEAR A6100 Manual de usuario

D-Link

D-Link DWA-121 Manual de usuario

Philips

Philips SWA2037 Manual de usuario

Basalte

Basalte 0610-20 Manual de usuario

Yealink

Yealink EHS40 Manual de usuario

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manual de usuario