Checkpoint 15000 Manual de usuario
Classification [Protected]
© 2020 Check Point Software Technologies Ltd. All rights reserved.
For a list of our trademarks, please refer to: www.checkpoint.com/copyright.html.
For a list of our Third Party Copyright notices, please refer to: www.checkpoint.com/3rd_party_copyright.html
15000 and 23000 Appliances
Replacing Power Supply Units
Protected
2020
Check Point 15000 and 23000 appliances have a redundant power supply unit
(PSU). 15000 and 23000 appliances support AC and DC PSUs.
If necessary, you can replace a PSU. Note that both PSUs on an appliance must
be of the same type (both AC or both DC). Mixing AC and DC PSUs is not
supported and can cause damage to the appliance.
Important - Make sure you are electromagnetically grounded before
you install, uninstall, or replace a PSU. ESD (electrostatic discharge)
can damage the appliance.
2
15000 and 23000 Appliances Rear Panel with AC PSUs
15000 and 23000 Appliances Rear Panel with DC PSUs
Item
Description
1 AC/DC Power supply units. The top PSU is identified as number 1
and the bottom PSU is identified as number 2.
2 Extractor handle.
3 Release lever.
4 Alarm off button for power supply units.
5 ESD grounding point.
3
Removing a Power Supply Unit
Before you remove a power supply unit, we recommend that you make sure that
either:
•A second power supply of the same type (AC or DC) is installed and
connected to a working power source
Or
•Shutdown the appliance
To remove a power supply unit:
1. Remove the power cord from the power supply unit.
2. If the alarm sounds, press the alarm off button to the right of the power
supply units.
The alarm stops.
3. Press and hold the release lever down as shown.
The illustration shows AC PSUs, but the same procedure applies to
appliances with DC PSUs.
4. While holding the release lever, pull the extraction handle to remove the
power supply unit.
Note - Remove the power supply unit only with the extraction handle
to prevent any possible damage.
4
Installing a Power Supply Unit
To install a replacement power supply unit:
1. Insert the power supply unit into the power supply slot.
2. Push the power supply unit in until the release lever clicks.
The illustration shows AC PSUs, but the same procedure applies to
appliances with DC PSUs.
3. Insert the power cord into the power supply socket.
4. For DC PSUs - Tighten the screws attached to the connector to make sure
the connector is fastened to the power supply.
5. Make sure that the power LED is illuminated.
Otros manuales para 15000
2
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Fuente de alimentación de Checkpoint
Checkpoint
Checkpoint 4800 Manual de usuario
Checkpoint
Checkpoint Smart-1 series Manual de instrucciones
Checkpoint
Checkpoint Smart-1 series Manual de instrucciones
Checkpoint
Checkpoint QUANTUM SMART-1 6000-L Manual de usuario
Checkpoint
Checkpoint Quantum LightSpeed Appliance QLS250 Manual de usuario
Checkpoint
Checkpoint TE250X Manual de usuario
Checkpoint
Checkpoint TCPP9000 Manual de usuario
Checkpoint
Checkpoint QUANTUM SMART-1 Manual de usuario
Checkpoint
Checkpoint Smart-1 series Manual de usuario
Checkpoint
Checkpoint Quantum 6000 Manual de usuario
